Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 326
Search took 0.02 seconds.
Search: Posts Made By: Vics Stuff
Forum: Early V8 (1932-53) 03-26-2021, 11:08 AM
Replies: 5
Views: 614
Posted By Vics Stuff
Re: 35 ford grille

I would agree there . Unless a guy has access to some type of tooling methods . Manufacturing the bars will be a lot of work. .
Vic
Forum: Early V8 (1932-53) 03-20-2021, 11:04 AM
Replies: 26
Views: 1,515
Posted By Vics Stuff
Re: Another find 32 tudor

Looks like a well cared for car. I am sure it is in the right hands. What A find.
Vic
Forum: Early V8 (1932-53) 03-19-2021, 04:14 PM
Replies: 24
Views: 1,304
Posted By Vics Stuff
Re: New 1940 Truck project

Mark ! the truck that you have there is a 1941 called a commercial. They share the same drivetrain as the cars. That is a nice start.
Vic
Forum: Early V8 (1932-53) 03-18-2021, 10:24 AM
Replies: 5
Views: 379
Posted By Vics Stuff
Re: California 1935, Wilshire Blvd in color

That is way cool in color
Vic
Forum: Early V8 (1932-53) 03-15-2021, 11:31 AM
Replies: 5
Views: 340
Posted By Vics Stuff
Re: Weight of lube to put in rear banjo and Manual trans on 1951 Ford

I used 90wt gear oil in my 41 ford pick up.
Forum: Early V8 (1932-53) 03-13-2021, 01:06 AM
Replies: 18
Views: 629
Posted By Vics Stuff
Re: 1933 ford Victoria

On the rear fenders , the rear of the skirtless fender does not roll down the side behind the rear wheel. They are similar to the 32 rear fenders .
Vic
Forum: Early V8 (1932-53) 03-12-2021, 12:29 PM
Replies: 4
Views: 397
Posted By Vics Stuff
Re: 1932 Dash Reapir Patch Panel

Contact John with American Muscle he is in a town right next to Brookville Ohio where Brookville Roadster is located. He does get pieces that have been exposed to moisture from setting around and...
Forum: Early V8 (1932-53) 03-10-2021, 12:18 PM
Replies: 9
Views: 606
Posted By Vics Stuff
Re: 1940 Ford Pickup reproduction parts.

My 41 Ford has Wescott rear glass fenders. They have been on the truck for 30 years . The fit and finish was good and after all these years they still look great.
Vic
Forum: Early V8 (1932-53) 03-04-2021, 12:19 AM
Replies: 10
Views: 746
Posted By Vics Stuff
Re: My Truck Needs a Ride to Mn

August I am headed from Reno Nevada to Milwaukee Wisconsin in my semi. I do have space on back for a vehicle $2,000.00
Vic
Forum: Early V8 (1932-53) 02-22-2021, 05:52 PM
Replies: 17
Views: 1,320
Posted By Vics Stuff
Re: Bob Drake fuel sending unit / customer service

Jason78613 As a car guy I would find myself in your same shoes. I would have tried to manipulate the sending unit to try in loostening it up to save from sending the part back. Like you I have had...
Forum: Early V8 (1932-53) 02-18-2021, 12:02 AM
Replies: 16
Views: 1,086
Posted By Vics Stuff
Re: Rim powder coating

Go to Prismatic Powders .com There you can buy your own powder and have the local guys spray it. I have done that several times.
Vic
Forum: Early V8 (1932-53) 01-30-2021, 11:29 PM
Replies: 15
Views: 1,036
Posted By Vics Stuff
Re: Chrome Shop Recommendations

I second that. Have been using these guys for over 35 years . I ship my parts from Alaska to them. Have been real satisfied with their work. A bit expensive but it depends on the quality of the...
Forum: Early V8 (1932-53) 01-30-2021, 02:38 AM
Replies: 8
Views: 922
Posted By Vics Stuff
Re: remove snapped off bolt

Heat bolt up red hot. Quench with water. Next weld a flat washer over the bolt then weld a nut to the washer. Allow to cool.
Done that on several occasions
Vic
Forum: Early V8 (1932-53) 01-12-2021, 08:36 PM
Replies: 62
Views: 5,966
Posted By Vics Stuff
Re: Hagerty insurance ?

I have had JC Taylor for over 40 years . Only one claim and they were honest , real fair about my claim and getting my car fixed without any hastles.
Vic
Forum: Early V8 (1932-53) 12-15-2020, 11:50 PM
Replies: 22
Views: 1,615
Posted By Vics Stuff
Re: Lug nuts stuck......

You need to heat the nut red hot then immediately quench in cold water. Do this a couple of times and the nut will unscrew easily.
Been there done that
Vic
Forum: Early V8 (1932-53) 12-01-2020, 12:27 PM
Replies: 35
Views: 6,190
Posted By Vics Stuff
Re: Wheels are back from the powder coater

I had my 35 ford wheels powdered coated then took them to a friends tire shop and had new tires mounted on the rims. No scuffs nor scratches.
Vic
Forum: Early V8 (1932-53) 11-14-2020, 01:31 PM
Replies: 56
Views: 3,931
Posted By Vics Stuff
Re: 4 post lifts

I have to agree with Pat/Ohio I have had a Backyard Buddy lift for many years with no problems. Perhaps the safest 4-post lift on the market. They are a bit pricey. I believe I paid around $3,200...
Forum: Early V8 (1932-53) 10-22-2020, 10:58 PM
Replies: 21
Views: 1,720
Posted By Vics Stuff
Re: is it ok to run diluted antifreeze?

I always run a 60 / 40 mix.
Vic
Forum: Early V8 (1932-53) 08-19-2020, 10:30 AM
Replies: 11
Views: 834
Posted By Vics Stuff
Re: Drake's Gas Tank In A "35

It appears that their tanks are a issue with leaking , therefore I would shy away from their tanks.
Vic
Forum: Early V8 (1932-53) 07-07-2020, 10:45 AM
Replies: 9
Views: 819
Posted By Vics Stuff
Re: Celebrating the 4th of July, Alaska style!!

With all the permits to have this event , the state is out there before and after to check that they have cleaned up the carnage. All the vehicles have had all their fluids removed as well.
Vic
Forum: Early V8 (1932-53) 07-07-2020, 10:44 AM
Replies: 9
Views: 819
Posted By Vics Stuff
Re: Celebrating the 4th of July, Alaska style!!

Ford38V8 Yes they do . That is part of the permit. They drain all the fluids out of the vehicle as well before launch off.
Vic
Forum: Early V8 (1932-53) 07-06-2020, 11:17 PM
Replies: 9
Views: 819
Posted By Vics Stuff
Re: Celebrating the 4th of July, Alaska style!!

This event is a must see on your bucked list. They even have been permitted by the State of Alaska and they do go out there and clean up every piece of scrap and leave it all natural . The...
Forum: Early V8 (1932-53) 06-29-2020, 11:48 PM
Replies: 40
Views: 2,559
Posted By Vics Stuff
Re: Antique Insurance a little off Topic

I use J C Taylor out of Darby Pennsylvania. been with them over 4 decades.
Vic
Forum: Early V8 (1932-53) 06-29-2020, 10:59 AM
Replies: 56
Views: 3,309
Posted By Vics Stuff
Re: 1934 Tudor needs a little hop-up

Hello Vincent ! Welcome to the Ford Barn. If I had a fairly original car , I would do all I can to keep it stock. If you were wanting to run at higher speeds I would look into a overdrive system....
Forum: Early V8 (1932-53) 06-25-2020, 11:04 AM
Replies: 23
Views: 1,949
Posted By Vics Stuff
Re: Vapor lock or not ?

You need to check your fuel pump pressure . I had similar issues with my 41 Ford pick up with a worked over flathead. I installed a electric fuel pump before the old mechanical pump and the problem...
Showing results 1 to 25 of 326

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:48 PM.