Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: Terry,OH
Forum: Early V8 (1932-53) 10-17-2020, 05:58 AM
Replies: 14
Views: 514
Posted By Terry,OH
Re: 33 Tranny to Driveshaft Oil Leak

The bearing can be replaced with a bearing that has a seal on one side, the output side. You may have too much oil in the case.
Forum: Early V8 (1932-53) 10-12-2020, 07:59 AM
Replies: 23
Views: 1,033
Posted By Terry,OH
Re: '37 Ford all locked up

I agree the locked up condition does sound like the transmission is in two gears. It also sounds like the battery is bad. I suggest he take the battery to an auto parts store and have it tested or...
Forum: Early V8 (1932-53) 10-10-2020, 10:51 AM
Replies: 3
Views: 193
Posted By Terry,OH
Re: 34 five window seat

Not sure of 33-34 but the 35 seat does use angle brackets on the upper, rear L & R top corners of the back rest to the sides of the side pieces.
Forum: Early V8 (1932-53) 10-10-2020, 09:59 AM
Replies: 23
Views: 1,033
Posted By Terry,OH
Re: '37 Ford all locked up

Are you trying to start with the clutch depressed? Or is the transmission in neutral? What is the condition of the battery?
Forum: Early V8 (1932-53) 10-07-2020, 07:08 AM
Replies: 25
Views: 797
Posted By Terry,OH
Re: 1941 convertible backfire to carb, with video

Fuel pressure is too high 2 to 2-1/2. The high pressure will cause engine to flood with fuel, since the carburetor fuel shut off valve was not designed for the pressure you have.

Can you...
Forum: Early V8 (1932-53) 10-06-2020, 08:02 AM
Replies: 49
Views: 1,522
Posted By Terry,OH
Re: Cooling system help needed

Fill coolant to just cover the radiator tubes. Too much and it will come out.
Forum: Early V8 (1932-53) 10-05-2020, 09:44 AM
Replies: 1
Views: 174
Posted By Terry,OH
Re: 37-48 V8 water pump

It is later vintage not early 37-41. It is an original Ford Part. The early ones do not have the Ford Script.
Forum: Early V8 (1932-53) 10-05-2020, 06:30 AM
Replies: 18
Views: 637
Posted By Terry,OH
Re: Different Key ways??

Do you have an adjustable drag link?
Forum: Early V8 (1932-53) 10-03-2020, 01:16 PM
Replies: 15
Views: 632
Posted By Terry,OH
Re: Problem Removing Steering Wheel

Near the bottom of the horn rod there is a recess in the recess is a C-clip. The C-clip holds the light switch spider and spring in place. The C-clip has to be removed usually by compressing the...
Forum: Early V8 (1932-53) 09-29-2020, 06:49 AM
Replies: 17
Views: 620
Posted By Terry,OH
Re: 33-34 Ford radiator mount pieces

They show up from time to time on the auction site. The pair below is 34 as mentioned above the 33 are much different.
Forum: Early V8 (1932-53) 09-28-2020, 06:36 AM
Replies: 15
Views: 619
Posted By Terry,OH
Re: Trunk Lid won't open

I had thought the 40 and 41 took the same deck lid lock cylinder. If so there are several NOS for sale. You could put the screwdriver in the tool box.
Forum: Early V8 (1932-53) 09-27-2020, 06:55 AM
Replies: 15
Views: 619
Posted By Terry,OH
Re: Trunk Lid won't open

The handle lock bolt could still be installed with the lock cylinder removed. The bold may have moved into the lock position preventing the handle from moving. See if you can insert a small...
Forum: Early V8 (1932-53) 09-26-2020, 09:40 AM
Replies: 20
Views: 570
Posted By Terry,OH
Re: 33 5w coupe rear window drain tube.

My 34 5W also had the clamp and remnants of the hose to drain in the same location. I do have the hole in the floor for the tube in the other location.
Forum: Early V8 (1932-53) 09-26-2020, 09:34 AM
Replies: 15
Views: 759
Posted By Terry,OH
Re: 1947 Lincoln Zephyr

The glove lock may not have a code and yet a key may be made for it, there are several factors.
Forum: Early V8 (1932-53) 09-26-2020, 06:57 AM
Replies: 15
Views: 759
Posted By Terry,OH
Re: 1947 Lincoln Zephyr

Not an expert here but I looked over the electrical drawings. The hydraulic system is for the windows, I saw no switch for the trunk or electrical wiring in the trunk for an opener. For Ford from...
Forum: Early V8 (1932-53) 09-25-2020, 05:15 AM
Replies: 3
Views: 257
Posted By Terry,OH
Re: Temperature gauge assembly

Use a line wrench, and a bit of heat helps.
Forum: Early V8 (1932-53) 09-24-2020, 06:04 AM
Replies: 55
Views: 2,336
Posted By Terry,OH
Re: new engine start-up problems

Beside above suggestion from Bursonaw check the ignition wiring to the coil and ignition switch.
Forum: Early V8 (1932-53) 09-22-2020, 06:20 AM
Replies: 15
Views: 738
Posted By Terry,OH
Re: syncro hub position for second

I am confused, the hub is the center part of the syncro and the syncro sleeve is the outer part. On the early syncro with 6 steel balls the hub moves on the splined shaft and the later syncros with...
Forum: Early V8 (1932-53) 09-16-2020, 11:12 AM
Replies: 6
Views: 257
Posted By Terry,OH
Re: Steering gear box leak

No seal there, leave the box empty of lube until after reinstalled.
Forum: Early V8 (1932-53) 09-16-2020, 06:40 AM
Replies: 15
Views: 688
Posted By Terry,OH
Re: 1936 Overheating Problem

35-6 are prone to over heat issues. Ford added modifications to several items such as louvers to the inner fender panels of 36 to improve cooling but they work best when the car is moving. IMO I...
Forum: Early V8 (1932-53) 09-15-2020, 06:25 AM
Replies: 11
Views: 367
Posted By Terry,OH
Re: Gas tank sender unit.

Look the sender over VERY closely even with a magnifying glass to make sure there are no cracks in ANY solder joint especially where the tubes go through the mounting plate and where they enter the...
Forum: Early V8 (1932-53) 09-15-2020, 06:15 AM
Replies: 11
Views: 649
Posted By Terry,OH
Re: 1937 Ford V8 Steering Box Bushes

They do look correct to me also. You can not hammer the new bushings into place and they MUST be started evenly.
Forum: Early V8 (1932-53) 09-15-2020, 06:11 AM
Replies: 15
Views: 770
Posted By Terry,OH
Re: adjusting 39 Ford pickup shocks

The small adjustment usually makes a very big difference. are the shocks full of fluid? Go ahead and move the pointer 3/8" When were the shocks rebuilt?
Forum: Early V8 (1932-53) 09-13-2020, 06:03 AM
Replies: 12
Views: 591
Posted By Terry,OH
Re: 1935 Ford Pickup Transmission hard to get into reverse! HELP!

Hard to tell what is the problem from here but if you have not rebuilt the top shift mechanism it may be time. Does the problem occur at idle, while down shifting, with engine off??? A bit more info...
Forum: Early V8 (1932-53) 09-13-2020, 05:50 AM
Replies: 15
Views: 770
Posted By Terry,OH
Re: adjusting 39 Ford pickup shocks

Turn CW to increase resistance and CCW for less. Suggest you take a note of your start point and only move about 1/32" at a time.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:02 PM.