Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Page 1 of 4 1 234
Showing results 1 to 25 of 88
Search took 0.01 seconds. Search: Posts Made By: Dave O
Forum: Model A (1928-31) 06-09-2018, 04:22 PM
Replies: 6
Views: 1,792
Posted By Dave O
Re: Babbiting

It's not exactly Ohio, but I recommend Dennis Piranio of Piranio Antique Automotive in Denton, Texas. Excellent babbit and machine work. If you are planning on a touring engine, I suggest you talk...
Forum: Model A (1928-31) 06-08-2018, 09:02 PM
Replies: 8
Views: 1,526
Posted By Dave O
Re: Starter Issue

Thanks for all the input!
Forum: Model A (1928-31) 06-08-2018, 04:47 PM
Replies: 8
Views: 1,526
Posted By Dave O
Re: Starter Issue

Sounds right. I'll check it out. Thanks!
Forum: Model A (1928-31) 06-08-2018, 03:46 PM
Replies: 8
Views: 1,526
Posted By Dave O
Re: Starter Issue

Anybody ever have this problem where the starter motor keeps running after the engine starts?
Forum: Model A (1928-31) 06-08-2018, 11:50 AM
Replies: 8
Views: 1,526
Posted By Dave O
Starter Issue

On several occasions my starter has kept turning after the engine starts and bendix releases. What could be causing this? I'm still on the original 6 volt system.
Forum: Model A (1928-31) 11-30-2017, 08:00 PM
Replies: 7
Views: 1,801
Posted By Dave O
Re: Steering Wheel Install - What did I do wrong?

Thanks for the replies. I'm pretty sure I installed the bushing but I will double check. The horn rod is the orignal rod so there should not be any fitment issues. I may have found the culprit. ...
Forum: Model A (1928-31) 11-30-2017, 02:35 PM
Replies: 7
Views: 1,801
Posted By Dave O
Steering Wheel Install - What did I do wrong?

After installing the new steering wheel, the light switch turns with the wheel. is there a washer under the light switch handle that I have left out?
Forum: Model A (1928-31) 07-22-2017, 10:04 PM
Replies: 27
Views: 14,034
Posted By Dave O
Re: Elkpointe & Kawanee Green Paint

Here is my version. Used the color chips in the paint manual to get as close as I could working with the folks at the local English Color store. And then, at the end of the day, I went with what I...
Forum: Model A (1928-31) 07-14-2017, 08:52 PM
Replies: 14
Views: 2,481
Posted By Dave O
Re: Brattons timing calibration tool

Hadn't seen this tool before. I like it. Made one out of bits and pieces tonight. will try in out tomorrow.
Forum: Model A (1928-31) 07-14-2017, 06:14 PM
Replies: 5
Views: 1,439
Posted By Dave O
Re: Timing gear Recess

Is there a way to find TDC without removing the head, since the spark plug is offset from the piston?
Forum: Model A (1928-31) 07-14-2017, 05:13 PM
Replies: 5
Views: 1,439
Posted By Dave O
Timing gear Recess

The recess/indention in the timing gear that is used when setting the timing on my car is very shallow and I have a hard time finding TDC for #1 cylinder. This is a new fiber gear that I installed...
Forum: Model A (1928-31) 07-09-2017, 03:07 PM
Replies: 21
Views: 3,394
Posted By Dave O
Re: Stop Light Location

Thanks for the suggestions folks. Guess I am being a little too anal over this.
Forum: Model A (1928-31) 07-09-2017, 09:39 AM
Replies: 21
Views: 3,394
Posted By Dave O
Stop Light Location

Where can I find dimensional data on the location of the stop light bracket on the rear fenders (I'm putting stop lights on both fenders)? I didn't have enough sense to measure the bolt holes on the...
Forum: Model A (1928-31) 07-08-2017, 06:40 PM
Replies: 19
Views: 3,567
Posted By Dave O
Re: Exhaust leak secrets

Thanks for all the suggestions. If none of these work, out comes the welder. LOL
Forum: Model A (1928-31) 07-08-2017, 03:32 PM
Replies: 19
Views: 3,567
Posted By Dave O
Re: Exhaust leak secrets

OK thanks. I haven't tried muffler sealant yet.
Forum: Model A (1928-31) 07-08-2017, 03:03 PM
Replies: 19
Views: 3,567
Posted By Dave O
Exhaust leak secrets

What's the trick to stopping a small leak between the exhaust manifold and muffler? I bought a new clamp, seal, and exhaust sleeve. made sure there was a good fit between the muffler and manifold...
Forum: Model A (1928-31) 07-01-2017, 05:10 PM
Replies: 9
Views: 2,742
Posted By Dave O
Re: Spare Tire Carrier - Is there a gasket?

Thanks for the hint Rusty. It just bugged me to put heavy cast iron on new paint!
Forum: Model A (1928-31) 07-01-2017, 03:48 PM
Replies: 9
Views: 2,742
Posted By Dave O
Spare Tire Carrier - Is there a gasket?

For the spare tire carriers that fit on the trunk of the Std Coupe (w/rumble seat), is there a rubber gasket, etc that fits between the carrier and the trunk?
Forum: Model A (1928-31) 06-26-2017, 04:30 PM
Replies: 9
Views: 1,426
Posted By Dave O
Re: Windshield - what goes here??

Thanks Jason. That flat piece is what I didn't see looking into the hole. I have ordered a screw kit which includes the nuts. Thanks.
Forum: Model A (1928-31) 06-26-2017, 02:59 PM
Replies: 9
Views: 1,426
Posted By Dave O
Re: Windshield - what goes here??

Jason,
Thanks for the response. I have the piece you are talking about and the screws fit into the side of the frame as you state. But mine also has two holes at the top (one each side) as shown...
Forum: Model A (1928-31) 06-26-2017, 02:32 PM
Replies: 9
Views: 1,426
Posted By Dave O
Windshield - what goes here??

What type of screw goes into the two holes at the top of the windshield frame and what do they screw into? The hole extends into the channel that holds the rubber seals. Is this intended to hold...
Forum: Model A (1928-31) 04-19-2017, 05:40 PM
Replies: 4
Views: 1,249
Posted By Dave O
Re: roof/visor fit

jdupay, you are right that the metal trim piece is missing, as well as the front header wood. I took that off to see if I needed to shape the wood some to make the top metal fit better. But it it...
Forum: Model A (1928-31) 04-19-2017, 02:52 PM
Replies: 4
Views: 1,249
Posted By Dave O
roof/visor fit

Putting the car back together I have run into an issue where the roof meets with the visor. Is it normal to have the amount of gap shown in the pictures? I don't see how the trim piece would ever...
Forum: Model A (1928-31) 03-30-2017, 08:06 PM
Replies: 13
Views: 2,188
Posted By Dave O
Re: Rear Hub Tightening

Thanks Katy. Got em!
Forum: Model A (1928-31) 03-30-2017, 09:53 AM
Replies: 13
Views: 2,188
Posted By Dave O
Re: Rear Hub Tightening

Thanks for all the excellent input. Looks like I need to size the brake shoes to the new drum. My assumption was that since I was not replacing the shoes they were worn enough and would be OK. BAD...
Showing results 1 to 25 of 88
Page 1 of 4 1 234

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:57 AM.