Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 180
Search took 0.01 seconds.
Search: Posts Made By: Arlyn Bieber
Forum: Model-A 09-10-2023, 09:07 PM
Replies: 0
Views: 396
Posted By Arlyn Bieber
original front seats

Pair of original front "bucket" seats for Model A Tudor. Upholstery in excellent condition but not original. $75 for pair plus UPS charges. [email protected] San Diego, CA
Forum: Model A (1928-31) 08-03-2023, 10:41 PM
Replies: 10
Views: 1,657
Posted By Arlyn Bieber
Burtz engine oil pump

According to Burtz engine Builders Guide---- A stock Model A oil pump with close fitting gears has been found to provide more than adequate volume and a relief valve is needed etc. Has anyone tried...
Forum: Model-A 03-08-2023, 10:38 AM
Replies: 0
Views: 427
Posted By Arlyn Bieber
Victoria rear window shade

Need an original rear window shade roller for Victoria, 26 inches long. Also rear assist straps used to assist when you exit the rear seat area. Thanks Arlyn Bieber
Forum: Model-A 02-22-2023, 09:36 PM
Replies: 0
Views: 574
Posted By Arlyn Bieber
Victoria front seats, either early of late ones

Need original front seats for Victoria, condition of upholstery is not an issue. Can be the early or late seats. Thanks, Arlyn Bieber, [email protected] or 858-530-2336
Forum: Model-A 02-10-2023, 12:58 AM
Replies: 0
Views: 685
Posted By Arlyn Bieber
Victoria sun visor bracket

Wanted Victoria or slant window sedan inside sun visor bracket. Arlyn Bieber [email protected]
Forum: Model-A 10-28-2022, 08:56 PM
Replies: 0
Views: 413
Posted By Arlyn Bieber
Right side spare tire plate

Looking for an original right side spare tire plate used to hold the spare tire in the fender. An original will have a "R" stamped in the plate. anbieb@ san.rr.com
Forum: Model A (1928-31) 05-16-2022, 08:52 AM
Replies: 15
Views: 2,185
Posted By Arlyn Bieber
Re: Rear Main Thrust Face

Larry is right. I have built more babbit engines than I can remember. Anything you do is a band aid at this point. The engine babbit is worn out, Do it right and replace the babbit, machine and...
Forum: Model A (1928-31) 12-26-2021, 11:44 AM
Replies: 8
Views: 1,317
Posted By Arlyn Bieber
Re: Original Robe rail Material-'31 sedans

Have an original with end caps for sale. Any interest? Arlyn Bieber, San Diego
Forum: Model A (1928-31) 08-08-2021, 03:23 PM
Replies: 47
Views: 5,070
Posted By Arlyn Bieber
Re: Do I panic? - Rear main oil leak.

Is it leaking a 1" puddle or a 6" puddle? If a 1" puddle, that is normal. If a 6"puddle and it happened suddenly and is coming from the rear of the engine, the rear main babbit bearing has probably...
Forum: Model-A 05-30-2021, 05:05 PM
Replies: 0
Views: 557
Posted By Arlyn Bieber
Early 1930 coupe electric windshield wiper

Need an original electric windshield wiper for an early 1930 Model A Coupe. Arlyn Bieber, [email protected]
Forum: Model-A 04-21-2021, 09:14 PM
Replies: 0
Views: 547
Posted By Arlyn Bieber
30-31 Coupe wooden header

Need a new 30-31 wood header (above windshield). Checked all the suppliers and none are available until June. Arlyn Bieber
Forum: Model A (1928-31) 03-04-2021, 10:27 AM
Replies: 12
Views: 2,394
Posted By Arlyn Bieber
Re: Radius rod rubber ball replacement.

The rubber ball is designed for the V-8 not Model A. Don't mess with Henry's design, install the original.
Forum: Model A (1928-31) 12-01-2020, 07:49 AM
Replies: 20
Views: 5,548
Posted By Arlyn Bieber
Re: Front End Rebuild Questions

Don't forget to straighten the axle, it is the foundation for all the other work you are doing. It has been my experience after rebuilding over 100 front ends that 99% of the axles are bent. I also...
Forum: Model-A 10-15-2020, 09:58 PM
Replies: 0
Views: 728
Posted By Arlyn Bieber
AA speedometer driven gear needed

Need to purchase a good condition AA speedometer driven gear Part # AA17271-F (6.6-11). The AA truck is an early 1930 short bed. The gear has 17 teeth and is slotted for the oval speedometer cable....
Forum: Model A (1928-31) 02-02-2020, 04:10 PM
Replies: 11
Views: 2,300
Posted By Arlyn Bieber
Re: two Ford assembly plants...

I would pick KC because it is likely my 1930 Coupe was "born" there. I was born in Kansas and rode home from the hospital in that very same Coupe in 1939. That Coupe resides in my garage and is in...
Forum: Early V8 01-02-2020, 10:45 AM
Replies: 0
Views: 862
Posted By Arlyn Bieber
V/8 Clutch Pressure plate

WANTED-- ORIGINAL 35-42 Ford 09A-7563 rebuildable clutch pressure plate with adjustable fingers and centrifugal flyweights [email protected]
Forum: Model A (1928-31) 04-13-2019, 05:33 PM
Replies: 1
Views: 1,122
Posted By Arlyn Bieber
Starter drive shaft end play

Anyone know the Ford specification for starter shaft end play? Just received a rebuilt starter and the end play is 0.120" or nearly 1/8". Seems like a lot to me. Snyder's list two thrust washer...
Forum: Model A (1928-31) 04-11-2019, 09:05 PM
Replies: 12
Views: 2,009
Posted By Arlyn Bieber
Water leak in cylinder

Have an Model A engine that developed a pin hole half way down number 3 cylinder. Bored the cylinder and installed a sleeve thinking that would stop the water leak but now when I air test the water...
Forum: Model-A 03-30-2019, 03:24 PM
Replies: 0
Views: 491
Posted By Arlyn Bieber
Victoria & slant window sedan rear curtain roller

Original rear window curtain roller 26 1/2" long. For Victoria and slant window sedan. $50 plus shipping. no cloth. email [email protected] for pictures
Forum: Model-A 03-30-2019, 03:17 PM
Replies: 0
Views: 499
Posted By Arlyn Bieber
Victoria original rear window curtain

Victoria original rear window curtain roller with new brown silk diamond pattern cloth per Judging Standards. $125 plus shipping. email [email protected] for more info and pictures. San Diego
Forum: Model A (1928-31) 03-18-2019, 11:04 PM
Replies: 10
Views: 1,808
Posted By Arlyn Bieber
Re: Wheel Balance with Dyna Beads

The easy way to install the beads is with an ice pick punch a hole in the tube then insert the beads and patch the hole. Of course you have to remove the tire and tube. Another way is to install...
Forum: Model-A 03-17-2019, 09:34 PM
Replies: 0
Views: 783
Posted By Arlyn Bieber
Original Model A Intruction Books

1. Original late '31 instruction book, mint condition $125
2. Original inst. book center E. brake (squeeze grip) good condition $30
3. Original inst. book center E. brake (squeeze grip) fair...
Forum: Model-A 03-17-2019, 09:00 PM
Replies: 0
Views: 681
Posted By Arlyn Bieber
Original Model A window curtain rollers

Original window curtain rollers for rear and side windows.
1. Original window curtain roller 26 1/2" long with new Brown silk w/ tab, criss-cross pattern per Judging Standards $125
2. Original...
Forum: Model A (1928-31) 02-14-2019, 11:00 AM
Replies: 29
Views: 4,057
Posted By Arlyn Bieber
Re: Stearing sector problems

Unless I am restoring for 500 points I would never attempt to restore a 7 tooth box. Been down that road!!!! Henry changed to a 2 tooth for a reason. I suggest you do the same. Forget trying to...
Forum: Model A (1928-31) 01-05-2019, 07:16 PM
Replies: 2
Views: 1,670
Posted By Arlyn Bieber
Enclosed 30' trailer

Anyone know of an enclosed 30' trailer in Southern CA that could be rented to transport 2 Model As from San Diego to the MARC National Meet next August. Thanks Arlyn Bieber, [email protected]
Showing results 1 to 25 of 180

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:32 AM.