Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: john charlton
Forum: Model A (1928-31) 06-23-2021, 02:03 PM
Replies: 31
Views: 3,110
Posted By john charlton
Re: model b engine cm gear

The Dagenham B block is not a smaller bore block it has the regular 3 7/8" bore same as USA. the BF block has the 3" bore . I measured a B block . The Dagenham B block is a different casting from the...
Forum: Model A (1928-31) 06-23-2021, 02:02 PM
Replies: 31
Views: 3,110
Posted By john charlton
Re: model b engine cm gear

The Dagenham B block is not a smaller bore block it has the regular 3 7/8" bore same as USA. the BF block has the 3" bore . I measured a B block . The Dagenham B block is a different casting from the...
Forum: Model A (1928-31) 06-22-2021, 03:06 PM
Replies: 31
Views: 3,110
Posted By john charlton
Re: model b engine cm gear

In a Dagenham block the entry hole in the gallery is 3/8" dia and the front exit hole is 1/4" so way smaller flow volume maybe different from a USA block .

John in same place same weather
Forum: Model A (1928-31) 06-21-2021, 03:38 PM
Replies: 31
Views: 3,110
Posted By john charlton
Re: model b engine cm gear

The hole is to lubricate the timing wheel and dipper tray as there is no hole in the casting like a Model A engine . The oil pump has a capacity to pressure feed the main bearings and lubricate the...
Forum: Model A (1928-31) 06-21-2021, 01:06 PM
Replies: 31
Views: 3,110
Posted By john charlton
Re: model b engine cm gear

The pressure relief system is that the oilpump drive is held down by the spring . When excess pressure occurs the drive lifts slightly against the spring pressure enough to regulate as the oil spills...
Showing results 1 to 5 of 5

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:21 PM.