Forum: Late V8 (1954+)
11-20-2022, 07:58 AM
|
|
Replies: 3
Views: 617
|
|
Forum: Late V8 (1954+)
11-19-2022, 08:32 PM
|
|
Replies: 3
Views: 617
|
|
Forum: Late V8 (1954+)
05-04-2022, 03:34 PM
|
|
Replies: 11
Views: 1,310
Re: 2014 f-150 wiper controls
A message to all of you that responded to my inquiry about the multi-function wiper switch on my 2014 F-150. First & foremost, a thank you to all of you for the tech info and advise. With that in...
|
|
Forum: Late V8 (1954+)
04-26-2022, 08:01 PM
|
|
Replies: 11
Views: 1,310
2014 f-150 wiper controls
Despite the wiper switch being rotated to the fully off position, the wipers continue to cycle at what appears to be the slowest (longest interval between wipes) position. These are not "autowipers"....
|
|
Forum: Late V8 (1954+)
12-14-2021, 09:38 AM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-10-2021, 02:23 PM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-06-2021, 12:20 PM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-06-2021, 12:20 PM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-05-2021, 10:26 AM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-03-2021, 04:54 PM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-03-2021, 06:19 AM
|
|
Replies: 16
Views: 1,752
|
|
Forum: Late V8 (1954+)
12-02-2021, 04:28 PM
|
|
Replies: 16
Views: 1,752
PRESSURE GAUGE ABRUPTLY BOTTOMS OUT BELOW 1000 rpm
F150 W/ 3.7 liter V6. Once the engine has been running for 10 - 15 minutes (whether idling or under load), the pressure gauge bottoms out and the engine oil warning symbol and alarm go off as soon as...
|
|
Forum: Early V8 (1932-53)
06-27-2021, 11:06 AM
|
|
Replies: 14
Views: 914
Re: 1939 model 91a charging
First, thanks to all for pointing me in the right direction. Here is an update:
I rolled the dice & disconnected the positive ground while the engine was running. It kept firing & the batt gauge...
|
|
Forum: Early V8 (1932-53)
06-27-2021, 10:13 AM
|
|
Replies: 14
Views: 914
Re: 1939 model 91a charging
It does not look like one of those four. The engine mount is similar but there is no device mounted on the top.
|
|
Forum: Early V8 (1932-53)
06-24-2021, 07:40 PM
|
|
Replies: 14
Views: 914
Re: 1939 model 91a charging
Thanks for the suggestion about testing at the gauge. Will give it a try if I can maneuver sufficiently to access the terminal. Might try to reach up there and hook on with an alligator clip lead.
|
|
Forum: Early V8 (1932-53)
06-24-2021, 07:23 PM
|
|
Replies: 14
Views: 914
Re: 1939 model 91a charging
Went right to the battery ground at the firewall for the ground. Set the multimeter on voltage & DC and then got scattered readings. Not sure what that is all about but going to try again with...
|
|
Forum: Early V8 (1932-53)
06-24-2021, 06:30 PM
|
|
Replies: 14
Views: 914
|
|
Forum: Early V8 (1932-53)
06-24-2021, 06:28 PM
|
|
Replies: 14
Views: 914
Re: 1939 model 91a charging
Thanks for responding. The voltages at the battery at idle & fast idle (no tach but guessing around 2000RPM) are essentially the same - 6.87/6.89. The regulator is the newer rectangular version as...
|
|
Forum: Early V8 (1932-53)
06-23-2021, 08:05 PM
|
|
Replies: 14
Views: 914
1939 model 91a charging
With the ignition switch on & before starting the engine, the battery gauge needle does NOT rise above the lower mark on the gauge. The engine must be at a sustained high idle to even keep the needle...
|
|
Forum: Early V8 (1932-53)
11-16-2020, 09:24 AM
|
|
Replies: 1
Views: 539
1939 MODEL 91A Hand Throttle Linkage
The one and only time I attempted to use the hand throttle, it leaked gas where the linkage connects to the carb. From what I observed and what I have been hearing, it looks like there may not be a...
|
|
Forum: Early V8 (1932-53)
11-16-2020, 09:15 AM
|
|
Replies: 1
Views: 414
1939 MODEL 91A Side view Mirrors
I am looking to replace the side view mirror assemblies and see where they are connected to the upper door hinge.
I cannot see any way to readily disconnect the mirror arms from the hinges.
Any...
|
|
Forum: Early V8 (1932-53)
10-22-2020, 04:16 PM
|
|
Replies: 9
Views: 2,083
Re: Jacking 1939 model 91A
Thanks to all for the suggestions. I am now the proud owner of a 1.5 T floor jack which will be in the trunk along with a short length of 2 X 12 & 2 chock blocks. As the jack is aluminum & steel, it...
|
|
Forum: Early V8 (1932-53)
10-19-2020, 11:08 AM
|
|
Replies: 9
Views: 2,083
Jacking 1939 model 91A
If I place the jack under the rear bumper arms as depicted in the Ford "Reference Book," the body goes up but not the tires. What am I doing wrong?
Otherwise, my only alternative is to use a floor...
|
