Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: FortyNiner
Forum: Early V8 (1932-53) 10-06-2019, 05:04 PM
Replies: 20
Views: 723
Posted By FortyNiner
Re: Test fired my flattey!!

You've got some serious go juice feeders on that flatty. I like it.
Forum: Early V8 (1932-53) 10-04-2019, 03:43 PM
Replies: 5
Views: 199
Posted By FortyNiner
Re: 1947 shock dogbones

You were reworking a defective part rather than returning it, correct? I doubt the glue matters since the friction fit is the key. Hopefully they work as you expect.
Forum: Early V8 (1932-53) 10-03-2019, 11:18 AM
Replies: 1
Views: 86
Posted By FortyNiner
Re: horn button

You have the button and not the horn ring setup, correct?
Forum: Early V8 (1932-53) 10-02-2019, 09:01 AM
Replies: 1
Views: 249
Posted By FortyNiner
Re: Swap meets please help

Jefferson, Wisconsin April 24 -26 http://www.madisonclassics.com/our-events/
Forum: Early V8 (1932-53) 10-01-2019, 07:46 AM
Replies: 12
Views: 396
Posted By FortyNiner
Re: Heater Core

Also check with these folks: http://ucvintagerad.com/
Forum: Early V8 (1932-53) 09-29-2019, 09:13 PM
Replies: 25
Views: 2,279
Posted By FortyNiner
Re: A Dennis Carpenter Complaint??

They learned from someone....
Forum: Early V8 (1932-53) 09-28-2019, 02:01 PM
Replies: 16
Views: 413
Posted By FortyNiner
Re: Radiator shops in Houston Texas

Do you have thermostats?
Forum: Early V8 (1932-53) 09-27-2019, 07:10 PM
Replies: 6
Views: 242
Posted By FortyNiner
Re: rear shock dogbones

The stud spinning is problematic.
Forum: Early V8 (1932-53) 09-27-2019, 04:24 PM
Replies: 6
Views: 242
Posted By FortyNiner
Re: rear shock dogbones

I would be returning a defective part.
Forum: Early V8 (1932-53) 09-27-2019, 04:21 PM
Replies: 8
Views: 286
Posted By FortyNiner
Re: 1948 Ford Tudor Sedan front fender brace

Round II

Wasn't a size issue, just didn't like one of the files.
Forum: Early V8 (1932-53) 09-27-2019, 12:08 PM
Replies: 8
Views: 286
Posted By FortyNiner
Re: 1948 Ford Tudor Sedan front fender brace

This is the set up for a '46:

Sorry, pics not posting.
Forum: Early V8 (1932-53) 09-27-2019, 09:15 AM
Replies: 8
Views: 517
Posted By FortyNiner
Re: 6volt battery charger

NAPA has this: https://www.napaonline.com/en/p/SORPL2310?partTypeName=Battery+Charger&keywordInput=charger
Forum: Early V8 (1932-53) 09-26-2019, 01:44 AM
Replies: 10
Views: 393
Posted By FortyNiner
Re: New water pump woes

Which engine? What year?
Forum: Early V8 (1932-53) 09-22-2019, 06:19 PM
Replies: 8
Views: 308
Posted By FortyNiner
Re: 1951 Starter 6&8

I understand that most use the 6V starter after the 12V conversion.
Forum: Early V8 (1932-53) 09-19-2019, 09:11 PM
Replies: 5
Views: 654
Posted By FortyNiner
Re: Skip Haney

Try this: http://www.fordcollector.com/
Forum: Early V8 (1932-53) 09-16-2019, 02:03 PM
Replies: 10
Views: 371
Posted By FortyNiner
Re: 52 f1

Perhaps I'm missing the issue here. There aren't many places to hide the pin. The inner handle shaft aligns with the holes on the mechanism shaft - the pin spans between the pieces.
Forum: Early V8 (1932-53) 09-15-2019, 05:09 PM
Replies: 10
Views: 371
Posted By FortyNiner
Re: 52 f1

Based on the typical wear issues with these mechanisms, the pin isn't likely the issue.

You'll need to hold the escutcheon ring back against the door to remove the pin. Use the blade of a...
Forum: Early V8 (1932-53) 09-13-2019, 08:16 PM
Replies: 6
Views: 258
Posted By FortyNiner
Re: Master cylinder bleeding

I would recommend bench bleeding the MC. Check out this video at about the 11 minute mark: https://m.youtube.com/watch?v=tOCkFYhTskQ
Forum: Early V8 (1932-53) 09-12-2019, 02:53 AM
Replies: 18
Views: 585
Posted By FortyNiner
Re: 1950 Ford F1 value?

During a 70 year life, there are bound to be many opportunities for a variety of actions with value consequences. Absolutely be diligent with your inspection before buying any old vehicle but a...
Forum: Early V8 (1932-53) 09-11-2019, 09:43 AM
Replies: 18
Views: 585
Posted By FortyNiner
Re: 1950 Ford F1 value?

They are. I would attribute any perceived differences to lighting.
Forum: Early V8 (1932-53) 09-11-2019, 09:40 AM
Replies: 18
Views: 772
Posted By FortyNiner
Re: Hello

Glad to have you on board.
Forum: Early V8 (1932-53) 09-10-2019, 09:36 PM
Replies: 18
Views: 585
Posted By FortyNiner
Re: 1950 Ford F1 value?

Yup, $15K+. That looks like an exception survivor.
Forum: Early V8 (1932-53) 09-10-2019, 12:55 PM
Replies: 24
Views: 787
Posted By FortyNiner
Re: On the horn now

Oops on the assumption.

There are three relay leads: horn button, the horn(s), and power (usually from the hot side of the solenoid). The horn itself is grounded (typically with the mounting but...
Forum: Early V8 09-06-2019, 05:17 PM
Replies: 0
Views: 96
Posted By FortyNiner
Forum: Early V8 (1932-53) 08-27-2019, 08:53 PM
Replies: 1
Views: 199
Posted By FortyNiner
Re: '48 Ford dash

Yup, any good adhesive should work. There isn't too much tension on the fasteners.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:44 PM.