Forum: Early V8 (1932-53)
09-02-2019, 07:43 PM
|
|
Replies: 22
Views: 3,116
Re: Flathead repair
I had the coil and the condenser check underload when I had my distributor rebuilt. But keep the ideas coming. I am sure out of ideas
|
|
Forum: Early V8 (1932-53)
09-01-2019, 08:44 PM
|
|
Replies: 22
Views: 3,116
|
|
Forum: Early V8 (1932-53)
09-01-2019, 07:59 PM
|
|
Replies: 22
Views: 3,116
|
|
Forum: Early V8 (1932-53)
09-01-2019, 06:58 PM
|
|
Replies: 22
Views: 3,116
|
|
Forum: Early V8 (1932-53)
09-01-2019, 09:10 AM
|
|
Replies: 22
Views: 3,116
|
|
Forum: Early V8 (1932-53)
08-31-2019, 09:37 PM
|
|
Replies: 22
Views: 3,116
Re: Flathead repair
Did it run fine when you had your foot of the gas but when you gave it gas the it would start to act up. Also does it make a sound like air going through baffles. It almost sounds like the sound that...
|
|
Forum: Early V8 (1932-53)
08-31-2019, 07:24 PM
|
|
Replies: 22
Views: 3,116
|
|
Forum: Early V8 (1932-53)
08-31-2019, 06:16 PM
|
|
Replies: 22
Views: 3,116
Re: Flathead repair
That I have not check but I have never seen oil in the radiator or water in the oil. Funny thing is if I turn the car off for 5 minutes and start it up it will run fine again but a couple of minutes...
|
|
Forum: Early V8 (1932-53)
08-31-2019, 05:39 PM
|
|
Replies: 22
Views: 3,116
Flathead repair
Can anyone point me in the right direction to a repair shop in north eastern PA that is really good with Flathead fords.. I can not find the issue with my 36. Runs great for about 1/2 an hour. Then...
|
|
Forum: Early V8 (1932-53)
09-17-2018, 06:55 PM
|
|
Replies: 8
Views: 1,915
Re: 36 running rough
Thank you all. I am going to send check the spark and if need send the coils to skip for rebuilding
|
|
Forum: Early V8 (1932-53)
09-16-2018, 01:52 PM
|
|
Replies: 8
Views: 1,915
36 running rough
Ran my stock 36 for about 2 hours today. It ran great except for the last 20 minutes. The car stated to loss power and buck. It only did this under load. The tempter of the car was fine at 185. So i...
|
|
Forum: Early V8 (1932-53)
09-03-2018, 06:48 AM
|
|
Replies: 3
Views: 1,134
|
|
Forum: Early V8 (1932-53)
09-02-2018, 08:47 PM
|
|
Replies: 3
Views: 1,134
36 ford radio
Does anyone have a photo of the fuse holder that goes on the hot wire to the radio. Also does anyone know were to get one.
|
|
Forum: Early V8 (1932-53)
04-03-2018, 07:23 PM
|
|
Replies: 9
Views: 2,535
|
|
Forum: Early V8 (1932-53)
11-22-2017, 07:33 PM
|
|
Replies: 7
Views: 1,777
|
|
Forum: Early V8 (1932-53)
11-19-2017, 06:36 AM
|
|
Replies: 5
Views: 1,754
|
|
Forum: Early V8 (1932-53)
11-11-2017, 11:29 AM
|
|
Replies: 179
Views: 33,975
|
|
Forum: Early V8 (1932-53)
11-10-2017, 06:58 AM
|
|
Replies: 45
Views: 8,586
Re: re-install 36 distributor
My dad did say it had something to do with the fact the Ford did not want to spend the extra money for additional gears to move the distributor.
|
|
Forum: Early V8 (1932-53)
11-08-2017, 08:38 PM
|
|
Replies: 45
Views: 8,586
|
|
Forum: Early V8 (1932-53)
11-08-2017, 07:14 PM
|
|
Replies: 45
Views: 8,586
Re: re-install 36 distributor
My dad tells a story of going to a v8 club meeting in the 70s and the speaker was the guy who put the distributor in that spot. Started his speech by saying that he was the son of a bitch the put...
|
|
Forum: Early V8 (1932-53)
10-09-2017, 07:27 PM
|
|
Replies: 40
Views: 5,966
Re: hershey
I think that it is a lot of walking and there are a lot of empty spaces between the vendors making it hard for people. For a lot of people it is just to much walking. I can't wait to go to Hershey...
|
|
Forum: Early V8 (1932-53)
09-30-2017, 08:39 PM
|
|
Replies: 9
Views: 1,467
Re: 36 ford wiper motor
Thank you Terry. I checked with Kent and he is out right know. I am going to Hershey next week maybe I will get lucky
|
|
Forum: Early V8 (1932-53)
09-28-2017, 08:04 PM
|
|
Replies: 9
Views: 1,467
|
|
Forum: Early V8 (1932-53)
09-27-2017, 05:20 PM
|
|
Replies: 9
Views: 1,467
|
|
Forum: Early V8 (1932-53)
09-27-2017, 03:15 PM
|
|
Replies: 69
Views: 13,183
|
