Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 14 of 14
Search took 0.00 seconds.
Search: Posts Made By: the99car
Forum: Early V8 (1932-53) 01-03-2020, 09:48 PM
Replies: 17
Views: 1,063
Posted By the99car
Re: crab distributor setup

I've got pertronix in my '48(was in it when I bought it) and just got one for my '46. Instructions don't tell how to time it. do you just install , start it and "fine tune" with the slight adj on...
Forum: Early V8 (1932-53) 08-24-2018, 07:44 AM
Replies: 8
Views: 864
Posted By the99car
Re: It Just don't figure

Thanks all. I'm heading out to the shop to play. I have the electric pump on a toggle so will see what happens with just the manual pump. when it dies out floor boarding it I've checked plugs and...
Forum: Early V8 (1932-53) 08-23-2018, 09:54 PM
Replies: 8
Views: 864
Posted By the99car
It Just don't figure

OK. 1946 sedan V8 all stock 6V. 115 -125 lbs compression, installed electric fuel pump. new plugs & wires. been thru 3 distributors & 3 carbs. and run all new fuel lines. The car will run 75 plus mph...
Forum: Early V8 (1932-53) 06-14-2018, 08:08 PM
Replies: 7
Views: 1,387
Posted By the99car
Re: 46 ignition coil

some times my 46 w/original coil won't start, put a later model 6v coil on and had same problem. I ran a jumper off a toggle switch to the coil and hit it briefly to start when needed. problem...
Forum: Early V8 (1932-53) 08-05-2017, 09:34 PM
Replies: 7
Views: 1,032
Posted By the99car
Re: ignition resistors

OK . NOW. what should the voltage reading be (key bon ,not running) going into the coil from the resister? Kenny - Zhills stock '46 flathead
Forum: Early V8 (1932-53) 09-10-2016, 09:24 PM
Replies: 1
Views: 670
Posted By the99car
distributor, what the ????

are silicone wires ok to use in the tight crammed together dist. cap of a 46 flat head ???? I have checked (I believe) all other areas fuel & ignition . can these plug wires be jumping spark???
...
Forum: Early V8 (1932-53) 09-10-2016, 08:16 AM
Replies: 5
Views: 883
Posted By the99car
Re: what the ????

will check fuel delivery. thans kruzn40
Forum: Early V8 (1932-53) 09-09-2016, 07:18 PM
Replies: 5
Views: 883
Posted By the99car
what the ????

my resent purchase , a 1946 sedan, runs and sounds great til about 1/2 throttle . had dist. out 3 times all set to spec and looks good even cleaned the vac. line coming from intake. all exhaust is...
Forum: Late V8 (1954+) 09-08-2014, 08:11 PM
Replies: 11
Views: 2,233
Posted By the99car
Re: 215 OHV 6 cyl

good call on that oil tube Dave55 I will double check that .my concern was the water passages lining up .The 223 head was revamped for more even cooling but I don't know if the holes line up. I will...
Forum: Late V8 (1954+) 09-08-2014, 03:27 PM
Replies: 11
Views: 2,233
Posted By the99car
215 OHV 6 cyl

Can I run a 223 (1954) head on a (1953) 215 block ??? - Kenny in Zhills, Fl
Forum: Early V8 (1932-53) 09-08-2014, 03:24 PM
Replies: 3
Views: 1,015
Posted By the99car
OHV 6 215cid

Will a 223 head go on a 215 block?? Kenny in Zhills,Fl
Forum: Early V8 (1932-53) 03-13-2011, 09:09 PM
Replies: 374
Views: 144,569
Posted By the99car
Re: An Early Ford Truck Post... Let's see them.

How do I get to the hardware store?.....
Forum: Early V8 (1932-53) 03-13-2011, 08:48 PM
Replies: 82
Views: 48,815
Posted By the99car
Re: Fleathead Engine Stands

I need that 4 speed AA trany in the picture there.the99car@yahoo.com
Forum: Late V8 07-17-2010, 09:34 PM
Replies: 2
Views: 966
Posted By the99car
Re: Rebuilt ford 6 cyl carb, 1952-1962

contact me about carb- the99car@yahoo.com thanks
Showing results 1 to 14 of 14

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:34 AM.