Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 63
Search took 0.01 seconds.
Search: Posts Made By: Redhorse1947
Forum: Early V8 (1932-53) 05-13-2019, 08:53 AM
Replies: 4
Views: 983
Posted By Redhorse1947
1934 Pickup Steering-wheel turns

I need some help/advise on the steering on my 1934 pickup. Specifically, how many turns (from center) is there to the left and to the right. From center (wheels straight ahead, drag link installed)...
Forum: Early V8 11-11-2017, 04:44 PM
Replies: 0
Views: 741
Posted By Redhorse1947
SOLD - 1937-1948 Skip Haney Water Pumps

SOLD: Pair of WIDE belt water pumps rebuilt by Skip Haney ................................................................................................................

These pumps fit 1937-1948...
Forum: Early V8 (1932-53) 11-05-2017, 02:03 PM
Replies: 2
Views: 668
Posted By Redhorse1947
1934 Pickup with 8ba...install problems

Back in May 2010 (yes, seven years ago) I posted a question under the above title. With the advice given and confirmed by other sources I will use a 1950 Mercury with a pre-1949 camshaft + early...
Forum: Early V8 (1932-53) 01-28-2015, 09:03 AM
Replies: 10
Views: 2,760
Posted By Redhorse1947
1949 F-1 Master cylinder-NAPA

I picked up a NAPA master cylinder and notice quite a difference (at least to me) from the original. As you can see from the picture only the smaller brass cap (vented) can be removed. The larger...
Forum: Early V8 (1932-53) 02-18-2014, 04:18 PM
Replies: 6
Views: 1,709
Posted By Redhorse1947
Re: Turn signals

My "turn signal knowledge" is limited but in all the cases that I have encountered the key to make all of it work was to have power to the turn signal switch and then the other lights (parking,...
Forum: Early V8 12-10-2013, 07:36 PM
Replies: 0
Views: 998
Posted By Redhorse1947
1948-1950 Ford F 1 Hood

SOLD 12/20/13
1948-1950 Ford F 1 Hood. Has some surface rust (has been in enclosed barn since 1993) but straight. Has usual metal stress breaks on each side of the nose and along the rear where the...
Forum: Early V8 12-10-2013, 04:06 PM
Replies: 0
Views: 778
Posted By Redhorse1947
1948-1950 Ford F 1 Cab

SOLD 12/20/13
1948-1950 Ford F 1 Cab. Has some surface rust (has been in enclosed barn since 1993) and bondo patches (my idea in 1993 was to fill dents rather than do the body work to straighten)....
Forum: Late V8 (1954+) 11-20-2013, 08:52 PM
Replies: 9
Views: 1,803
Posted By Redhorse1947
69 F-100 Steering Issue

I have a 1969 F-100, V8, with manual steering. It was in mothballs for a few years and now I drive it daily. My problem is that when I drive straight ahead at 60 mph I have to steer slightly to the...
Forum: Early V8 (1932-53) 11-06-2013, 05:41 PM
Replies: 2
Views: 1,142
Posted By Redhorse1947
Re: 1934 Pickup-UNKNOWN part...Help

Oh my!

Yes, yes, yes!

Thank you very much! I will label the parts before the sun sets...today!
Forum: Early V8 (1932-53) 11-06-2013, 04:24 PM
Replies: 2
Views: 1,142
Posted By Redhorse1947
1934 Pickup-UNKNOWN part...Help

The image below shows bolts I simply can not identify their intended purpose. I am nearly dead certain these belong somewhere on a 1934 pickup but where? Of all the pictures I took before...
Forum: Early V8 (1932-53) 11-05-2013, 05:59 PM
Replies: 1
Views: 1,981
Posted By Redhorse1947
1932-34 Ford Pickup Rear Window Installation

I am getting close to installing the rear glass in a 1934 pickup. I understand how it would be done the original way (leak, leak, leak) but was wondering if anyone has found a more leak proof...
Forum: Early V8 (1932-53) 10-13-2013, 12:51 PM
Replies: 38
Views: 14,643
Posted By Redhorse1947
Re: 1937 Ford transmission rebuild

I believe you will be very pleased with a Mac VanPelt rebuild. No doubt you will include the shifter housing (top cover) with your shipment. Having him check the wear of the plunger, replacing two...
Forum: Late V8 10-08-2013, 08:49 PM
Replies: 2
Views: 1,276
Posted By Redhorse1947
Re: WTB: Ford 49-53 Flathead V8 Dual 2BBL Intake

Here is a Craigslist link here in the Dallas Ft worth area...............

Good luck!

http://dallas.craigslist.org/dal/pts/4108758456.html
Forum: Late V8 (1954+) 10-02-2013, 08:27 PM
Replies: 4
Views: 1,786
Posted By Redhorse1947
Re: 1969 F100 Fuel bowl leak down

THANKS to the three members that replied to my carb leak down issue. I purchased a 1" phenolic spacer to replace the original heated carb spacer and it appears all my issues are in the rear view...
Forum: Early V8 09-30-2013, 08:45 PM
Replies: 1
Views: 923
Posted By Redhorse1947
WTB-1948-1950 F-1 Exhaust Manifold

Need RIGHT side exhaust manifold for 1948-1951 (maybe thru 1953) Ford F-1 flathead V8.
See attached pictures to determine if yours is a match.
Pictures welcome.
Dallas-Ft Worth area (Grand Prairie...
Forum: Late V8 (1954+) 09-06-2013, 10:09 AM
Replies: 4
Views: 1,786
Posted By Redhorse1947
1969 F100 Fuel bowl leak down

I am posting this for ideas on WHY my carburetor bowl “leaks down” when the engine is HOT.
Specifics: 1969 F100 360 V8 Auto Trans (I am the original owner)
2100D 2 bbl carb manual choke...
Forum: Early V8 05-30-2013, 12:44 PM
Replies: 0
Views: 1,214
Posted By Redhorse1947
1948-1950 F1 pickup bed

1948-early 1950 (raised sides) pickup bed.
No Fenders. No tailgate.
Rear pockets need replacing.
Rear cross member needs repair or replacing.
Cash only.
Forum: Early V8 (1932-53) 10-25-2012, 04:03 PM
Replies: 4
Views: 1,862
Posted By Redhorse1947
Re: 1950 F1 Stock Photos

For starters here are a few pictures. My radio is mounted under the dash and the "stock" radio/speaker blanks in the dash are body color rather than ivory. Turn signals are on the steering column but...
Forum: Early V8 (1932-53) 09-09-2012, 09:19 PM
Replies: 3
Views: 1,430
Posted By Redhorse1947
Re: Gas Tank Cleaner and How to

AFTER cleaning my F-1 tank and sealing it I still found that small pieces of "stuff" would (over time) clog up the fuel filiter and the engine would stop running. 15 years ago I found a solution. I...
Forum: Early V8 (1932-53) 08-20-2012, 12:16 PM
Replies: 5
Views: 1,544
Posted By Redhorse1947
1933/34 Pickup Firewall

Attached is a picture of a 1934 pickup firewall.

Can someone tell me WHAT the 1/2" hole I've indicated is used for?

THANKS for the comments!
Forum: Early V8 07-25-2012, 01:27 PM
Replies: 0
Views: 694
Posted By Redhorse1947
1948-early 50 FI cab & bed

Pickup bed for sale: $200 straight sides, needs rear pockets, no fenders.
(pictures attached)

Pickup cab for sale: $100 good top, firewall repaired, surface rust.
(can send pictures if...
Forum: Early V8 (1932-53) 07-25-2012, 01:13 PM
Replies: 43
Views: 17,228
Posted By Redhorse1947
Re: The Neatest Gas Station You Have Ever Seen

A couple of stations from Texas. The station with bays is in Albany and down the road is the "office only" Sinclair in Snyder, Texas.
Forum: Late V8 04-18-2012, 01:20 PM
Replies: 2
Views: 4,492
Posted By Redhorse1947
Re: Autolite 2100 carb w/manual choke

THANKS for the info about your carburetor. Sorry for the delay in replying...have been out of town visiting family.

Since posting my ad I have found a carburetor that will solve my problem. My...
Forum: Late V8 04-08-2012, 04:54 PM
Replies: 2
Views: 4,492
Posted By Redhorse1947
Autolite 2100 carb w/manual choke

Looking for a 2 bbl Autolite carb with manual choke. Several years would work (1966-1969). The air horn would need to have the vent hole in the top...NOT the solid top of some 2100's.

Does not...
Forum: Early V8 (1932-53) 02-26-2012, 09:23 PM
Replies: 16
Views: 2,909
Posted By Redhorse1947
Re: Can I bench test this ?

Concerning your gas tank..."what can I swish around in it to clean it some before filling it full of gas "...............
On my 1949 F1 I cleaned and cleaned but without warning the gas line would...
Showing results 1 to 25 of 63

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:51 AM.