Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 127
Search took 0.01 seconds.
Search: Posts Made By: lee34
Forum: Early V8 (1932-53) 03-13-2013, 10:52 PM
Replies: 11
Views: 1,522
Posted By lee34
Re: JB Weld penny for heat riser block offs?

RE Penny block off . You have to use old penny the new penny is not penny is made cheaper and not as good, [ like a lot of new parts} l l Lee34
Forum: Early V8 (1932-53) 12-25-2012, 04:29 AM
Replies: 12
Views: 2,729
Posted By lee34
Re: 33/34 dips in cowl for hood support.

The cowl (dents) are much more noticeable than I see in your pics 33 Ford had flared place on the radiator.In the same area the 33 did not have a screen in the cowl vent.The screen was approved for...
Forum: Early V8 (1932-53) 12-22-2012, 11:46 PM
Replies: 16
Views: 2,636
Posted By lee34
Re: Open driveline phasing ?

There are some vehicles that have independent rear suspension that use 2 u joints for each axle plus u joints on the drive shaft.(Total of 6) Each u joint can be installed 180 degrees off. when...
Forum: Early V8 (1932-53) 12-16-2012, 11:34 PM
Replies: 7
Views: 1,616
Posted By lee34
Re: 40 wheel out of round who repairs this? KY

L78
There is a very good place in Louisville.They shaved my tires on the car..My wheel was a spoke wheel .They also balance your tire on the car (do not remove hub cap or any thing)They balance and...
Forum: Early V8 (1932-53) 09-10-2012, 10:47 PM
Replies: 4
Views: 1,062
Posted By lee34
Re: 1933 vs 1934 Front Bumpers

The 2 inner holes on 33 are 22 in apart and 34 are 26 in apart .They can be used on both years if same year brackets and bumpers are used together (not correct for year for restoration) Lee34
Forum: Early V8 (1932-53) 07-27-2012, 09:58 PM
Replies: 19
Views: 2,586
Posted By lee34
Re: Head lites

The reflectors that Drakes sell (possible others) are different than original.The problem seams to be worse with the h4 type bulbs.They are bright enough just not focused.I purchased the kit from...
Forum: Early V8 (1932-53) 07-26-2012, 10:05 PM
Replies: 19
Views: 2,586
Posted By lee34
Re: Head lites

I had a 34 sedan with original lense and h4 bulb with same symptoms,I purchased Drakes
reflector kit and now I can see I no longer have to use Braille to drive at night Try to explain to your...
Forum: Early V8 (1932-53) 07-12-2012, 03:47 AM
Replies: 8
Views: 2,826
Posted By lee34
Re: Loud turn signal flasher

Jim;You can get one from RON FRANCIS WIRING 800-292-1940 www.ronfrancis.com Simple hook up.2 wires.Does not even need to be grounded.A little on the loud side.I am sure there are others out there...
Forum: Early V8 (1932-53) 07-05-2012, 09:39 PM
Replies: 349
Views: 108,079
Posted By lee34
Re: Please post pictures of 1933-1934's here

Owned this car for 52 years...Think I'll keep it...only owe one more payment..LOL!
Lee34
Forum: Early V8 (1932-53) 06-09-2012, 11:09 PM
Replies: 13
Views: 1,703
Posted By lee34
Re: POOR Brake Lights ~ Thought I Fixed Them ~ HELP!

Have you checked to see if the running lights and brake lights are switched so the proper element is not receiving voltage as needed ? lee34
Forum: Early V8 (1932-53) 06-09-2012, 10:57 PM
Replies: 18
Views: 3,584
Posted By lee34
Re: 1934 repo bumpers.

The original 33 & 34 bumpers had a ( 0 ) stamped on the back side. sometimes only a partial of the 0 made contact leaving a ( c ) . Both of mine are stamped on the left side (while looking at...
Forum: Early V8 (1932-53) 04-25-2012, 08:35 PM
Replies: 8
Views: 1,310
Posted By lee34
Re: Who Knows Potter Trunks ?

Your trunk may be a trunk that was made to go on top of a luggage rack.There was several different manufactures for the trunks.In 1934 the Potter trunk was was the only one authorized by Ford.Later...
Forum: Early V8 (1932-53) 03-09-2012, 11:16 PM
Replies: 7
Views: 1,279
Posted By lee34
Re: 33 or 34 cowls

The 34 has a notch on top of the cowl for the hood to be held when open and 33 do not,34 has a screen in the vent and the 33 does not.If the dash is still attached all the gauge are mounted to a...
Forum: Early V8 (1932-53) 02-25-2012, 11:12 PM
Replies: 10
Views: 1,331
Posted By lee34
Re: Help on noise please

fREDERICK Checking a cylinder by pulling a plug wire off can cause damage to electronic ignition components .You can use a plug wire that is pulled off and attach it to a plug touching the motor...
Forum: Early V8 (1932-53) 02-22-2012, 11:39 PM
Replies: 2
Views: 796
Posted By lee34
Re: Drake grill fitment? Need to know

Like alchemy stated they all seam to be different Look at the tie bar at the bottom ,most are not uniform lee34
Forum: Early V8 (1932-53) 02-19-2012, 11:25 AM
Replies: 17
Views: 1,691
Posted By lee34
Re: 34 question

Could this be Fords answer to Chevy wing ? Lee34
Forum: Early V8 (1932-53) 02-19-2012, 11:19 AM
Replies: 6
Views: 866
Posted By lee34
Re: Ford headlight rings...help identify please!

Notice how every thing on e bay fits 34 Ford (0r it says so) Lee34
Forum: Early V8 (1932-53) 02-19-2012, 11:10 AM
Replies: 9
Views: 2,124
Posted By lee34
Re: Coker wheels

I have vintiques dual pattern for 10 years.Mine are tubeless and they are spoke type.Had some trouble with leaks at the rim spoke area sealing.Found the cause was porosity in the sealer to seal the...
Forum: Early V8 (1932-53) 02-13-2012, 11:04 PM
Replies: 14
Views: 1,681
Posted By lee34
Re: Pilot bearing removal?

On the extra tight bushing tap threads in the bushing take a bolt with the first part of the threads removed,screw the bolt in and push the bushing out.Try the grease method first.lee34
Forum: Early V8 (1932-53) 02-13-2012, 10:50 PM
Replies: 54
Views: 5,753
Posted By lee34
Re: Lets Be Honest.....

Shadetree;How about curb feelers,port-a-walls,49 Plymouth bumpers,drag pipes made from gas tank filler necks (just twist off the cap and you bypassed the smittys),chrome covers for your motor...
Forum: Early V8 (1932-53) 02-11-2012, 03:13 PM
Replies: 4
Views: 1,071
Posted By lee34
Re: Vin number 34 Tudor

Rod; there is another location on the frame on the kick up portion. There is a very good book that every 33/34 owner should own.wealth of information.There is one chapter dealing with frame...
Forum: Early V8 (1932-53) 02-09-2012, 11:53 PM
Replies: 10
Views: 1,023
Posted By lee34
Re: Help 34 help

ken;I used some small black pop rivets.Make sure whatever you use is below the surface of the fuzzy material or you will end up with scratches on your glass. Worked for me Lee34
Forum: Early V8 (1932-53) 02-09-2012, 11:34 PM
Replies: 7
Views: 1,197
Posted By lee34
Re: Vin number 34 Sedan

All assembly locations were supposed to stamp the frame number following a star and 18 >Some locations did not stamp as instructed .Some assembly plants stamped only the star
,.Some were stamped...
Forum: Early V8 (1932-53) 01-29-2012, 07:04 PM
Replies: 9
Views: 9,115
Posted By lee34
Re: 1934 Ford Installing New Top Insert

Bobh;I just used the material and went by the direction provided by Julianos .You also have to form the 4 corners plus the slight curves on the sides.At the time I installed the top this was all that...
Forum: Early V8 (1932-53) 01-28-2012, 11:58 PM
Replies: 9
Views: 9,115
Posted By lee34
Re: 1934 Ford Installing New Top Insert

Installed mine from Julianos .After 10years no leaks ,easy to follow directions ,Some wind noise Lee34
Showing results 1 to 25 of 127

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:43 PM.