Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 122
Search took 0.01 seconds.
Search: Posts Made By: tonydennisadw
Forum: Early V8 (1932-53) 05-13-2020, 05:13 AM
Replies: 11
Views: 335
Posted By tonydennisadw
Re: 1952 ford car clutch install

A bones a friend put the clutch in who is very familiar with ford clutches he has a 53 truck i suspect the pressure plate surface surface was not cleaned if not will it wear off
Forum: Early V8 (1932-53) 05-13-2020, 04:58 AM
Replies: 11
Views: 335
Posted By tonydennisadw
Re: 1952 ford car clutch install

thanks all were working on it...... one thing when i took the pressure plate out of the box and saw the fingers i thought those dont look good poor casting or machining to me clutch and...
Forum: Early V8 (1932-53) 05-11-2020, 03:32 PM
Replies: 11
Views: 335
Posted By tonydennisadw
Re: 1952 ford car clutch install

there was absolutely 0 chatter on old clutch motor mounts were replaced about 4 years ago when replaced w pumps flywheel was not burnt in spots and no cracks so did not resurface.......wish i had...
Forum: Early V8 (1932-53) 05-11-2020, 02:57 PM
Replies: 11
Views: 335
Posted By tonydennisadw
1952 ford car clutch install

clutch pp and throw out bearing prior clutch engaging pretty far out 1still engaging far out at what inch from floor should it engage my manual doesnt say and how to adjust 2 clutch...
Forum: Early V8 (1932-53) 10-25-2019, 09:42 AM
Replies: 4
Views: 388
Posted By tonydennisadw
Re: 1952 ford customline

chiefdave thanks dennis
Forum: Early V8 (1932-53) 10-24-2019, 12:50 PM
Replies: 4
Views: 388
Posted By tonydennisadw
1952 ford customline

1952 ford stick transmission and rear end what value oil /grease do they take dennis,,,,, ive been told 80/90 .... others said 140
Forum: Early V8 (1932-53) 09-28-2019, 03:18 PM
Replies: 17
Views: 665
Posted By tonydennisadw
Re: 1952 customline gas gauge reads near full

the irony of this whole durn thing is when you purchase these new senders after market they say on instructions FOR ORIGINAL GAUGES AND TANKS ONLY....................i am on num 6 and not buying...
Forum: Early V8 (1932-53) 09-28-2019, 03:10 PM
Replies: 17
Views: 665
Posted By tonydennisadw
Re: 1952 customline gas gauge reads near full

19Fordy and all interested put a 25 ohm r in and read just above 1/4 the 25 was a variable resister set for 25 since i had a 10 ohm ordered waited for it put in today and it reads about...
Forum: Early V8 (1932-53) 09-25-2019, 09:11 PM
Replies: 17
Views: 665
Posted By tonydennisadw
Forum: Early V8 (1932-53) 09-24-2019, 02:32 PM
Replies: 17
Views: 665
Posted By tonydennisadw
Re: 1952 customline gas gauge reads near full

jseery thanks ill work on that just ordered 2 diff value resistors would be nice to know when on empty
Forum: Early V8 (1932-53) 09-24-2019, 12:19 PM
Replies: 17
Views: 665
Posted By tonydennisadw
Re: 1952 customline gas gauge reads near full

thanks 19 fordy for the info and thanks again too all of the guys think ill go back to 60 some years ago way stick in gas fill haha Dennis
Forum: Early V8 (1932-53) 09-24-2019, 07:55 AM
Replies: 17
Views: 665
Posted By tonydennisadw
Re: 1952 customline gas gauge reads near full

was suggested to put a resister inline 50 ohms put one in and read real low was suggested to put a lower ohms resis in,,, working on that now but my question is what should the resistor wattage be or...
Forum: Early V8 (1932-53) 09-23-2019, 08:26 PM
Replies: 17
Views: 665
Posted By tonydennisadw
1952 customline gas gauge reads near full

fifth tank sender think said had new resistance style still reading high close to full,,,,,,battry reads 6.30v,,, at sender reads 6.30v, when read through sender when hooked up see 3.5v any...
Forum: Early V8 (1932-53) 04-26-2019, 04:18 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

Anteek29 tried a 50 ohm 10 watt resister put in where wire connects at left tail light area ????? gauge went from E to about 1/4 E extremely slow with tank being pretty full was yours a...
Forum: Early V8 (1932-53) 03-27-2019, 03:19 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

perhaps the op keeps doing open ended replays because he is 80 with beginning dementia and loves his cars and still trys working on em ... so with that this will be my last post to ford barn if i...
Forum: Early V8 (1932-53) 03-25-2019, 08:02 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

the one i took out ooked like very sme manufacture and worked for a coule years
Forum: Early V8 (1932-53) 03-25-2019, 12:19 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

JSeery gauge stays on full when not full test manually gauge will go from full to to low so works not installed took a voltage reading at battery battery is 6.5volts took a reading...
Forum: Early V8 (1932-53) 03-24-2019, 09:43 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

well here i am again hooked existing wires up... tested apart from tank seemed to work fine {fuel sending unit } put it in tank reads full then tested voltage again to it reads about 4 volts ...
Forum: Early V8 (1932-53) 03-15-2019, 09:23 AM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

well finally warmed up a bit.....put new gauge in went to full stayed there took out hooked up outside tank float in down position showed empty half pos showed app half all way up showed...
Forum: Early V8 (1932-53) 02-28-2019, 07:07 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
Re: 1952 ford customline fuel sending unit

ok tnx back to extreme cold here in ohio so a waiting game again
Forum: Early V8 (1932-53) 02-28-2019, 01:49 PM
Replies: 23
Views: 1,601
Posted By tonydennisadw
1952 ford customline fuel sending unit

this is the 5th fuel ,,,, sender ive put on none work correct i wired it same as original wire from gauge to center wire from frame to frame or screw to tanlk ive read these aftermarket...
Forum: Early V8 (1932-53) 11-22-2018, 10:55 AM
Replies: 16
Views: 1,572
Posted By tonydennisadw
Re: 6v fuel pump for carb draining....

flathead fever well this is the 3rd carb on there and still drains however i have another 52 flattie that has sat for at least a month and always starts right away.....dennis
Forum: Early V8 (1932-53) 11-19-2018, 10:08 PM
Replies: 16
Views: 1,572
Posted By tonydennisadw
Re: 6v fuel pump for carb draining....

fortyonerag primer only runs great when fills up ok mfirth too cold now to fool with it soon as gets in 50ties with sun can handle it this engine runs cool unless extreme heat like last summer...
Forum: Early V8 (1932-53) 11-19-2018, 07:07 AM
Replies: 16
Views: 1,572
Posted By tonydennisadw
Re: 6v fuel pump for carb draining....

thanks to all for help and Pat/ohio we have had a trailer in wilmington at kirkwood for over 40 years i am in cincinnati east the car is 52 ford flathead is 3rd carb ive tried think this one...
Forum: Early V8 (1932-53) 11-16-2018, 03:59 PM
Replies: 16
Views: 1,572
Posted By tonydennisadw
6v fuel pump for carb draining....

still cant fig out why carb drains so heres my ? got a 6 v ele fuel pump low volume will it work ok if i put it next to fuel pump this old man will prob have gas everywhere if i try to hook...
Showing results 1 to 25 of 122

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:40 AM.