Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: Zax40
Forum: Early V8 (1932-53) 06-19-2019, 08:11 AM
Replies: 17
Views: 3,122
Posted By Zax40
Re: Fuel pump stand with small pinholes usable?

Yeah, that's the one. I measured just the cast part and it's right around 3 inches tall. I think between the two I could make one good one. I'll send you a private message.

Thanks
Forum: Early V8 (1932-53) 06-18-2019, 08:29 AM
Replies: 17
Views: 3,122
Posted By Zax40
Re: Fuel pump stand with small pinholes usable?

Thanks, i'll measure it today when I get home from work.
Forum: Early V8 (1932-53) 06-17-2019, 10:53 AM
Replies: 17
Views: 3,122
Posted By Zax40
Re: Fuel pump stand with small pinholes usable?

That would be fantastic! It's right at 4 3/4 from the base where it bolts to the intake to the top of the tube where the breather goes. Looks like the one in the link below.
...
Forum: Early V8 (1932-53) 06-17-2019, 08:51 AM
Replies: 17
Views: 3,122
Posted By Zax40
Re: Fuel pump stand with small pinholes usable?

I thought about that, but didn't know how it would hold up to the heat inside the engine.
Forum: Early V8 (1932-53) 06-17-2019, 08:12 AM
Replies: 17
Views: 3,122
Posted By Zax40
Fuel pump stand with small pinholes usable?

My fuel pump stand has some pitting and a few tiny pin holes in the steel tube that goes down into the intake. It was lightly media blasted. The metal is still solid, but will the small holes be a...
Showing results 1 to 5 of 5

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:35 PM.