Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: Terry,OH
Forum: Early V8 (1932-53) Today, 05:55 AM
Replies: 7
Views: 353
Posted By Terry,OH
Re: Need to replace oxy-acetylene torch set

I have the jewelers torch from Mico and the slightly larger torch also Mico. Like them both. I too vote for a rebuild of your existing equipment. Maybe new tips will help performance.
Forum: Early V8 (1932-53) 10-14-2019, 08:59 AM
Replies: 12
Views: 290
Posted By Terry,OH
Re: 1940 "standard" Fordor dome lamp(s)

The salesmans manual page 11 reads: Rear compartment lamps in the two Sedans are located on the door pillars with switch on the right-hand side.
Forum: Early V8 (1932-53) 10-14-2019, 06:39 AM
Replies: 16
Views: 603
Posted By Terry,OH
Re: Hershey on the West Coast

Hershey, in size, is unique. There are some large swaps on the west coast.
Forum: Early V8 (1932-53) 10-14-2019, 05:19 AM
Replies: 14
Views: 358
Posted By Terry,OH
Re: 36 fuel pump flare fittings leaking...

The early glass bowl fuel pumps used fittings with brass ferrells as did all the early V8 Ford pumps prior to the war. The later style have NPT threads. I am not aware of any flare fittings
Forum: Early V8 (1932-53) 10-12-2019, 06:09 PM
Replies: 15
Views: 550
Posted By Terry,OH
Re: 35 transmission

The guys below are correct 35 is slanted and 36 is straight
Forum: Early V8 (1932-53) 10-11-2019, 05:44 AM
Replies: 10
Views: 360
Posted By Terry,OH
Re: 1940 Deluxe condenser help

The vertical one is the ignition condenser the horizontal one is radio interference suppression. The ignition condenser is an aftermarket style. The original style does not use a metal arm going to...
Forum: Early V8 (1932-53) 10-10-2019, 07:08 AM
Replies: 16
Views: 421
Posted By Terry,OH
Re: 32 Cabriolet repro parts?

Are the 32 Cabriolet window frames the same as the 33-34? I know the 35 through late 30's are the same but wider than 33-34.
Forum: Early V8 (1932-53) 10-06-2019, 05:30 AM
Replies: 8
Views: 346
Posted By Terry,OH
Re: First 2 speed axles

You may want to ask on the Model T form.
Forum: Early V8 (1932-53) 10-05-2019, 06:28 AM
Replies: 17
Views: 404
Posted By Terry,OH
Re: 36 Ford steering box question

The leak at the light switch is usually fixed by removing the tube 40-3597 and soldering the tube to it's mounting plate. If the leak is at the sector and pitman arm the sector shaft seal in the...
Forum: Early V8 (1932-53) 10-05-2019, 06:15 AM
Replies: 51
Views: 826
Posted By Terry,OH
Re: 36 Ford drag link orientation question

The drag link should go to the RH wheel and it's steering arm with the adjuster near the wheel.
Forum: Early V8 (1932-53) 10-04-2019, 11:05 AM
Replies: 8
Views: 608
Posted By Terry,OH
Forum: Early V8 (1932-53) 10-02-2019, 03:37 PM
Replies: 8
Views: 608
Posted By Terry,OH
Re: Another "load-a-matic" day at bubbas.....

Bubba could you post a photo of just the lead wire?? I wonder what the two ends look like.
Forum: Early V8 (1932-53) 10-02-2019, 03:34 PM
Replies: 14
Views: 621
Posted By Terry,OH
Re: Cutting domes in 21 stud aluminum heads?

Seen it done and there was not enough meat at all four positions. It can be done with flat cast iron heads.
Forum: Early V8 (1932-53) 09-30-2019, 05:52 AM
Replies: 7
Views: 320
Posted By Terry,OH
Re: A Couple 36 Fordor Questions

This is the accessory 36 horn. The shock fill plugs are up and the rear shock body is inside the frame with the arm on the outside.
Forum: Early V8 (1932-53) 09-25-2019, 06:54 AM
Replies: 3
Views: 292
Posted By Terry,OH
Re: insulated wire

Most likely came out of a multi conductor cable. Insulation got deformed in the bundling of the wires to form a cable.
Forum: Early V8 (1932-53) 09-21-2019, 06:55 AM
Replies: 16
Views: 357
Posted By Terry,OH
Re: 1940 Ford deluxe help with a speaker grill problem

There are two slightly different speaker grills, one is early. One of the difference is the location of the mounting pins. If you have your old grill, that fits, check it out.
Forum: Early V8 (1932-53) 09-21-2019, 06:46 AM
Replies: 9
Views: 344
Posted By Terry,OH
Re: 35 intake manifold

There are at least two intakes for 35 below are pictures of both. The early style, was used for a couple of months, it has the smooth edges on the sides where it bolts to the engine bolck. as well...
Forum: Early V8 (1932-53) 09-20-2019, 08:10 AM
Replies: 6
Views: 332
Posted By Terry,OH
Re: Wiper Motor Mtg. Hardware needed....

Try Ficken or another rebuilder.
Forum: Early V8 (1932-53) 09-20-2019, 08:05 AM
Replies: 16
Views: 615
Posted By Terry,OH
Re: Ol man thinkin & seeking to learn

Condensers do not all act alike. Some go bad slowly, some suddenly. Engine heat and cold cycles and electrical use take a toll on the materials inside the capacitor. Best to change to a new...
Forum: Early V8 (1932-53) 09-13-2019, 08:09 AM
Replies: 4
Views: 217
Posted By Terry,OH
Re: 1936 cabriolet package tray support

The steel pieces were sold by Lebaron Bonney before they closed so there is a source somewhere.
Forum: Early V8 (1932-53) 09-13-2019, 06:40 AM
Replies: 27
Views: 1,069
Posted By Terry,OH
Re: 6V generator

Did you add oil to the rear bushing through the oil cup? What year is the generator?
Forum: Early V8 (1932-53) 09-13-2019, 06:36 AM
Replies: 21
Views: 1,007
Posted By Terry,OH
Re: need your help

If "Ford V8 1939, black" is already on the papers ask them to include the vehicle serial number as it is on your frame.
In the USA that is usually all the information that appears on papers. Many...
Forum: Early V8 (1932-53) 09-12-2019, 05:48 AM
Replies: 4
Views: 217
Posted By Terry,OH
Re: 1936 cabriolet package tray support

Are these the pieces you reference?
Forum: Early V8 (1932-53) 09-08-2019, 07:56 AM
Replies: 23
Views: 824
Posted By Terry,OH
Re: Trany Problems

Yes I believe you have it Glenn!

In the photo with the screwdriver you can clearly see how much the syncro hub has moved away from the 2nd gear so the syncro sleeve does not uncover the syncro...
Forum: Early V8 (1932-53) 09-07-2019, 07:03 AM
Replies: 23
Views: 824
Posted By Terry,OH
Re: Trany Problems

Anyone have the link to the posting a couple of months ago?? Fellow had the same problem lots of photos and link to his posting on the HAMB. I have searched without luck.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:01 PM.