The Ford Barn
FordBarn.com
The Forum
Swap
About
Register
Calendar
Community
Today's Posts
Search
FAQ
The Ford Barn
>
Search Forums
Search Results
User Name
Remember Me?
Password
Community Links
Members List
Search Forums
Show Threads
Show Posts
Advanced Search
Go to Page...
Sponsored Links (Register now to hide all advertisements)
Showing results 1 to 23 of 23
Search took
0.00
seconds.
Search:
Posts Made By:
nemw001
Forum:
Early V8 (1932-53)
09-07-2011, 01:04 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Thank you all for the help - many minds = many outlooks on same issue - sometimes we all develop tunnel vision and need a new perspective - again -Thanks.
Forum:
Early V8 (1932-53)
09-07-2011, 11:39 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Had timing cover off, so lined up timing marks on the cam / crank gears - then pulled #1 and #6 plugs to be sure that valves were closed, precautionary move, the "wider" part of distributor drive...
Forum:
Early V8 (1932-53)
09-07-2011, 10:59 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Thanks -
Forum:
Early V8 (1932-53)
09-07-2011, 10:18 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I do not think it should be a problem, but a stupid question asked is better than one not asked that causes heartache and headaches, does it matter if condenser is grounded to the ditributor mounting...
Forum:
Early V8 (1932-53)
09-07-2011, 09:48 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Thanks - checked condenser connections - good, clean, and tight.
Forum:
Early V8 (1932-53)
09-07-2011, 09:45 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Update -- took of muffler and no change - took off timing cover and barred engine over to check actual timing mark alignment, they are right on - it has a fiber cam gear and no teeth were missing and...
Forum:
Early V8 (1932-53)
09-07-2011, 09:11 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I never took dist apart, I presummed that it was OK - I did notice the intermittent spark that was a result of a bad condenser it appears - so I replaced that but as you know did not have to tamper...
Forum:
Early V8 (1932-53)
09-07-2011, 09:08 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I did try starting fluid - and still got the popping thru carb - I even tried raw fuel down carb left choke open, and put fuel pedal to floor with the same reults.
Forum:
Early V8 (1932-53)
09-07-2011, 09:05 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Car was starting and running fine - then - started to be hard to start and would start and run BUT then when warm would not start - SO I checked for fuel, air, spark and there was NO spark at all...
Forum:
Early V8 (1932-53)
09-06-2011, 05:53 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I am going to take off the timing cover and check for gear alignment or some other issue behind it - will keep all posted.
Forum:
Early V8 (1932-53)
09-06-2011, 05:51 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
took off muffler and cranked it - still justthe backfiring.
Forum:
Early V8 (1932-53)
09-06-2011, 12:43 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Thanks George - I will check it - this distributor was just done by VanPelts so I ASSummed it was fine - but ya never know -- where you at in Mid-Coast area? I am in Warren.
Forum:
Early V8 (1932-53)
09-06-2011, 12:37 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Took off muffler and tried to start - same deal - no start and backfiring out of the carburetor - I am going to order caps, inner and outer, and wires. - will update after install them hopefully by...
Forum:
Early V8 (1932-53)
09-06-2011, 11:31 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I am going to disconnect exhaust at the manifold and try to start it and see what happens. I held my hand over tailpipe to check and see if there was pressure there, and seemed to be ok. However, no...
Forum:
Early V8 (1932-53)
09-06-2011, 11:30 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I did verify firing order using VanPelts diagram, I took caps apart and checked them, saw no sign of arcing. I ohm checked the wires with loom and cap attached off car and they were all like 2 or so...
Forum:
Early V8 (1932-53)
09-06-2011, 11:26 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
This car has an off-set keyway that wont allow for the distributor to be put on 180 out - If you try to do that you would crack the distributor housing I do believe. - Spark at each plug wire is blue...
Forum:
Early V8 (1932-53)
09-06-2011, 10:33 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I did test voltage at coil with all wriing hooked up, it was 2.5 - 3ish volts - I took wire right off of coil and ran straght 6v to it while cranking - still just backfiring - I then had someone...
Forum:
Early V8 (1932-53)
09-06-2011, 10:31 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I did put distributor in vise last week, hooked up 6v to it and rotated by hand, there was an intermittent spark - I swapped out the condenser with one I had on hand and that gave me a good strong...
Forum:
Early V8 (1932-53)
09-06-2011, 10:28 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
I poured a 1/2 cup af raw gas right down the carb held the fuel pedal to the floor and cranked - and just the backfiring - would not fire off until fuel was exhausted as you would expect it to do if...
Forum:
Early V8 (1932-53)
09-06-2011, 09:13 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Update - I disconnected the coil feed wire from switch and ran 6v temporarily to coil off of battery with a jumper wire and cranked - still no start - there is 2.5 - 3v feeding coil with switch on. I...
Forum:
Early V8 (1932-53)
08-30-2011, 04:56 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
One thing I again forgot to mention is that when I take the plugs out, which I do after trying a few things to check them, they are never WET and show no signs of the dreaded blackness associated...
Forum:
Early V8 (1932-53)
08-30-2011, 04:52 PM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
Re: 1937 No start
Thanks all - here is an update - I should have included this with initial post - but I didnt want to have too big a post - I had already removed plugs and watched valaves for proper operation, none...
Forum:
Early V8 (1932-53)
08-30-2011, 11:06 AM
Replies:
219
1937 No start
Views:
51,160
Posted By
nemw001
1937 No start
Hello all - I am currently working on a 1937 Ford - it came into my shop as a crank-no start - it had no spark - I sent the distributor which was original out to be refurbished at VanPelts, had a...
Showing results 1 to 23 of 23
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
General Discussion
Model T (1909-1927)
Model A (1928-31)
Early V8 (1932-53)
Late V8 (1954+)
Hot Rods & Customs
The Swap Meet
For Sale
Model-T
Model-A
Early V8
Late V8
The Jalopy Auction House
To The Editors
Questions & Suggestions
The Test Forum
The Archives
Model-T
Model-A
Early V8
Late V8
Sponsored Links (Register now to hide all advertisements)
All times are GMT -5. The time now is
05:34 PM
.