Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: steward614
Forum: Model A (1928-31) 06-14-2016, 09:36 AM
Replies: 23
Views: 3,573
Posted By steward614
Re: Zenith rebuilt. No power past 40mph

Also I noticed there is a small bit of play in the throttle shaft. However does not effect idle so I didnt think it would impact high end speed performance.
Forum: Model A (1928-31) 06-14-2016, 09:25 AM
Replies: 23
Views: 3,573
Posted By steward614
Re: Zenith rebuilt. No power past 40mph

Morning-I used the heated ultrasonic and each passage was blown out with 70psi of steam (a steam boiler we use in the Jewelry industry which has a fine tip outlet) and yes all jets were removed,...
Forum: Model A (1928-31) 06-13-2016, 08:26 PM
Replies: 23
Views: 3,573
Posted By steward614
Re: Zenith rebuilt. No power past 40mph

Mr Miller, good point. I recently replaced dist., points and cap and button. All adjusted to spec along with TDC of #1 on contact. Let me let her cool off tonight and Ill check the timing.
Forum: Model A (1928-31) 06-13-2016, 08:18 PM
Replies: 23
Views: 3,573
Posted By steward614
Re: Zenith rebuilt. No power past 40mph

Mitch- I read the attached link to the main jet artificial on rebuilding. Appears to address my issues with high speed power. Without flow testing I am left with purchasing calibrated jets. I didnt...
Forum: Model A (1928-31) 06-13-2016, 08:13 PM
Replies: 23
Views: 3,573
Posted By steward614
Re: Zenith rebuilt. No power past 40mph

Utopia- I did turn the GAV open up-to two turns then back down to damn near off. Not a substantial change. All while running 40mph made an impact when open, some popping.
Forum: Model A (1928-31) 06-13-2016, 07:31 PM
Replies: 23
Views: 3,573
Posted By steward614
Zenith rebuilt. No power past 40mph

Greetings. I am a jewelry who used my ultrasonic and steam generator to clean and inspect (10x magnification) a few old zenith carbs, pieces and parts to make two good units. The two run really well,...
Showing results 1 to 6 of 6

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:34 AM.