Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: steve tansy
Forum: Early V8 (1932-53) 06-23-2014, 06:09 PM
Replies: 218
Views: 119,961
Posted By steve tansy
Re: Boring a flathead

THANKS, Martin, sorry for the mix up on my end your right .125 less than from .179 is .1054 4 inch stroke right on.Thanks again you have help me veary much .Steve
Forum: Early V8 (1932-53) 06-23-2014, 04:19 PM
Replies: 218
Views: 119,961
Posted By steve tansy
Re: Boring a flathead

yes, that is what ron said to do i understand this i my problem right know i have not disassembled my engine i was hoping someone out there could please measure a 239 piston for me from middle of...
Forum: Early V8 (1932-53) 06-23-2014, 09:28 AM
Replies: 218
Views: 119,961
Posted By steve tansy
Re: Boring a flathead

thanks, i thought that it could be done on engine likes the engine is not tore down, do you have a measurement from a 239 stock piston that you could give me from the center of wrist pin the top...
Forum: Early V8 (1932-53) 06-23-2014, 12:19 AM
Replies: 218
Views: 119,961
Posted By steve tansy
Re: Boring a flathead

i have purchased a set of 3 3/8 pistons the seller says their fore inch stroke they check out 3 3/8,but not sure if they are for my 4 inch crank can you please help my engine has not been tore down...
Forum: Early V8 11-28-2011, 01:54 AM
Replies: 1
Views: 1,398
Posted By steve tansy
Re: Ford Flathead Fan & Bracket

rog, will take it will send money order to you send info on total cost to steve . [email protected] will forward information on shipping Steve Tansy
Showing results 1 to 5 of 5

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:49 PM.