Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: koates
Forum: Early V8 (1932-53) 12-16-2023, 11:39 PM
Replies: 13
Views: 1,101
Posted By koates
Re: Led Bulbs

Yes I have used them in my 34 Ford 6volt system. The dash and park lamps are good. But the headlamps throw the light around all over the place and are very bright, but are rather voltage sensitive....
Forum: Early V8 (1932-53) 12-16-2023, 06:57 PM
Replies: 13
Views: 1,101
Posted By koates
Re: Led Bulbs

Classic and Vintage Bulbs in Blackwood,, 5051, South Australia. Anthony Pearson. 08 82784393.. They have a website. Regards, Kevin.
Forum: Early V8 (1932-53) 12-12-2023, 06:49 PM
Replies: 25
Views: 2,334
Posted By koates
Re: Ford Rear Brake Drum repair

You should also have a close inspection of the female taper inside the hub to make sure it is not worn. It must fit the axle taper precisely. Also measure across the drum braking surface to make...
Forum: Early V8 (1932-53) 12-11-2023, 06:45 PM
Replies: 51
Views: 2,852
Posted By koates
Re: Remember Pearl Harbor

Many nations pulled together to defeat the Nazis and the Japs, but I acknowledge the Americans did the heavy lifting and massive supply of their fantastic equipment. Lest we forget their great...
Forum: Early V8 (1932-53) 12-11-2023, 06:28 PM
Replies: 80
Views: 5,798
Posted By koates
Re: Jim Linder aka Bubba

Another very knowledgeable bloke gone. RIP Bubba.
Forum: Early V8 (1932-53) 11-02-2023, 06:42 PM
Replies: 10
Views: 963
Posted By koates
Re: Starter Locking Up

This sort of symptom can happen if your battery is weak and only able to rotate the starter enough to engage the ring gear but not enough power to rotate or crank the engine. Have your battery LOAD...
Forum: Early V8 (1932-53) 11-02-2023, 06:33 PM
Replies: 4
Views: 720
Posted By koates
Re: 6V vs 12V Starter Solenoid

The voltage coil inside a 6 volt solenoid is designed to operate on 6 volts but will operate on 12 volts but will draw twice the current (amps) which is not good. This could eventually be the demise...
Forum: Early V8 (1932-53) 11-02-2023, 06:19 PM
Replies: 22
Views: 1,447
Posted By koates
Re: '32 Tudor Sedan Questions

Buy yourself a reprint copy of the original Ford owners handbook which will give you much information. It came with the car when it was new. Regards, Kevin.
Forum: Early V8 (1932-53) 10-19-2023, 05:20 PM
Replies: 30
Views: 2,073
Posted By koates
Re: Stp.

STP will not stop the leaks in an early ford steering box, but might slow it down a little. John Deer corn head grease will fix most of it but there is no substitute for repairing the box properly. ...
Forum: Early V8 (1932-53) 10-16-2023, 02:03 AM
Replies: 3
Views: 564
Posted By koates
Re: Looking for help with Generator and Regulator in the San Fernando Valley

All you need to do initially is test the voltage across the battery or at the battery terminal of the voltage regulator. The engine needs to be running at quite a bit above idle speed to read the...
Forum: Early V8 (1932-53) 10-16-2023, 01:17 AM
Replies: 14
Views: 1,169
Posted By koates
Re: Anybody running a helmet distributor w/o vacuum?

I run my stock 34 Ford original engine with about 3 or four threads showing on the tension bolt beyond the lock nut. That is about the original factory setting for the helmet distributor. I also set...
Forum: Early V8 (1932-53) 09-29-2023, 08:12 AM
Replies: 11
Views: 1,183
Posted By koates
Re: Stromberg 97

A vacuum leak in the intake manifold somewhere. Too much air getting in and a lean mixture is the result. Thats why you have to choke it. Use a vacuum gauge to check this or spray around the intake...
Forum: Early V8 (1932-53) 09-07-2023, 07:27 PM
Replies: 10
Views: 864
Posted By koates
Re: Hood ornament

I would really like some proof that in 1936 that Ford motor company offered a greyhound mascot. It would not be a radiator cap as the 36 cap is under the hood. I have never ever seen an actual 1935...
Forum: Early V8 (1932-53) 09-02-2023, 02:20 AM
Replies: 4
Views: 386
Posted By koates
Re: 1932 Ford Radio suppresion

I have suppressors fitted on each spark plug on my original 1934 Ford V8. They are required to eliminate the RF (radio frequency noise) in my original glove box radio and work fine without any...
Forum: Early V8 (1932-53) 08-27-2023, 09:12 PM
Replies: 18
Views: 1,225
Posted By koates
Re: Best wheel bearings:

I purchased two new rear wheel bearings for my 1934 Ford and turned out that they were made in Germany and the end plates on the bearing cages were not hardened at all just soft steel. This is not...
Forum: Early V8 (1932-53) 08-24-2023, 02:15 AM
Replies: 12
Views: 1,087
Posted By koates
Re: Battery?

A fairly common issue with 1932-34 Fords is the foot starter switch where the internal copper contacts can become worn and burnt causing a bad connection to the starter. You must push down really...
Forum: Early V8 (1932-53) 08-22-2023, 06:59 PM
Replies: 8
Views: 596
Posted By koates
Re: Help me ID this Ford emblem

1934 Ford passenger car. Regards, Kevin.
Forum: Early V8 (1932-53) 08-21-2023, 08:07 PM
Replies: 8
Views: 463
Posted By koates
Re: 48-50 F1 headlight switch glass fuse help 6v

Yes, Yes we all know it should have circuit breakers as originally fitted but it has a new non original wiring kit fitted and all he wanted to know was the value of the fuse on the replacement...
Forum: Early V8 (1932-53) 08-21-2023, 04:37 AM
Replies: 8
Views: 463
Posted By koates
Re: 48-50 F1 headlight switch glass fuse help 6v

The fuse on your aftermarket switch would only power all of your lights so as long as all your lights are all factory original specs then a 20 amp fuse would be OK. If any bulbs are higher wattage...
Forum: Early V8 (1932-53) 08-05-2023, 01:51 AM
Replies: 15
Views: 1,341
Posted By koates
Re: Optima Battery Maintenance

I never leave any of my optima batteries on a float charger for extended periods. Only place them on an automatic charger for about 8 hours once a month. Optima batteries just dont loose charge like...
Forum: Early V8 (1932-53) 07-18-2023, 06:56 PM
Replies: 13
Views: 950
Posted By koates
Re: Hot 33

Lawrie, fit some cast iron replacement type heads on her. Also a pair of the new type water pumps with improved impellers and bearings instead of bushes. Worked great on my 34 sedan. Regards, Kevin.
Forum: Early V8 (1932-53) 07-17-2023, 07:27 PM
Replies: 29
Views: 1,649
Posted By koates
Re: 36 new wire harness, no tail light or brake light

There is only ONE fuse in an ORIGINAL 1936 Ford and it is a 20 AMP fuse. Regards, Kevin.
Forum: Early V8 (1932-53) 07-17-2023, 07:11 PM
Replies: 29
Views: 1,649
Posted By koates
Re: 36 new wire harness, no tail light or brake light

Jack,, I am thinking that you have contact alignment problems in the rear stop and tail sockets. The bulbs must match the sockets as in the pins on the sides of the bulbs are either offset or in...
Forum: Early V8 (1932-53) 07-12-2023, 03:07 AM
Replies: 27
Views: 2,279
Posted By koates
Re: bypassing the resister

NO, NO, The small post on any early FORD solenoid is grounded by the starter push button on the dash. You think about what that will do to either of the small coil terminals. Connected to the POS...
Forum: Early V8 (1932-53) 07-09-2023, 10:21 PM
Replies: 27
Views: 2,279
Posted By koates
Re: bypassing the resister

Engine cranking speed or turn over speed has nothing to do with the ignition resistor. If it is cranking slowly that means there is lower voltage than normally required in your system. First load...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:27 AM.