Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: jw hash
Forum: Model A (1928-31) Yesterday, 07:25 PM
Replies: 25
Views: 925
Posted By jw hash
Re: Oil Leak Worstning Quickly

first do you have and updraft carb on the car, if so the gas will run out on the floor and will NOT get in the crank case while setting. if you have a down draft it can, but it HAS too fill the glass...
Forum: Model A (1928-31) Yesterday, 07:12 PM
Replies: 6
Views: 284
Posted By jw hash
Re: Door Handle set screw...

Pluck
I looked and I do not have any extra`s. get a hold of Steve at Bert`s, I bet he have some originals. they are just 1/4-20 so they are pretty easy to make. John
Forum: Model A (1928-31) 07-16-2018, 04:47 PM
Replies: 9
Views: 469
Posted By jw hash
Re: Glass bowl gaskets....

cork is the best all around.
Forum: Model A (1928-31) 07-11-2018, 07:17 PM
Replies: 48
Views: 3,351
Posted By jw hash
Re: A400 68C rubber stem bumpers

I sent out my last set at the original price of $5 today it cost me $6 to send them. so if anyone wants some now it is $12 for the first set and $5 for any additional sets.
Forum: Model A (1928-31) 07-09-2018, 06:06 PM
Replies: 48
Views: 3,351
Posted By jw hash
Re: A400 68C rubber stem bumpers

guy`s I went back and looked at my original post. it will not let me edit it. I have had to rise the price since then for the shipping cost. I will honor that price for the ones that have ordered up...
Forum: Model A (1928-31) 07-07-2018, 09:14 PM
Replies: 48
Views: 3,351
Posted By jw hash
Re: A400 68C rubber stem bumpers

I still have A LOT of them 7/7/18 John
Forum: Model A (1928-31) 06-18-2018, 08:45 AM
Replies: 3
Views: 244
Posted By jw hash
Re: 31 SW vacuun line installation

john
hold your windshield side molding in place, you will notice that there is a little step on the edge of the molding, your vacuum line runs down right under that step. there is room to let the...
Forum: Model A (1928-31) 06-14-2018, 08:01 PM
Replies: 4
Views: 247
Posted By jw hash
Re: Qtr window install

in what body.
Forum: Model A (1928-31) 06-13-2018, 12:11 PM
Replies: 16
Views: 740
Posted By jw hash
Re: 160 B front door window trim

I have a June 160A and it has three screws. I have never seen one with only two screws on the found side of that molding
Forum: Model A (1928-31) 06-10-2018, 02:07 PM
Replies: 23
Views: 694
Posted By jw hash
Re: 1930 Victoria leatherback inner panel rear spare tire brace

Wadetser I have seen that bracket before. I wonder if they might of been used on the very early Victoria`s. and yes I assembled all the wood before final installation of the rear sheet metal. I did...
Forum: Model A (1928-31) 06-10-2018, 09:05 AM
Replies: 23
Views: 694
Posted By jw hash
Re: 1930 Victoria leatherback inner panel rear spare tire brace

yes the outer two braces should come in the wood kit. here is a couple pictures of my body back in the early 80`s
Forum: Model A (1928-31) 06-10-2018, 08:33 AM
Replies: 23
Views: 694
Posted By jw hash
Re: 1930 Victoria leatherback inner panel rear spare tire brace

Vern, there are three braces in the back of the leatherback, the center one is metal and the other two braces on the are wood.
Forum: Model A (1928-31) 06-09-2018, 05:49 PM
Replies: 23
Views: 694
Posted By jw hash
Re: 1930 Victoria leatherback inner panel rear spare tire brace

it is the female rear seat latch. they are the same in the steel back and A400
Forum: Model A (1928-31) 06-09-2018, 12:55 AM
Replies: 2
Views: 245
Posted By jw hash
Re: Horn rod

remove the horn rod from the column. look on the back side of the top, there is four prongs that are bent over. straighten them out and remove the ring that holds the horn button.
Forum: Model A (1928-31) 06-06-2018, 08:54 PM
Replies: 14
Views: 875
Posted By jw hash
Re: 31 Model A Vacuum Line

a speedo cable will not make it around the corners. the vacuum line are the same size as the small brake lines. I just used up the last one I made on the 160C I just finished.
Forum: Model A (1928-31) 06-06-2018, 08:45 PM
Replies: 5
Views: 496
Posted By jw hash
Re: Correct windshield color/Coker wheels

the correct windshield frame color should be upper body color. the new wheels are a lot of money. if you have good original wheels, use them.
Forum: Model A (1928-31) 06-05-2018, 06:19 PM
Replies: 14
Views: 875
Posted By jw hash
Re: 31 Model A Vacuum Line

just go to NAPA and buy a brake line that size, and make a new one.
Forum: Model A (1928-31) 06-03-2018, 09:39 PM
Replies: 4
Views: 240
Posted By jw hash
Re: Speedometer cable

if you are close to any major city. there should be a speedometer shop that can make a cable for you. In our area it is Northwest Speedometer. in Tacoma
Forum: Model A (1928-31) 06-02-2018, 06:21 PM
Replies: 14
Views: 1,862
Posted By jw hash
Re: Shock Links

if you look at the picture along with the original question. the picture is INCORRECT . the off set on both seals should be to the top. the picture shows one up and one down. I start off with the...
Forum: Model A (1928-31) 06-01-2018, 02:28 AM
Replies: 6
Views: 479
Posted By jw hash
Re: Windshield problem

you can drill out the brackets and replace them with the 30-31 they are easy to do.
the inside gets painted low gloss black.
Forum: Model A (1928-31) 05-30-2018, 10:25 PM
Replies: 6
Views: 479
Posted By jw hash
Re: Windshield problem

Steve is correct. I hope you didn't have it plated.
Forum: Model A (1928-31) 05-29-2018, 11:53 PM
Replies: 3
Views: 281
Posted By jw hash
Re: Cowl lights screw or rivet

the cowl lights had a screw in the back up until April of 1930. and it was not only the screw in the back. the whole light if different than the later version with the rivet.
Forum: Model A (1928-31) 05-28-2018, 08:22 PM
Replies: 9
Views: 345
Posted By jw hash
Re: window seals for 1929

the slant window bodies had a seal that was part of the glass setting rubber. and both Murray and Briggs four doors had outer seal strips that screwed into the wood in the door. and the 68 A&B...
Forum: Model A (1928-31) 05-28-2018, 09:15 AM
Replies: 9
Views: 345
Posted By jw hash
Re: window seals for 1929

there is not a seal that goes on the outside of the glass. there is an anti rattle that goes on the inside.
Forum: Model A (1928-31) 05-27-2018, 09:00 AM
Replies: 18
Views: 711
Posted By jw hash
Re: Painting new cast iron drums

I use high heat engine paint, it holds up real well. also I have had some powder coated. and both ways hold up about the same.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:35 AM.