Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 441
Search took 0.03 seconds.
Search: Posts Made By: 31Tudor
Forum: Model A (1928-31) 10-20-2020, 10:35 AM
Replies: 18
Views: 755
Posted By 31Tudor
Re: Generator Charging

You mention "idle amps". At idle, the generator cut out has opened and broken the contact, so you do not get any charging showing at idle. You would adjust your charging rate at a higher RPM, when...
Forum: Model A (1928-31) 09-18-2020, 10:27 AM
Replies: 10
Views: 635
Posted By 31Tudor
Re: Model a instruction book

I looked at two original manuals and they both have- Form 1940
Forum: Model A (1928-31) 09-17-2020, 08:25 AM
Replies: 33
Views: 1,272
Posted By 31Tudor
Re: Cleaning Silvered Plated Lamp Reflectors

I had Craig do mine maybe 3 years ago and they were $55.00 each. Came out beautiful.
Forum: Model A (1928-31) 08-21-2020, 02:11 PM
Replies: 22
Views: 683
Posted By 31Tudor
Re: Frame welting application

Well.....yes and no. That is what is was told by two Henry winners? Which have done 3 cars between the two of them. I did mine that way and did not receive any deduction in that area. My answer...
Forum: Model A (1928-31) 08-21-2020, 01:46 PM
Replies: 22
Views: 683
Posted By 31Tudor
Re: Frame welting application

The welting starts about 2" past the rear of the splash apron and continues forward just wrapping over the front horns, but not below them. I have used contact cement, no problem. I have fit them...
Forum: Model A (1928-31) 08-18-2020, 02:54 PM
Replies: 16
Views: 777
Posted By 31Tudor
Re: 3.78 vs 3.54 rear end and speedometer/miles

I run 3:54 in two cars and it seems to give about 6-7 MPH more with the same RPM. You will need to change the speedometer drive gear in the cap on the torque tube. All the parts houses have them...
Forum: Model A (1928-31) 07-06-2020, 11:26 AM
Replies: 7
Views: 685
Posted By 31Tudor
Re: Rear backing plate/brake installation Les Andrews instructions

This is the way I have had the most luck, even on an assembled car. I have spent so much time trying to assemble the emergency brake arm and re-hook the spring back on, that for me it is so simple...
Forum: Model A (1928-31) 06-25-2020, 09:42 AM
Replies: 2
Views: 485
Posted By 31Tudor
Re: Hood latch mounting

Your guide could be your hood shelf. Line the holes up in the back hood latch and then you will see where the holes line up in the front.
Forum: Model A (1928-31) 06-24-2020, 02:32 PM
Replies: 7
Views: 537
Posted By 31Tudor
Re: Need Information

With the timing pin in you can have that drop in at TDC on cylinder number 1. You now know the firing sequence and that number 1 cylinder has all valves closed. You can then take the valve...
Forum: Model A (1928-31) 04-01-2020, 12:24 PM
Replies: 44
Views: 2,647
Posted By 31Tudor
Re: Nice Town car photo

My guess would be some type of upper cylinder oiler
Forum: Model A (1928-31) 03-25-2020, 01:53 PM
Replies: 10
Views: 782
Posted By 31Tudor
Re: Changing distributor points

Hey Pete, I don't really think there is a true mileage anymore. There are a lot of different points sold out in the market now, that I don't think a one mileage fits them all.

I run points until...
Forum: Model A (1928-31) 03-13-2020, 02:08 PM
Replies: 9
Views: 968
Posted By 31Tudor
Re: Tudor seat pivot pin

This is what original pins and clips look like
Forum: Model A (1928-31) 11-14-2019, 03:38 PM
Replies: 47
Views: 3,836
Posted By 31Tudor
Re: Interesting read in Hemmings about restoration costs.

That is true.....and PPG and Dupont did not have a good color match for the Elkpoint Green. The Kewaunee green was pretty close, but the codes were not correct for Elkpoint.
Forum: Model A (1928-31) 11-12-2019, 12:41 PM
Replies: 14
Views: 1,163
Posted By 31Tudor
Re: 1930 Model A Tudor Value?

Maybe $10,000 - $12,000?
Forum: Model A (1928-31) 11-12-2019, 12:37 PM
Replies: 34
Views: 2,060
Posted By 31Tudor
Re: Gear ratio

With a stock engine in a 28 pickup, with a 3:54 rear end, I can run 50-55 all day. Going up into the NC mountains, with that set up, on club touring events, I see no difference in shifts points...
Forum: Model A (1928-31) 11-06-2019, 01:46 PM
Replies: 3
Views: 539
Posted By 31Tudor
Re: Odo Stuck - 1930 Round

Or... No known website: Harry Warburton (252)-258-1530/(252)-752-4098 (N. Carolina)

He cleaned mine up, in a very reasonable time.
Forum: Model A (1928-31) 11-05-2019, 04:10 PM
Replies: 17
Views: 1,525
Posted By 31Tudor
Re: Brakes quiz!! ID the mistery system.

If I recall, they were originally sold as a "brake floater". Conway had it right, I know Rick's sold them as an aftermarket. My dad had them on his Roadster in the day, not sure it stopped any...
Forum: Model A (1928-31) 10-30-2019, 11:09 AM
Replies: 7
Views: 835
Posted By 31Tudor
Re: contact info

Harry worked on mine, came out great.

3. No known website: Harry Warburton (252)-258-1530/(252)-752-4098 (N. Carolina)
Forum: Model A (1928-31) 10-28-2019, 09:24 AM
Replies: 21
Views: 1,780
Posted By 31Tudor
Re: 28 Tudor Sedan

I actually really like that! Nice clean looking car.
Forum: Model A (1928-31) 10-28-2019, 09:20 AM
Replies: 27
Views: 2,195
Posted By 31Tudor
Re: Model A backfire, can't move

Before you jump in replacing parts, with either a test light or volt meter, start seeing where you have power. With the key off, you should have power both sides of the coil. With the key on, you...
Forum: Model A (1928-31) 10-24-2019, 10:31 AM
Replies: 14
Views: 1,730
Posted By 31Tudor
Re: Re-Silver A Rear-View

I recently had Alchemy Mirror Resilvering do one for a fine point care, they did a good job and it came out really nice. It was under $50. Steve mentions the link on post #11 and that is pulled...
Forum: Model A (1928-31) 10-24-2019, 08:34 AM
Replies: 3
Views: 448
Posted By 31Tudor
Re: Horn/headlight switch issue

Jim,
The end of the horn/light rod is part of the horn circuit. The very bottom of the rod, presses onto a little brass "button" inside the switch. There may be a little bend to the bottom of your...
Forum: Model A (1928-31) 10-23-2019, 12:56 PM
Replies: 9
Views: 865
Posted By 31Tudor
Re: Steering wheel orientation.

The steering wheel makes a X vs a +. If that makes any sense. When you are driving straight, the steering wheel spoke does not block the speedometer.
Forum: Model A (1928-31) 10-22-2019, 08:46 AM
Replies: 19
Views: 1,418
Posted By 31Tudor
Re: Hi compression head and stock ignition

I run a 7 to 1 with stock ignition. Gave up on electronic when it left me on the side of the road. Runs great.
Forum: Model A (1928-31) 10-15-2019, 02:38 PM
Replies: 45
Views: 3,473
Posted By 31Tudor
Re: Rewiring . . . What would you do different?

I think I would just buy a wiring harness from one of the suppliers and be done with it. I have never had a problem with a stock wiring harness. They are correct the right color and go to the right...
Showing results 1 to 25 of 441

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:22 PM.