Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Jacksonlll
Forum: Model A (1928-31) Today, 12:48 PM
Replies: 12
Views: 184
Posted By Jacksonlll
Re: 600w leaking out of steering box

Grab your pitman arm and pull it toward you and away from you from the side of the car. If there is any movement in the sector shaft bushings, you must replace them. Make sure the pinch bolt is...
Forum: Model A (1928-31) Today, 10:46 AM
Replies: 12
Views: 184
Posted By Jacksonlll
Re: 600w leaking out of steering box

There is a fix for the leak through the sector shaft bushings. An external o ring that works pretty good. Check the catalog.
Forum: Model A (1928-31) 03-30-2020, 08:36 PM
Replies: 22
Views: 485
Posted By Jacksonlll
Re: grounding distributor

Pull out you fuel line to the carb, I assume it’s a Zeinth, and make sure the end of the fuel line is not going in too far and hitting the filter screen. The ferrule should be right at the end of the...
Forum: Model A (1928-31) 03-30-2020, 09:54 AM
Replies: 11
Views: 276
Posted By Jacksonlll
Re: operation question

Model A losing idle upon Deceleration :
Over the years, I have had trouble with various A engines dying out during a fast stop. I would question the float or something else in the carb. And I was...
Forum: Model A (1928-31) 03-29-2020, 05:37 AM
Replies: 26
Views: 644
Posted By Jacksonlll
Re: Spark Plug Condition

Here is a short video on how to clean them.
Yours look black and fuzzy. Time to clean them. Keep them clean and those plugs will last a very long time. Our plugs do foul and it is easy to clean...
Forum: Model A (1928-31) 03-25-2020, 01:59 PM
Replies: 17
Views: 737
Posted By Jacksonlll
Re: Would there be any interest in a programmable electronic points replacer?

The problem with getting away from standard is that when you break down on a tour, your buddies can’t help you. You better have a spare you can put on, or be able to fix it yourself. 8
Forum: Model A (1928-31) 03-25-2020, 01:53 PM
Replies: 10
Views: 479
Posted By Jacksonlll
Re: Changing distributor points

They can last 10 to 20,000 miles.
Forum: Model A (1928-31) 03-24-2020, 07:21 PM
Replies: 11
Views: 551
Posted By Jacksonlll
Re: Surging at idle with spark where it should be

Look real hard for an intake air leak. Do the trick with starting fluid. Good luck.
Forum: Model A (1928-31) 03-23-2020, 05:48 AM
Replies: 5
Views: 305
Posted By Jacksonlll
Re: 31 Model A rear end seals

Those seals don't prevent the rear axle lube from getting to the drum, they redirect the grease from the rear bearing grease fitting out toward the rear bearing. If they are not there, you will pump...
Forum: Model A (1928-31) 03-21-2020, 08:55 AM
Replies: 24
Views: 1,083
Posted By Jacksonlll
Re: Overheating

Eagle, Right On
Forum: Model A (1928-31) 03-20-2020, 12:52 PM
Replies: 24
Views: 1,083
Posted By Jacksonlll
Re: Overheating

If its an old radiator, then the tubes are probably plugged solid so nothing can get into the to clean them out. If not, and it overheated during a very short trip, it may be combustion gases...
Forum: Model A (1928-31) 03-20-2020, 01:41 AM
Replies: 15
Views: 530
Posted By Jacksonlll
Re: tie rod

Measure your toe-in before you take anything apart. Bet you don’t have any.
Forum: Model A (1928-31) 03-19-2020, 07:18 PM
Replies: 11
Views: 492
Posted By Jacksonlll
Re: Very slow/no cranking

Take some jumper cables and go from the battery to the starter and ground. Leave the standard cables in place. If it’s better, then you have resistance somewhere in your cables, or you have 12 volt...
Forum: Model A (1928-31) 03-10-2020, 06:09 AM
Replies: 25
Views: 1,387
Posted By Jacksonlll
Re: Shortened Pitman Arm

They are used a lot and they are fine. It does reduce the turning effort, but the turning radius goes up. I took mine off because I could not turn around like all the other cars when we had a...
Forum: Model A (1928-31) 03-06-2020, 01:31 PM
Replies: 13
Views: 502
Posted By Jacksonlll
Re: Rear-end oil fill

Like Tom said: Fill until it runs out. Fill to spill.
Forum: Model A (1928-31) 03-05-2020, 10:36 AM
Replies: 7
Views: 293
Posted By Jacksonlll
Re: Import Broker Recommendation

Check your private messages.
Forum: Model A (1928-31) 03-03-2020, 09:23 PM
Replies: 18
Views: 860
Posted By Jacksonlll
Re: Need Picture of Cutaway Water Jacket

Best would be to figure out a way to make it a push through system instead of the suck through system.
Forum: Model A (1928-31) 03-02-2020, 08:27 PM
Replies: 17
Views: 1,738
Posted By Jacksonlll
Re: Engine locked up

Search YouTube for. Ford model a starter hang up.
Forum: Model A (1928-31) 03-02-2020, 08:17 PM
Replies: 9
Views: 404
Posted By Jacksonlll
Re: brake light

Don’t throw out that old switch. Take it apart and fix it. Very simple.
Forum: Model A (1928-31) 03-01-2020, 04:52 PM
Replies: 18
Views: 1,012
Posted By Jacksonlll
Re: Rear Motor Mount Rubber Issue

Get ready for a big difference in vibration. Don’t throw the float a motors away.
Forum: Model A (1928-31) 02-25-2020, 06:20 AM
Replies: 21
Views: 1,293
Posted By Jacksonlll
Re: I wish I would have waited

If that starter was using four times the power, it would be glowing red hot. It only takes so much power to spin an engine. You can't make it use four times the power. The power used remains about...
Forum: Model A (1928-31) 02-24-2020, 08:48 PM
Replies: 21
Views: 1,293
Posted By Jacksonlll
Re: I wish I would have waited

For the same power, a 12 volt system will draw half the current. If you double the voltage, current is halved. Power (watts)=voltagexcurrent.
Forum: Model A (1928-31) 02-24-2020, 12:15 PM
Replies: 20
Views: 892
Posted By Jacksonlll
Re: Won't start

Sure sounds like your fuse looks good, but is not. Check it with an ohm meter or test light.
Forum: Model A (1928-31) 02-21-2020, 05:08 PM
Replies: 5
Views: 429
Posted By Jacksonlll
Re: Rear brakes.

You should put in new bushings for both shafts unless that has already been done. Very high load on the service brake shaft bushings.
Forum: Model A (1928-31) 02-20-2020, 08:18 PM
Replies: 13
Views: 923
Posted By Jacksonlll
Re: Hand throttle notches

Keep in mind that they are spring loaded and can be pulled toward you to get some room to work with a file.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:57 PM.