Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Marshall V. Daut
Forum: Model A (1928-31) Today, 07:31 PM
Replies: 45
Views: 9,427
Posted By Marshall V. Daut
Re: Misfiring and backfiring when engine is warm

Check your private messages.
Marshall
Forum: Model-A 07-11-2019, 10:01 AM
Replies: 1
Views: 301
Posted By Marshall V. Daut
Forum: Model-A 07-05-2019, 07:32 AM
Replies: 1
Views: 301
Posted By Marshall V. Daut
FS: 1929 Model A Tudor Sedan

I am posting this for a friend. Please contact him directly.
For Sale: 1929 Model A Tudor Sedan. Authentic Bonnie Gray/Chelsea Blue exterior paint. The pin striping, however, is a light-green...
Forum: Model A (1928-31) 07-01-2019, 08:28 PM
Replies: 24
Views: 1,529
Posted By Marshall V. Daut
Re: Odd Failure

Check your private messages.
Marshall
Forum: Model A (1928-31) 06-30-2019, 10:49 AM
Replies: 5
Views: 230
Posted By Marshall V. Daut
Re: No spark after nEw head replacement

Check your private messages.
Marshall
Forum: Model A (1928-31) 06-18-2019, 09:38 PM
Replies: 21
Views: 827
Posted By Marshall V. Daut
Re: Starter issue

Check your private messages.
Marshall
Forum: Model-A 06-16-2019, 02:54 PM
Replies: 1
Views: 192
Posted By Marshall V. Daut
Re: Heater exhaust and intake manifolds

Tentatively sold. Thanks to all for looking!
Marshall
Forum: Model-A 06-15-2019, 12:06 PM
Replies: 1
Views: 192
Posted By Marshall V. Daut
Heater exhaust and intake manifolds

Waffle style heater and intake manifold set. No heater top. Exhaust manifold ports are level across their tops = no drooping in rear. Separated for wire wheel cleaning and painting in Ford Engine...
Forum: Model-A 06-15-2019, 11:58 AM
Replies: 0
Views: 160
Posted By Marshall V. Daut
1931 Running Board matting, NEW!

NEW running board matting pair for 1931 Model A. Pre-cut diamond pattern with sticky undersides and special 1931 molded edges on three sides. Never been used or even test-fitted to running boards....
Forum: Model-A 06-15-2019, 11:33 AM
Replies: 0
Views: 142
Posted By Marshall V. Daut
Heater top for exhaust manifold

Reproduction aluminum heater top for exhaust manifolds with the typical waffle top, such as Sears, Autolite and other common brands of the era. Two bolt holes on its top match those in the waffle top...
Forum: Model-A 06-15-2019, 11:28 AM
Replies: 0
Views: 147
Posted By Marshall V. Daut
Firewall Battery Carrier

Used battery carrier assembly for firewall-mounted battery in 1928-29 Model As. Many Model A owners in the 1940s and 1950s moved the battery from under the floorboards to the firewall to make...
Forum: Model A (1928-31) 06-12-2019, 02:27 PM
Replies: 27
Views: 1,253
Posted By Marshall V. Daut
Re: Help me identify engine noise?

Check your private messages.
Marshall
Forum: Model A (1928-31) 05-06-2019, 08:29 AM
Replies: 24
Views: 1,203
Posted By Marshall V. Daut
Re: HP & Torque For Various Cylinder Heads

Terry and others -
I didn't mention the type of bearings in my engines because I was trying to keep my previous post short (Ha, ha, ha!). Nor did I mention that some of the trips were made with "A"...
Forum: Model A (1928-31) 05-05-2019, 11:05 PM
Replies: 24
Views: 1,203
Posted By Marshall V. Daut
Re: HP & Torque For Various Cylinder Heads

Ha, ha, ha! Ya' got me there, Joe! Yup - a highway patrolman pulled me over for speeding in my '29 Cabriolet IN THE MOUNTAINS while going uphill near Heber, Arizona. That was with the Riley Two-Port...
Forum: Model A (1928-31) 05-05-2019, 09:47 PM
Replies: 24
Views: 1,203
Posted By Marshall V. Daut
Re: HP & Torque For Various Cylinder Heads

Since the mid-1990's when I was upgrading my various Model A's for cross-county driving from Arizona to Iowa and back on vacations, I experimented with several different higher compression cylinder...
Forum: Model-A 04-28-2019, 08:17 AM
Replies: 1
Views: 253
Posted By Marshall V. Daut
Forum: Model-A 04-23-2019, 07:28 PM
Replies: 1
Views: 321
Posted By Marshall V. Daut
Forum: Model-A 04-12-2019, 07:53 PM
Replies: 1
Views: 264
Posted By Marshall V. Daut
Re: Bronze timing gear for sale

Payment received today, so the gear is "officially" sold. Thanks to all for your responses. I wish I had more of these gears to sell!
Marshall
Forum: Model-A 04-12-2019, 12:40 PM
Replies: 0
Views: 133
Posted By Marshall V. Daut
1930-31 Roadster rear seat riser, new

For Sale: 1930-31 Model A Roadster rear seat riser (sheet metal). Purchased new 20 years ago when Model A sheet metal was still being made properly. Never installed. Stored inside. A light surface...
Forum: Model-A 04-12-2019, 12:36 PM
Replies: 1
Views: 253
Posted By Marshall V. Daut
Firewall battery carier for 1928-29 Model A's

For Sale: Firewall battery carrier for 1928-29 Model As
Used, VERY WELL-MADE sturdy metal battery carrier for Group 1 batteries mounted on the firewall. This was a popular conversion in the 1940s...
Forum: Model-A 04-12-2019, 12:22 PM
Replies: 1
Views: 321
Posted By Marshall V. Daut
Heater Exhaust and Intake Manifold set

For Sale: Model A heater exhaust & intake manifold set
Waffle style exhaust manifold with intake manifold. No heater top. Intake has the threaded hole for the vacuum windshield wiper fitting...
Forum: Model-A 04-09-2019, 08:01 PM
Replies: 1
Views: 246
Posted By Marshall V. Daut
Re: Manifold heater top for DOWNDRAFT carbs

I might also mention that with this cut-out modification, there is direct access to the distributor locking bolt in the cylinder head directly through the hole cast into the waffle portion of...
Forum: Model-A 04-09-2019, 05:28 PM
Replies: 1
Views: 264
Posted By Marshall V. Daut
Bronze timing gear for sale

This is a used bronze timing gear that comes from a Model A engine with far fewer than 1000 easy miles. It's standard size and is almost like new with so few miles on it. It runs MUCH quieter than an...
Forum: Model-A 04-09-2019, 05:13 PM
Replies: 1
Views: 246
Posted By Marshall V. Daut
Manifold heater top for DOWNDRAFT carbs

Aluminum repo manifold heater top for the waffle style exhaust manifold (Sears, Interstate, Autolite among others). What's special about this one is the modification so that it can be used in tandem...
Forum: Model-A 04-09-2019, 05:04 PM
Replies: 0
Views: 147
Posted By Marshall V. Daut
For Sale: Six-blade fan

This is the water pump fan with six plastic blades and a machined hub. It came from an engine with way less than than 1,000 miles and is still very nice. Cleaned and repainted = ready to mount. If...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:10 PM.