Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: redmodelt
Forum: Model T (1909-1927) 01-26-2022, 11:40 AM
Replies: 2
Views: 134
Posted By redmodelt
Re: roof overhang missing piece?

This should answer your questions; http://www.mtfca.com/discus/messages/257047/290665.html?1337631048
Forum: Model A (1928-31) 01-25-2022, 11:12 AM
Replies: 452
Views: 121,515
Posted By redmodelt
Re: carburetor 13/32 deep well socket

I have access to a Model A era tool for removing the GVA, I can say that not all GVA's take the same size socket. That "T" handled deep socket tool does not fit on all of them. Guessing could be...
Forum: Model A (1928-31) 01-23-2022, 09:03 PM
Replies: 13
Views: 810
Posted By redmodelt
Re: brazzing

Solder repairs will work too. Done by V'ing out the crack, rubbing copper on V'ed out area or tinning then soldering. One of these days I am going to try it.
Forum: Model A (1928-31) 01-21-2022, 07:57 PM
Replies: 452
Views: 121,515
Posted By redmodelt
Re: carburetor 13/32 deep well socket

The person that was making them, their last post and time on this site was back in 2017. You could try contacting them with a PM, but I think after one post a while back that I read, think the wind...
Forum: Questions & Suggestions 01-19-2022, 08:53 PM
Replies: 9
Views: 1,408
Posted By redmodelt
Re: Do not have permission

What you just did.
Forum: Questions & Suggestions 01-18-2022, 09:20 AM
Replies: 1
Views: 127
Posted By redmodelt
Re: 56 Victoria hot primary wiring

You need to ask on the Late V8 forum. This section is for questions about the site, not car questions.
Forum: Questions & Suggestions 01-18-2022, 09:19 AM
Replies: 1
Views: 72
Posted By redmodelt
Re: 55 Thunderbird Transmission

You need to ask on the Late V8 forum. This section is for questions about the site, not car questions.
Forum: Model A (1928-31) 01-16-2022, 08:43 AM
Replies: 84
Views: 7,975
Posted By redmodelt
Re: Clear Distributor Cap

The cutaway one would be good for setting the spark gap between the rotor and body with everything in place.
Forum: Model A (1928-31) 01-15-2022, 11:51 PM
Replies: 21
Views: 906
Posted By redmodelt
Re: Gas guage outer ring not seating

Do you have the brass slip rings in place?
Forum: Model T (1909-1927) 01-15-2022, 11:49 PM
Replies: 3
Views: 1,439
Posted By redmodelt
Re: Is There Really Anything New Under the Sun? - The Hucks "T" Airplane Starter

Try "mtfca; huck" There has been a lot posted there on this T base starter including a while back the building of one.
Forum: Model T (1909-1927) 01-15-2022, 11:47 PM
Replies: 2
Views: 211
Posted By redmodelt
Re: Livingood four-wheel drive

Here not so much, Model T Ford Club of America has a lot more info, including this current one: https://www.mtfca.com/phpBB3/viewtopic.php?f=2&t=26286
Try also a search of "mtfca; Livingood"
Forum: Model T (1909-1927) 01-15-2022, 07:29 PM
Replies: 6
Views: 991
Posted By redmodelt
Re: Intake manifold Gaskets for 1913

Last time he was on FB was Jan 2021. Hope he is well, being 83 young.
Forum: Model T (1909-1927) 01-15-2022, 07:26 PM
Replies: 7
Views: 519
Posted By redmodelt
Re: My car

No he means brake and clutch master cylinder. Not T engined. Click on his name and read some of the back postings.
Forum: Model T (1909-1927) 01-15-2022, 02:36 PM
Replies: 6
Views: 991
Posted By redmodelt
Re: Intake manifold Gaskets for 1913

if the exhaust manifold is straight, go with No 1 or 4 on that list.
Forum: Model A (1928-31) 01-14-2022, 12:01 PM
Replies: 32
Views: 15,446
Posted By redmodelt
Re: Body to frame welting...

You'll need to ask on the Early V8 forum.
Forum: Model A (1928-31) 01-14-2022, 11:59 AM
Replies: 22
Views: 1,142
Posted By redmodelt
Re: greasing new springs

I seem to recall that Model A's up did not use grease or any lube between the leafs? Model T's did.
Forum: Model A (1928-31) 01-12-2022, 10:58 AM
Replies: 41
Views: 2,375
Posted By redmodelt
Re: 1930 Tudor accident

RE the bumper flying up. Sounds like you have/had those older cast bumper mounts. Make sure they are replaced with the proper forged type.

If the bumper mounting brackets are bent, after they get...
Forum: Model T (1909-1927) 01-12-2022, 10:51 AM
Replies: 8
Views: 502
Posted By redmodelt
Re: Model A W/ Suicide Doors?

Around 1910, one of the touring car body builders used suicide rear doors for a short time. Ford used a number of different body builder thought out the production of the T into the Model A era. Not...
Forum: Questions & Suggestions 01-10-2022, 05:33 PM
Replies: 50
Views: 30,086
Posted By redmodelt
Re: Trying to reply to a classified ad?

What reply are you trying to open? Without more information, it would be hard to even start helping. If you are trying to reply to ad, go back and read the very first post.

Try posting as a NEW...
Forum: Model T (1909-1927) 01-09-2022, 12:54 AM
Replies: 1
Views: 172
Posted By redmodelt
Re: Door Hinge Mounted Side Mirrors…

About the same as any mirror on any Model T. A lot depends on construction and weight of mirror. Any mirror, vibrating or not, is good to have.
Forum: Model A (1928-31) 01-08-2022, 04:26 PM
Replies: 20
Views: 902
Posted By redmodelt
Re: AA Delivery's

Neil, thanks for the correction. When I was with Tom G. and he got the X hearse, guess with all the muck looked like loose spoke. Corrected my post.
Forum: Model A (1928-31) 01-07-2022, 11:44 PM
Replies: 20
Views: 902
Posted By redmodelt
Re: AA Delivery's

See Neils post below. They are rare and even more rare are the hub caps. The only reason I know anything about them, is because I know someone that has an X hearse that has them on it.
Forum: Model A (1928-31) 01-07-2022, 08:35 PM
Replies: 20
Views: 902
Posted By redmodelt
Re: AA Delivery's

See my post #15 for more views of the Lincoln style wire wheels like above; https://www.fordbarn.com/forum/showthread.php?t=308557
Forum: Model A (1928-31) 01-07-2022, 08:28 PM
Replies: 46
Views: 2,535
Posted By redmodelt
Re: Extinct Model A

Stand drive for sale, no connection;
https://www.smokstak.com/forum/threads/ford-stand-drive.219665/
Forum: Questions & Suggestions 01-07-2022, 08:06 PM
Replies: 1
Views: 193
Posted By redmodelt
Re: 1929 model a pickup

If you have questions or need more information, you need to post on the Model A forum page. This section is for questions about the site and its use, not car questions. Few people read this section,...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:05 PM.