Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: Kerk
Forum: Early V8 (1932-53) Yesterday, 07:12 AM
Replies: 6
Views: 442
Posted By Kerk
Re: H&C rotors

If he does not want it I do. Thanks kerk kx3235ford@gmail.com
Forum: Early V8 (1932-53) 10-05-2019, 04:35 AM
Replies: 22
Views: 578
Posted By Kerk
Re: Ballast resistor getting real hot

Were the bulbs changed to 12 volt or are they burned out with the 12 Volts ? just a thought!
Forum: Early V8 (1932-53) 10-05-2019, 03:47 AM
Replies: 5
Views: 346
Posted By Kerk
Re: Wanted: Ford Script version battery cable 40-14313-B

I think the Brillman Co in Jackson, Va. tel.# 888-274-5562 or # 540-477-4112..... they used to set up in Hershey. Good Quality cables. kerk
Forum: Early V8 (1932-53) 10-04-2019, 10:38 AM
Replies: 28
Views: 1,364
Posted By Kerk
Re: Where are you at HERSHEY

Kerk, I am usually at, Light pole # 84 for many years but last year was my last year. Health Issues are the main reason! I can be reached at email - kx3235ford@gmail.com . Been there for so many...
Forum: Early V8 (1932-53) 10-02-2019, 02:49 PM
Replies: 2
Views: 162
Posted By Kerk
Re: 34 pickup gas pedal parts

I believe they are very similar. One thing is the hand throttle ball on the side of the linkage to connect to the dash bell crank located on the 32 dash tunnel. Just something to look for as my...
Forum: Early V8 (1932-53) 09-18-2019, 04:21 PM
Replies: 39
Views: 1,926
Posted By Kerk
Re: Mitchell Overdrive

Someone from Middle of the country sent me an email and I am not able to reply ! Computer problem or ME Sent him a reply and told him I am from ma and National V 8 Club member and in the roster .....
Forum: Early V8 (1932-53) 09-17-2019, 04:55 PM
Replies: 32
Views: 861
Posted By Kerk
Re: 3 brush generator ????

The original cut out is just what it says ! When it is not charging the points are open and closed when it is charging.. IF the points STICK and you shut the engine off the Amp meter can burn out. ...
Forum: Early V8 (1932-53) 09-15-2019, 07:45 AM
Replies: 39
Views: 1,926
Posted By Kerk
Re: Mitchell Overdrive

I was going to go with a Coumbia and have the parts but at this point I do not think I will get to it. Age & health changes things ! kx
Forum: Early V8 (1932-53) 09-09-2019, 03:22 PM
Replies: 14
Views: 654
Posted By Kerk
Re: Water based cleaner??

M Td my Greatfalls tank and cleaned it. It needs to go away at this stage of my non use ofm it. Too big & takes too much space. kx
Forum: Early V8 (1932-53) 09-08-2019, 09:52 AM
Replies: 6
Views: 307
Posted By Kerk
Re: 34 front engine mount /water outlet

I have a pair but they are not marked ! I thought they were 35 when I bought them but they were too Narrow when mounted on my engine so maybe ethey are 34/34, You are wlecome to have them for the...
Forum: Early V8 (1932-53) 09-06-2019, 02:00 PM
Replies: 23
Views: 829
Posted By Kerk
Re: Trany Problems

There is a sleve KR Wilson #BV39 which is to slide the balls down when assembling I belive.. I just went to shop and looked at the one I have. Had it so long for.got and have not done a trwanny...
Forum: Early V8 (1932-53) 08-24-2019, 10:55 AM
Replies: 10
Views: 518
Posted By Kerk
Re: Safety Wire

A.F. was mostly 032 dia. Still have some. Thanks all!
Forum: Early V8 (1932-53) 08-21-2019, 05:30 AM
Replies: 5
Views: 360
Posted By Kerk
Re: Mechanical fuel pump

I test a pump by hand cranking or rotating the crankshaft until I see the push rod at its Highest point and then install the fuel pump on its stand and then with the gas line connected manually push...
Forum: Early V8 (1932-53) 08-18-2019, 04:08 PM
Replies: 12
Views: 887
Posted By Kerk
Re: Got the call

Just a word of Caution. Be sure that when you remove the Heavy read end assembly thatb= you have enough support for the front rest of the car as on a 2 post lift it could fall down in front with a...
Forum: Early V8 (1932-53) 08-18-2019, 12:42 PM
Replies: 18
Views: 616
Posted By Kerk
Re: cleaned fuel bowl=no start?

The only way to use a vacuum might be on the pressure side to blow into the fuel tank with a rag tohelp seall it! Should probably have 2 people. CAUTION !! Using a vacuum cleaner on the vacuum...
Forum: Early V8 (1932-53) 08-12-2019, 11:25 AM
Replies: 75
Views: 4,078
Posted By Kerk
Re: Roy Nacewicz's business, and it's future

Great News ! AGREE with all the above (plusses sp! ) kerk
Forum: Early V8 (1932-53) 08-08-2019, 05:38 AM
Replies: 19
Views: 727
Posted By Kerk
Re: Spark at Battery is it a short?

On my 32 the cut out on the generator stuck closed. Burned out the amp meter ! Just a side note, kx
Forum: Early V8 (1932-53) 07-30-2019, 03:33 PM
Replies: 21
Views: 643
Posted By Kerk
Re: 32 stock v8 tudor steering very hard

I had a 32 Tudor that I put 15,000+ miles including a cross country from Ma. to Hood River Qregon . Mn. Meet & Georgia meet. I had rebuilt all sterring pcs and it worked O.Kfor me.. I would start by...
Forum: Early V8 (1932-53) 07-29-2019, 04:12 PM
Replies: 53
Views: 1,612
Posted By Kerk
Re: Flathead deck height

I know that in at least one case the block was shaved INSTEAD of the heads because if you were a winner they would tear down the engine right after the race to check the bore & stroke etc. before you...
Forum: Early V8 (1932-53) 07-19-2019, 11:38 AM
Replies: 16
Views: 1,699
Posted By Kerk
Re;; !!A Distributor

Do you rebuild or set up the 11A for the early flat heads. ? kerk kx3235ford@gmail.com
Forum: Early V8 (1932-53) 07-05-2019, 04:41 PM
Replies: 12
Views: 929
Posted By Kerk
Re: Priming engine with oil

The only thing I can add is to tunn the engine Slowly while pressuring the system . Always did it on fresh rebuilds . Helps to have someone to do the turning. Run 3 or 4 quarts this way. Kerk
Forum: Early V8 (1932-53) 07-05-2019, 04:32 PM
Replies: 5
Views: 424
Posted By Kerk
Re: Need help Identifying trunk lids year

Number 6 looks like a 35/36 2 door & 4door hump back . Kerk
Forum: Early V8 (1932-53) 06-27-2019, 09:46 AM
Replies: 8
Views: 449
Posted By Kerk
Re: Source for '35 diagrams and illustrations?

Bob, I am also working on a 35 Pick up. Where are you located ? There may be a club or a member that may be able to answer some of your questions. jmho kerk
Forum: Early V8 (1932-53) 06-21-2019, 10:32 AM
Replies: 2
Views: 552
Posted By Kerk
Charlie N.Y.

Charlie, Please send me your Tel. # so I can give it ro my son to contact you. re: doing Distributors & any info you may have on My old Harmon-Collins Distributor and other 11A conversions..Kerk ...
Forum: Early V8 (1932-53) 06-19-2019, 11:29 AM
Replies: 15
Views: 776
Posted By Kerk
Re: Adding an electric fuel pump

I believe that the Carter pump is a gear type pump and if it is I do Not think they are a Flow through Pump. kerk
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:33 PM.