The Ford Barn
FordBarn.com
The Forum
Swap
About
Register
Calendar
Community
Today's Posts
Search
FAQ
The Ford Barn
>
Search Forums
Search Results
User Name
Remember Me?
Password
Community Links
Members List
Search Forums
Show Threads
Show Posts
Advanced Search
Go to Page...
Sponsored Links (Register now to hide all advertisements)
Showing results 1 to 6 of 6
Search took
0.00
seconds.
Search:
Posts Made By:
Model A
Forum:
Model A (1928-31)
04-25-2022, 07:25 PM
Replies:
21
Era Tennessee plates $$$
Views:
3,203
Posted By
Model A
Re: Era Tennessee plates $$$
The first two digits on the South Dakota plates identitye county that issued the plates.
39- was issued in Jackson County. I have many plates from Hutchinson County 37.
Forum:
Early V8 (1932-53)
08-06-2019, 12:33 PM
Replies:
52
Bat piss
Views:
7,958
Posted By
Model A
Re: Bat piss
I have installed tightly strung fishing line in areas that they fly in. They learn to avoid this area.
Forum:
Questions & Suggestions
05-31-2018, 06:35 PM
Replies:
8
Heat for my garage
Views:
3,111
Posted By
Model A
Re: Heat for my garage
If you go with the gas, buy a low BTU input unit. If the heater is to large it will cycle off frequently. It is better to leave them run when very cold.
Forum:
Model-A
03-31-2016, 07:22 PM
Replies:
0
1929 Ford two door sedan
Views:
1,124
Posted By
Model A
1929 Ford two door sedan
1929 was in barn 40 years. Some rust on back, motor stuck. doors cowl solid. No interior, but fairly complete. Top wood gone. 21" wheels and old barn tires included. Wheels shown are 19"...
Forum:
Model A (1928-31)
12-04-2012, 06:50 PM
Replies:
3
Oil Pump Drive Gear
Views:
6,929
Posted By
Model A
Oil Pump Drive Gear
I can not get the oil pump drive gear installed. I have a new engine and installed the oil pump and oil pan and did not get the gear installed first.
Do I have to remove the pan and pump to install...
Forum:
Model A (1928-31)
06-10-2010, 12:26 PM
Replies:
25
engine rebuild, piston ring size????
Views:
11,475
Posted By
Model A
Re: engine rebuild, piston ring size????
I took my block to a machine shop just to find out what it needed. Turned out the bearings are cracked and pistons are worn. Mine are .040 over, what diameter over is safe for heating block?
Showing results 1 to 6 of 6
Forum Jump
User Control Panel
Private Messages
Subscriptions
Who's Online
Search Forums
Forums Home
General Discussion
Model T (1909-1927)
Model A (1928-31)
Early V8 (1932-53)
Late V8 (1954+)
Hot Rods & Customs
The Swap Meet
For Sale
Model-T
Model-A
Early V8
Late V8
The Jalopy Auction House
To The Editors
Questions & Suggestions
The Test Forum
The Archives
Model-T
Model-A
Early V8
Late V8
Sponsored Links (Register now to hide all advertisements)
All times are GMT -5. The time now is
05:46 AM
.