Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.10 seconds.
Search: Posts Made By: Bob C
Forum: Model A (1928-31) Today, 11:03 AM
Replies: 8
Views: 295
Posted By Bob C
Re: Steering arms

The arrow shows the flat on the steering arm that should keep it from rotating.
Forum: Model A (1928-31) 09-20-2021, 11:50 AM
Replies: 10
Views: 673
Posted By Bob C
Re: So, I have apparently blown head gasket

I've also had a couple of sleeved engines with no problems. Just make sure they leave
a step at the bottom of the original bore so the sleeve can't move down.
Forum: Model A (1928-31) 09-20-2021, 11:45 AM
Replies: 13
Views: 486
Posted By Bob C
Re: Door hinge screw removal

An impact driver works good also.
Forum: Early V8 (1932-53) 09-19-2021, 04:51 PM
Replies: 5
Views: 232
Posted By Bob C
Re: NOS 6 Cylinder Exhaust Manifold ID needed please!

The Hollander Interchange shows you can use that manifold on 1947-48 H engine
and 1948-51 truck 226 engine by using intake to exhaust manifold studs from the
manifold being replaced.
Forum: Early V8 (1932-53) 09-19-2021, 04:46 PM
Replies: 18
Views: 416
Posted By Bob C
Re: 34 Ford Carburetor

If it's been sitting that long I would pull the top off the carb and see if there is
old dried out gas that looks like shellac in the bowl.
Forum: Early V8 (1932-53) 09-19-2021, 04:43 PM
Replies: 13
Views: 262
Posted By Bob C
Re: 1950 Ford Steering Wheel Alignment

When you count the turns of the steering wheel lock to lock and then go half way
back is the steering wheel centered??
Forum: Model A (1928-31) 09-19-2021, 01:56 PM
Replies: 3
Views: 232
Posted By Bob C
Re: 30 Tudor Cowl to Chassis Mounts

Are you saying the frame bracket is missing??
Forum: Model A (1928-31) 09-19-2021, 01:48 PM
Replies: 14
Views: 432
Posted By Bob C
Forum: Early V8 (1932-53) 09-19-2021, 01:38 PM
Replies: 24
Views: 457
Posted By Bob C
Re: Electrical verification 32 Ford

This is from Van Pelt's site.
Forum: Early V8 (1932-53) 09-19-2021, 11:46 AM
Replies: 24
Views: 457
Posted By Bob C
Re: Electrical verification 32 Ford

The generator should not be in the circuit if the cutout points are open.
Forum: Model A (1928-31) 09-19-2021, 10:11 AM
Replies: 6
Views: 445
Posted By Bob C
Re: Rebuilding Distributor

Sounds like the washer may be to thick.
Forum: Early V8 (1932-53) 09-19-2021, 10:06 AM
Replies: 15
Views: 386
Posted By Bob C
Re: Headlight

He's not a new guy, been a member since June 2011. Just doesn't post much.
Forum: Model A (1928-31) 09-18-2021, 09:28 PM
Replies: 15
Views: 520
Posted By Bob C
Re: 1929 Model A Pickup HELP!! No forward or Reverse Gears

If the speedometer moves then the problem is in the rear axle.
Forum: Model A (1928-31) 09-18-2021, 09:25 PM
Replies: 2
Views: 211
Posted By Bob C
Re: Roadster windshield weatherstrip

Here's a picture of Marco's Roadster.
Forum: Model A (1928-31) 09-18-2021, 09:19 PM
Replies: 15
Views: 520
Posted By Bob C
Re: 1929 Model A Pickup HELP!! No forward or Reverse Gears

When you have it in gear and the clutch out and the truck is not moving is
the speedometer moving??


Typed to slow again.
Forum: Model A (1928-31) 09-18-2021, 05:23 PM
Replies: 14
Views: 432
Posted By Bob C
Re: 1929 AA Truck flat bed puzzle .

I agree with grove truck. The bed on the one I have is 69 3/4" wide.
The picture is similar to the one I have.
Forum: Model A (1928-31) 09-17-2021, 11:45 AM
Replies: 35
Views: 1,552
Posted By Bob C
Re: Fading Interest

OK, your idea of dirt cheap and mine are way different. Good luck
in what ever you choose.
Forum: Model A (1928-31) 09-17-2021, 11:40 AM
Replies: 3
Views: 312
Posted By Bob C
Re: 1930 Model A engine

Maybe Turlock Machine, I have no experience with them.
https://www.youtube.com/watch?v=meVhdz10RRc
Forum: Early V8 (1932-53) 09-17-2021, 11:27 AM
Replies: 24
Views: 1,130
Posted By Bob C
Re: Vintage battery kill switch?

I think you are overthinking this. Just make a bracket to mount the switch on the
inner fender panel near the battery. Run a short cable from the battery to the switch
and another from the switch...
Forum: Model A (1928-31) 09-16-2021, 09:16 PM
Replies: 35
Views: 1,552
Posted By Bob C
Re: Fading Interest

Where do you find these dirt cheap prewar cars unless you mean
the Iraqi war.
Forum: Early V8 (1932-53) 09-16-2021, 10:58 AM
Replies: 516
Views: 33,395
Posted By Bob C
Re: 1932 The Deuce, Dually, Dump Truck

Snyder's has this engine stand side mount. https://www.snydersantiqueauto.com/ProductDetail/A-6005-ADP_ENGINE-STAND-ADAPTER?fromCategory=Products/model-a/tools
Forum: Model A (1928-31) 09-14-2021, 04:11 PM
Replies: 112
Views: 5,178
Posted By Bob C
Re: 1929 double a won't start, help

Try these. https://georgemoir.ca/
http://www.oldcarcentre.com/
Forum: Early V8 (1932-53) 09-14-2021, 04:05 PM
Replies: 2
Views: 196
Posted By Bob C
Re: Parkling light stuck on, Headlights not working

The bottom of the steering gear in the light switch.
Forum: Model A (1928-31) 09-14-2021, 10:26 AM
Replies: 5
Views: 433
Posted By Bob C
Re: Original color ignition cable

The high tension wire was black lacquered cloth covered.
Forum: Early V8 (1932-53) 09-13-2021, 04:16 PM
Replies: 20
Views: 486
Posted By Bob C
Re: 45 Truck parking brake problems

Did he measure the drums with a brake drum micrometer?
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:29 PM.