Forum: Model A (1928-31)
01-29-2024, 11:25 PM
|
Replies: 5
Views: 461
Re: Small Bubbles in Transmission Oil
Garage isn’t heated. Chilly winter temps (ok, for the Southern Appalachians). Guess it’s been doing this in the past, though not seen. Perhaps driving simply warms things and get rid of this?
|
Forum: Model A (1928-31)
01-29-2024, 09:23 PM
|
Replies: 5
Views: 461
|
Forum: Model A (1928-31)
01-29-2024, 06:47 PM
|
Replies: 5
Views: 461
Small Bubbles in Transmission Oil
When I removed the shifter tower to inspect the gears, I notices an accumulation of small bubbles in the gear oil (90w). I promptly drained the oil, which was clean looking.
Upon refilling it and...
|
Forum: Model A (1928-31)
08-18-2022, 10:01 PM
|
Replies: 15
Views: 1,930
|
Forum: Model A (1928-31)
08-18-2022, 07:37 PM
|
Replies: 15
Views: 1,930
Trying to Pump Grease Into Non-Zerc Fittings
I've got some pressed-in old style fittings (both straight nozzle and conical shaped). I have what I think is an adapter tip for the lube gun. When I attempt to pump in some grease - say into the...
|
Forum: Model A (1928-31)
08-16-2022, 07:38 PM
|
Replies: 8
Views: 1,580
Re: '31 Slant Windshield Side Mirror
So it sounds as if the correct bracket for a slant windshield model (A400) is going to be a challenge. If I am interpreting your comments in the article properly, I would likely need a longer pin -...
|
Forum: Model A (1928-31)
08-16-2022, 04:57 PM
|
Replies: 8
Views: 1,580
|
Forum: Model A (1928-31)
08-15-2022, 08:09 PM
|
Replies: 8
Views: 1,580
'31 Slant Windshield Side Mirror
I saw the recent thread about side mirrors, but I wasn't quite clear about the correct application for a slant windshield.
I have an A400 and would like to add a hinge mounted driver side mirror. ...
|
Forum: Model A (1928-31)
06-03-2022, 03:01 PM
|
Replies: 8
Views: 2,241
|
Forum: Model A (1928-31)
06-03-2022, 11:54 AM
|
Replies: 8
Views: 2,241
|
Forum: Model A (1928-31)
06-03-2022, 10:48 AM
|
Replies: 8
Views: 2,241
Modern Points & Condenser - Napa Part #'s Please
I have a modern points/condenser plate (Nurex) and wanted to grab a spare set of points and condenser at my local Napa store.
Would someone please share the correct part #s for these?
Thanks!
|
Forum: Model A (1928-31)
02-16-2022, 05:33 PM
|
Replies: 7
Views: 1,331
|
Forum: Model A (1928-31)
10-08-2021, 07:24 PM
|
Replies: 16
Views: 1,621
Starting Issue - Need Ideas!
Problem: Starter motor can barely turn over the engine.
Background: Tried two starters that check out fine. We’ve tried hooking them up straight to both 6 volt (used on car) and 12 volt. ...
|
Forum: Model A (1928-31)
10-05-2021, 06:37 PM
|
Replies: 26
Views: 2,955
|
Forum: Model A (1928-31)
09-02-2021, 07:28 PM
|
Replies: 9
Views: 1,649
|
Forum: Model A (1928-31)
08-15-2021, 06:49 PM
|
Replies: 24
Views: 2,292
|
Forum: Model A (1928-31)
08-15-2021, 10:42 AM
|
Replies: 24
Views: 2,292
|
Forum: Model A (1928-31)
08-15-2021, 10:42 AM
|
Replies: 24
Views: 2,292
|
Forum: Model A (1928-31)
08-15-2021, 10:25 AM
|
Replies: 24
Views: 2,292
|
Forum: Model A (1928-31)
08-15-2021, 09:56 AM
|
Replies: 24
Views: 2,292
|
Forum: Model A (1928-31)
08-15-2021, 09:55 AM
|
Replies: 24
Views: 2,292
|
Forum: Model A (1928-31)
08-15-2021, 09:41 AM
|
Replies: 24
Views: 2,292
Doesn't Want to Restart After Running a While
My '31 coupe starts just fine and runs well. After it runs 10-15 minutes, it often won't fire up. Cranks fine, ammeter is moving when cranking. I am wondering if the condenser might be getting too...
|
Forum: Model A (1928-31)
02-02-2020, 09:51 AM
|
Replies: 22
Views: 4,392
Re: Rear backing plates delima
I am just now joining, but seem to be having a similar issue and would appreciate some guidance. I am rebuilding the back brakes and replaced the roller track assembly, purchased new cast iron...
|