Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: Planojc
Forum: Early V8 (1932-53) Yesterday, 11:14 AM
Replies: 20
Views: 542
Posted By Planojc
Re: Standard or Deluxe Model?

Didn't the standard only have one horn and the deluxe with two?
Forum: Model A (1928-31) 01-16-2020, 10:27 AM
Replies: 10
Views: 450
Posted By Planojc
Re: VIN Number

JD see if the vin # on your title matches the # stamped on the engine. If it does, you are very lucky and good to go, but if not check with the Ohio DMV on what to do. You can do this online. Most of...
Forum: Early V8 (1932-53) 12-13-2019, 09:19 AM
Replies: 9
Views: 552
Posted By Planojc
Re: A Bob Drake Fuel pump...

Send it to Charlie NY
Forum: Early V8 (1932-53) 11-13-2019, 10:46 AM
Replies: 183
Views: 10,983
Posted By Planojc
Re: Interest in new restoration project thread?

Looking forward to seeing what you do on your lunch hour.
Forum: Early V8 (1932-53) 10-12-2019, 09:06 AM
Replies: 5
Views: 495
Posted By Planojc
Re: turn signals

Has anyone tried the Electro-Tech, Inc. turn signals? Operates on 6 or 12v, pos. or neg. with self canceling.
Forum: Model A (1928-31) 10-12-2019, 08:30 AM
Replies: 32
Views: 2,058
Posted By Planojc
Re: What have you found working on your A?

Changed out a model A gas gauge and the previous mechanic had wired a blue Christmas tree light bulb in place of the float.
Forum: Early V8 (1932-53) 10-09-2019, 07:48 AM
Replies: 31
Views: 1,339
Posted By Planojc
Re: Running without a torque tube center bearing ?

Put a Mitchell in it and the bearing problem is gone, plus you have overdrive.
Forum: Model A (1928-31) 09-27-2019, 01:07 PM
Replies: 0
Views: 189
Posted By Planojc
Another 30-30 roadster question

Getting ready to assemble the seat backrest wood and need to know which way the three vertical wood supports go. I assume the tapered notch goes to the top but have seen pictures of it both ways....
Forum: Model A (1928-31) 09-26-2019, 12:06 PM
Replies: 2
Views: 315
Posted By Planojc
30-31 wheel well patch panel question

Was the L shaped flange on the bottom of the panel folded up to the sub rail or left L shaped? Thanks
Forum: Model A (1928-31) 09-25-2019, 07:54 AM
Replies: 6
Views: 414
Posted By Planojc
Re: Mitchell cable control

I have a cable shift and it operates very easy with one finger.
Forum: Early V8 (1932-53) 09-21-2019, 09:44 AM
Replies: 18
Views: 891
Posted By Planojc
Re: need my transmission rebuilt

Gary Bernard of AAAA Transmissions in Fort Worth, Texas 817-624-4342. He rebuilt two 39's for me. He's also the guy who came up with the F150 four speed conversion to a model A.
Forum: Model A (1928-31) 08-28-2019, 11:19 AM
Replies: 3
Views: 303
Posted By Planojc
Re: floor pan color

Thanks Brent
Forum: Model A (1928-31) 08-28-2019, 09:36 AM
Replies: 3
Views: 303
Posted By Planojc
floor pan color

Were the floor pans and back side of the trunk lid painted black or body color? Thanks.
Forum: Early V8 (1932-53) 08-17-2019, 08:45 AM
Replies: 12
Views: 1,006
Posted By Planojc
Re: Got the call

Yes you can leave the tires on, just get it high enough to roll it out. Then remove the torque tube and drive shaft and replace with the Mitchell. You will love it.
Forum: Early V8 (1932-53) 08-09-2019, 08:22 AM
Replies: 183
Views: 10,983
Posted By Planojc
Forum: Model A (1928-31) 08-01-2019, 08:42 AM
Replies: 30
Views: 1,917
Posted By Planojc
Re: misdiagnosis based on assumptions

Most broken axles are due to axle nut not torqued properly.
Forum: Early V8 (1932-53) 07-15-2019, 07:30 AM
Replies: 4
Views: 449
Posted By Planojc
Forum: Early V8 (1932-53) 07-13-2019, 06:59 AM
Replies: 33
Views: 1,830
Posted By Planojc
Forum: Early V8 (1932-53) 07-05-2019, 08:03 AM
Replies: 18
Views: 1,098
Posted By Planojc
Re: overdrive

I have found many Borg-Warner relays with as much as a two volt drop due to bad connections inside the relay. If you remove the cover you will see that all connections are made with rivets and over...
Forum: Early V8 (1932-53) 07-04-2019, 07:26 AM
Replies: 18
Views: 1,098
Posted By Planojc
Re: overdrive

If you are talking about a BW overdrive, I have done this but only in an emergency. My OD would not kick in while on a long trip so I wired a switch from the battery to the Sol just to get me home. I...
Forum: Early V8 (1932-53) 06-26-2019, 07:52 AM
Replies: 13
Views: 854
Posted By Planojc
Re: Crab Distributor Question

I like Charlie's price better.
Forum: Model A (1928-31) 06-22-2019, 05:31 PM
Replies: 8
Views: 728
Posted By Planojc
Re: 31 Roadster Question

The area that I'm referring to is from the door back to the wheel well. The quarters are attached to the sub rails on the bottom with sheet metal tabs that are part of the bottom of the quarter...
Forum: Model A (1928-31) 06-22-2019, 10:00 AM
Replies: 8
Views: 728
Posted By Planojc
31 Roadster Question

Some of the tabs are rusted off on the bottom of a 31 roadster rear quarter panel so I'm thinking about welding new tabs to the inside of the panel? Any other suggestions on a better fix? Thanks
Forum: Early V8 (1932-53) 06-22-2019, 08:39 AM
Replies: 21
Views: 1,658
Posted By Planojc
Re: Need an electrical genius, don't know where to turn.

Great answers and no one said it should be posted somewhere else.
Forum: Early V8 (1932-53) 05-31-2019, 08:58 AM
Replies: 40
Views: 2,871
Posted By Planojc
Re: A Young Mans Questions

When folks ask me how long I've had my 35 Ford, I like to tell them that I bought it new and I only have one more payment to make.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:06 PM.