Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: captndan
Forum: Model A (1928-31) 05-18-2023, 07:12 AM
Replies: 11
Views: 1,983
Posted By captndan
Re: 1930 model a leaking water

If the temp stays in the green drive it and carry an extra gallon of water. Overfilling is common.
Forum: Model-T 01-28-2023, 08:40 AM
Replies: 0
Views: 507
Posted By captndan
WTB Very nice brass T

Looking for a nice brass model T. Ready to drive.
Forum: Model A (1928-31) 01-12-2023, 09:57 AM
Replies: 12
Views: 1,699
Posted By captndan
Re: 12 volt aux battery grounded to frame??

Correct....But make up your mind and go all 12v or all 6v.. A combination is just inviting trouble.
Forum: Model-A 01-31-2022, 12:33 PM
Replies: 0
Views: 503
Posted By captndan
Horn

Wanted, 12V Model A horn.
Forum: Model A (1928-31) 09-22-2020, 10:52 AM
Replies: 36
Views: 6,318
Posted By captndan
Re: Ignition timing question

I had one that was so full of crud you could not feel it. had to pull the cover.
If you do be sure to drill the dimple out a little.
Forum: Model A (1928-31) 03-30-2020, 03:54 PM
Replies: 28
Views: 11,099
Posted By captndan
Re: Crime Does Not Pay.

I used recycled oil $.26 a quart. That old metro loved it.
Forum: Model A (1928-31) 03-21-2020, 09:33 AM
Replies: 20
Views: 3,467
Posted By captndan
Forum: Model A (1928-31) 03-02-2020, 11:21 AM
Replies: 24
Views: 4,720
Posted By captndan
Re: Sidemount Spare Installation Problem

Let the air out of the tire.
Forum: Model A (1928-31) 02-19-2020, 04:44 PM
Replies: 12
Views: 2,397
Posted By captndan
Re: Oil - again

Rotella T and don't worry about the little stuff.
Forum: Model A (1928-31) 02-19-2020, 04:39 PM
Replies: 2
Views: 1,130
Posted By captndan
Re: 7-tooth steering column/sector change and repair...

I say don't mess with it. Go with F150.
Forum: Model A (1928-31) 02-19-2020, 04:29 PM
Replies: 55
Views: 9,206
Posted By captndan
Re: spark plug caps

They are only penny's from the suppliers. Not worth the effort to mess about. I get mine from Bert's.
Forum: Model A (1928-31) 02-19-2020, 04:25 PM
Replies: 44
Views: 6,761
Posted By captndan
Re: Preferred Vendor for parts?

Bert's all the way.
Forum: Model A (1928-31) 02-07-2020, 04:34 PM
Replies: 16
Views: 2,936
Posted By captndan
Re: Model A gas tank cleaning

OMG! Don't waste your time and money on any of these fixes! There is only one way to do it right. Use a cut off wheel and cut the tank along the seam. Have it sand blasted then have a good welder...
Forum: Model A (1928-31) 02-07-2020, 04:25 PM
Replies: 28
Views: 5,656
Posted By captndan
Re: “Do not use a file” to dress down breaker points

If you're stuck out on the road use what eve you have. If you're in town don't be so darn cheap. Go buy a new set.
Forum: Model A (1928-31) 01-29-2020, 04:30 PM
Replies: 14
Views: 2,308
Posted By captndan
Re: spark plug connector pictures

The pictures are correct. 1234
Forum: Model A (1928-31) 01-18-2020, 10:55 AM
Replies: 12
Views: 3,284
Posted By captndan
Re: Current 6 Volt Positive Ground Turn Signal Recommendation

When you buy the switch from a major supplier just tell them what voltage and ground.
Forum: Model A (1928-31) 01-18-2020, 10:52 AM
Replies: 15
Views: 1,918
Posted By captndan
Re: Head light focusing procedure

Just loosen the nut on the bottom and point the lights wherever you want.
Forum: Model A (1928-31) 01-14-2020, 10:48 AM
Replies: 6
Views: 1,712
Posted By captndan
Re: Fresh overhaul & modern lube'

Lucas or STP in the tranny is not a good idea. The high speed gears will throw it to the side of the case where it will stick. Thus reducing to total amount of lubricant in the tranny. 600W is...
Forum: Model A (1928-31) 12-26-2019, 01:36 PM
Replies: 8
Views: 2,145
Posted By captndan
Re: High Point on Cam

Better yet is borrow a dial indicator then mark the cam with something like finger polish.
Forum: Model A (1928-31) 12-17-2019, 08:03 AM
Replies: 21
Views: 32,339
Posted By captndan
Re: Head Bolt Torque-Hot or Cold?

The condition of the studs and nuts is more important. New American made studs and nuts are a must. Then hot warm or cold is much less important.
Forum: Model A (1928-31) 12-06-2019, 09:05 AM
Replies: 7
Views: 7,404
Posted By captndan
Forum: Model A (1928-31) 11-11-2019, 03:50 PM
Replies: 58
Views: 13,589
Posted By captndan
Re: Cracked Block

A (good) welder can fix that crack. Amateurs usually cannot.
Forum: Model A (1928-31) 11-11-2019, 03:45 PM
Replies: 7
Views: 1,633
Posted By captndan
Re: Water Glass

Yes. Some stop leaks today contain water glass. All depends on the crack.
Forum: Model A (1928-31) 11-11-2019, 03:42 PM
Replies: 21
Views: 4,029
Posted By captndan
Re: One note to modern engine oils

If your engine is smoking don’t worry about what oil. An overhaul is in order then use Rotella T.
Forum: Model A (1928-31) 11-11-2019, 12:20 PM
Replies: 21
Views: 4,029
Posted By captndan
Re: One note to modern engine oils

Just run Rotella T 15-40 and never look back.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:30 AM.