Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: flatheadmurre
Forum: Early V8 (1932-53) 01-12-2016, 04:32 AM
Replies: 44
Views: 14,933
Posted By flatheadmurre
Re: Blower motor center main cap

Never said i installed them torqued into the block.
Just that i was told they should be loaded so the loctite doesnt get between the surfaces of the thread distributing the load when torqued later....
Forum: Early V8 (1932-53) 01-11-2016, 05:18 PM
Replies: 44
Views: 14,933
Posted By flatheadmurre
Re: Blower motor center main cap

I installed large studs and it was very specific installed heights and we had spacers on and preloaded every bolt to specs.
And this was Loctites products and their techs teaching us.
But perhaps...
Forum: Early V8 (1932-53) 01-11-2016, 02:33 PM
Replies: 44
Views: 14,933
Posted By flatheadmurre
Re: Blower motor center main cap

I was told the threads should be loaded before it sets.
Other wise when you tighten it up the loctite starts to move if you go over the holding point.
Showing results 1 to 3 of 3

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:57 AM.