Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Ken/Alabama
Forum: Early V8 (1932-53) 12-04-2019, 07:22 PM
Replies: 82
Views: 2,267
Posted By Ken/Alabama
Re: Do You Carry a Container of Gas in your Trunk?

That would be a big NO for me. I drive my cars almost daily. I even take trips in them from time to time so for me it’s no different than driving my wife’s 2014 Ford Explorer , I don’t carry around...
Forum: Early V8 (1932-53) 12-01-2019, 10:28 PM
Replies: 6
Views: 286
Posted By Ken/Alabama
Re: Oil Pressure Reading

I ran into the same program when I fired up the V12 in my Zephyr. The dash gauge reads 0-50. I was reading low oil pressure . Screwed a mechanical gauge in the block to verify it actually had good...
Forum: Early V8 (1932-53) 12-01-2019, 10:14 PM
Replies: 6
Views: 284
Posted By Ken/Alabama
Re: Arm rest interior help

Pretty sure that’s not the correct arm rest for the 40 Fordor rear . The Fordor has the arm rest made into the side panel board and it all goes in as a unit then nailed in place into the tacking...
Forum: Early V8 (1932-53) 11-27-2019, 07:04 PM
Replies: 18
Views: 555
Posted By Ken/Alabama
Re: Updating a 33/34 radio.

http://www.turnswitch.com/ These folks can help you. They did the radio for my 39 Zephyr.
Forum: Early V8 (1932-53) 11-25-2019, 06:52 PM
Replies: 3
Views: 229
Posted By Ken/Alabama
Re: distributor inner caps

How many more sets you need ?? I’ve got a bunch but don’t want to sell all of them.
Forum: Early V8 (1932-53) 11-25-2019, 06:49 PM
Replies: 3
Views: 229
Posted By Ken/Alabama
Re: distributor inner caps

This is your go to man for that.
Forum: Early V8 (1932-53) 11-23-2019, 11:19 AM
Replies: 21
Views: 717
Posted By Ken/Alabama
Re: 1940 Ford Tailight Conversion to LED lenses or bulbs

I’m still running a 6 volt system but those bulbs are available in 12 volt also. I installed a relay to keep from burning out the brake switch on the master cylinder because of the higher amp draw on...
Forum: Early V8 (1932-53) 11-23-2019, 08:11 AM
Replies: 21
Views: 717
Posted By Ken/Alabama
Re: 1940 Ford Tailight Conversion to LED lenses or bulbs

I put 32 Ford headlight bulbs in mine.
Forum: Early V8 (1932-53) 11-21-2019, 07:32 PM
Replies: 13
Views: 410
Posted By Ken/Alabama
Re: 33 engine noise

Had similar noise in a 34 Ford once.
Forum: Early V8 (1932-53) 11-21-2019, 07:32 PM
Replies: 13
Views: 410
Posted By Ken/Alabama
Re: 33 engine noise

Don’t rule out the front main drive bearing in the transmission .
Forum: Early V8 (1932-53) 11-21-2019, 04:26 PM
Replies: 40
Views: 2,538
Posted By Ken/Alabama
Re: Could It Be :The rare 1940 Ford Deluxe Electric Clock

Here’s a couple pictures of the one I have .
Forum: Early V8 (1932-53) 11-16-2019, 08:44 PM
Replies: 7
Views: 682
Posted By Ken/Alabama
Re: Stock 40 Coupe

Try pulling out on the choke to see if it picks up. If I understand your post correctly, it runs ok as long as your pressing on the gas peddle.
Forum: Early V8 (1932-53) 11-16-2019, 12:42 PM
Replies: 11
Views: 336
Posted By Ken/Alabama
Re: What Lube do you put in your Columbia S/W Speedo Changer?

Make sure the speedometer cables going in and out of the Changer isn’t dry also .
Forum: Early V8 (1932-53) 11-16-2019, 07:15 AM
Replies: 4
Views: 519
Posted By Ken/Alabama
Re: Glass etching kits ... date “bugs”

The bug for the 39 Zephyr is same as Ford.
Forum: Early V8 (1932-53) 11-12-2019, 08:00 PM
Replies: 24
Views: 683
Posted By Ken/Alabama
Re: Honoring our veterans

My Dad , Drafted in spring of 1951 after he and mom were married in Jan of 1951. Spent two years over seas. He died 29 years ago today..
Forum: Early V8 (1932-53) 11-09-2019, 05:33 PM
Replies: 19
Views: 722
Posted By Ken/Alabama
Re: 1934 Missing -Covering My Bases

Also check the ignition switch itself on the column drop. They get dirty and burned over time.
Forum: Early V8 (1932-53) 11-05-2019, 11:22 AM
Replies: 8
Views: 380
Posted By Ken/Alabama
12 volt starter solenoid

Anyone have a current part number for a 1950 Ford starter solenoid but 12 volt version ? Has two large post and one small post for the push button.
Forum: Early V8 (1932-53) 11-02-2019, 05:48 PM
Replies: 1
Views: 111
Posted By Ken/Alabama
Re: 226-6 Running Rich

Set float lower. I had a 47 coupe with a G series 6 and fought that same battle. It fixed mine .
Forum: Early V8 (1932-53) 11-02-2019, 05:45 PM
Replies: 5
Views: 326
Posted By Ken/Alabama
Re: who owns a '40 standard fordor sedan?

That was first 40. Sold it to build my new shop when I moved. Wish I could find it.
Forum: Early V8 (1932-53) 11-02-2019, 05:43 PM
Replies: 4
Views: 349
Posted By Ken/Alabama
Re: Trunk side panels

Well, it’s always good to know what you working on ???
Forum: Early V8 (1932-53) 10-29-2019, 01:09 PM
Replies: 6
Views: 448
Posted By Ken/Alabama
Re: Hydraulic brake adjustments.

Me too & I’ve been using dot 5 in my 40 for the last 23 years without any issues.
Forum: Early V8 (1932-53) 10-29-2019, 10:23 AM
Replies: 2
Views: 413
Posted By Ken/Alabama
Re: Moonshine time

I went. Fair crowd considering the weather. Cloudy and some sprinkles on Friday . Cloudy windy an drizzle all day Saturday. Clear and sunny on Sunday for the trip home. Put 622 miles on the old 40...
Forum: Early V8 (1932-53) 10-21-2019, 07:08 PM
Replies: 11
Views: 408
Posted By Ken/Alabama
Re: Help bearing race removal F1 hub

What Skidmarks said!!
Forum: Early V8 (1932-53) 10-19-2019, 01:44 PM
Replies: 58
Views: 2,048
Posted By Ken/Alabama
Re: Top three Ford Products, '32 - '53

32 3 window, 39 Lincoln Zephyr Coupe , 40 Ford
Forum: Early V8 (1932-53) 10-16-2019, 07:20 PM
Replies: 7
Views: 396
Posted By Ken/Alabama
Re: 1953 Sun Distributor Machine - schematic

http://www.paramountd.com/service.html
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:11 AM.