Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 92
Search took 0.01 seconds.
Search: Posts Made By: 39deluxecp
Forum: Early V8 10-10-2020, 07:45 PM
Replies: 0
Views: 122
Posted By 39deluxecp
60 HP Ford v8 parts wanted

Need parts for my 60 hp flathead engine. Oil pan, fuel pump, carburetor, crank pulley and crank mounted fan. Generator also.



Call me at 712-579-0447 Henry. Thanks
Forum: Late V8 08-27-2020, 03:14 PM
Replies: 0
Views: 197
Posted By 39deluxecp
1955 t-bird for sale

Frame off restoration. 351 Cleveland and C4. Call 712-579-0447 or message me.
Forum: Late V8 (1954+) 07-31-2020, 09:04 PM
Replies: 5
Views: 421
Posted By 39deluxecp
Stop light switch used for safety starter switch?

Why not use the hydraulic brake stoplight switch for the safety starter switch?. Just connect the wires for the starter solenoid through the brake switch. Then the brake pedal will have to be...
Forum: Late V8 (1954+) 07-31-2020, 08:50 PM
Replies: 15
Views: 623
Posted By 39deluxecp
Re: 1956 Thunderbird brake question

There are smaller diameter boosters available that should clear the battery. I would check in to one with dual booster diaphragms.
Forum: Late V8 (1954+) 07-26-2020, 04:21 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

I am going to go back to the original jets, then set the timing, and carb.i bought a new 750 Holley so that when I replace this 351 with the 408 stroker I am replacing it with next winter the carb...
Forum: Late V8 (1954+) 07-26-2020, 12:27 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Hallalua!! I found the missfire at full throttle problem!

asked my son what he thought might be causing the backfire and loss of power under load. He crawled under the car to check the fuel lines...
Forum: Late V8 (1954+) 05-30-2020, 03:05 PM
Replies: 23
Views: 1,217
Posted By 39deluxecp
Re: idle adjusting needles

if it does not affect the idle, the idle passages are plugged
Forum: Late V8 (1954+) 05-30-2020, 03:04 PM
Replies: 12
Views: 980
Posted By 39deluxecp
Re: Y block fuel pump

must be a stuck or inoperative check valve in the pump.
Forum: Late V8 (1954+) 05-06-2020, 06:45 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

I ty it was stale gas.
Forum: Late V8 (1954+) 05-05-2020, 02:25 PM
Replies: 9
Views: 439
Posted By 39deluxecp
Re: 57 fairlane 4dr

yes, most of the "57 parts will fit the "55. Not all. one is 6 volt, other 12 volt as I am sure you know. I would jump on it, not many parts cars fpr 55-57 fprds, we raced the hell out of them on our...
Forum: Early V8 (1932-53) 05-05-2020, 02:18 PM
Replies: 22
Views: 1,029
Posted By 39deluxecp
Re: Valve Spring Shim Question

if the valve seats are cut too far down, makes everything else lots harder to do. it the block needs new seats, better to do it.
Forum: Early V8 05-01-2020, 03:42 PM
Replies: 0
Views: 190
Posted By 39deluxecp
1939 ford deluxe windshield frame

rust in lower outer corners. 1 good glass, other is cracked. plus shipping. Thanks Ford Barn.
Forum: Late V8 (1954+) 05-01-2020, 03:19 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

E85 to the rescue!!! after a new 180* edelbrock manifold, bigger (92) jets in the primary and secondary , new autolite 26 plugs, various timing adjustments, I put in a half tank of good old E85 to...
Forum: Late V8 (1954+) 04-30-2020, 03:12 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Just wanted to give an update. I replaced the sparkplugs with autolite 26 , which is 2 heat ranges hotter than the 24 that were in it. Ran much better, but it is still cutting out at higher load and...
Forum: Late V8 (1954+) 04-27-2020, 11:01 AM
Replies: 16
Views: 881
Posted By 39deluxecp
Re: dif gear ratio

I like 4.11
Forum: Late V8 (1954+) 04-25-2020, 03:28 PM
Replies: 24
Views: 1,261
Posted By 39deluxecp
Re: Which PS fluid

IHC hytrans fluid
Forum: Late V8 (1954+) 04-25-2020, 03:23 PM
Replies: 5
Views: 425
Posted By 39deluxecp
Re: oil flow

The pushrods are hollow on a Chevy at supply oil to the rockers. 272 has no oil passage in pushrods.
Forum: Late V8 (1954+) 04-21-2020, 06:31 PM
Replies: 7
Views: 516
Posted By 39deluxecp
Re: 64 Galaxie rear brake cylinder

This station wagon and 427 engined cars had bigger brake than a cheep 6 banger custom
Forum: Late V8 (1954+) 04-21-2020, 06:24 PM
Replies: 10
Views: 676
Posted By 39deluxecp
Re: 351 cleveland engine

All the same pump
Forum: Late V8 (1954+) 04-19-2020, 09:50 AM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

I have used this distributor before and it worked fine. If I had another distributor I would try it.i do believe it is ignition.buying all new duraspark components runs into a few bucks to. I have...
Forum: Late V8 (1954+) 04-18-2020, 08:19 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Keeps me out of the bars!!!
Forum: Late V8 (1954+) 04-18-2020, 06:57 PM
Replies: 3
Views: 406
Posted By 39deluxecp
Re: How to adjust a HOLLY 4 BARREL CARB

If the choke is not opening all the way, it may be stuck on high idle cam
Forum: Late V8 (1954+) 04-18-2020, 06:00 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

Sorry for the delay. Been too cold to mess with the car.tbe distributor is a cheep $50.00 self contained with the module in the distributor.i have checked and re checked float level, timing, vacuum...
Forum: Late V8 (1954+) 04-12-2020, 01:39 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

14" vacuum at idle in nuetral. 38* advance at 3,000 rpm, vacuume advance disconnected.
Forum: Late V8 (1954+) 04-12-2020, 01:37 PM
Replies: 42
Views: 2,387
Posted By 39deluxecp
Re: 351c miss/backfire under load?

no difference in miss of engine with vacuum advance connected or not. The distributor is a China quality product. I got a reading of .04 ohms and 7.38 ohms on the coil. limits are .04 to 2.0 . and...
Showing results 1 to 25 of 92

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:57 PM.