Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 80
Search took 0.01 seconds.
Search: Posts Made By: Als48
Forum: Early V8 (1932-53) 10-14-2021, 10:34 AM
Replies: 640
Views: 42,657
Posted By Als48
Re: 1932 The Deuce, Dually, Dump Truck

Right Chris, I'm thoroughly enjoying your thread. I'm also a tractor guy. I've recently rebuilt and painted the '54 Ford NAA my grandad bought new. It's always been in the family. Had to re-sleeve...
Forum: Early V8 (1932-53) 10-08-2021, 04:04 PM
Replies: 640
Views: 42,657
Posted By Als48
Re: 1932 The Deuce, Dually, Dump Truck

Sugarmaker, I'm lovin that ole truck! Wish I had one like it. It reminds me of one my brother had, which was a '34 Pickup hot-rodded a little with a C... engine. I shoulda bought it before his...
Forum: Early V8 (1932-53) 10-08-2021, 04:03 PM
Replies: 640
Views: 42,657
Posted By Als48
Re: 1932 The Deuce, Dually, Dump Truck

Sugarmaker, I'm lovin that ole truck! Wish I had one like it. It reminds me of one my brother had, which was a '34 Pickup hot-rodded a little with a C... engine. I shoulda bought it before his...
Forum: Early V8 (1932-53) 10-08-2021, 03:45 PM
Replies: 67
Views: 2,289
Posted By Als48
Re: Help Im Lost

You can use #14 or #16 Gauge wire. A jumper cable with alligator clips would be great if small enough to connect at the coil.

Al H
Forum: Early V8 (1932-53) 10-07-2021, 12:35 PM
Replies: 7
Views: 376
Posted By Als48
Re: Help with passenger's door handle/upholstery

Of course you should be sure that you have the inner handle in the unlocked position to allow the outer lever to operate.
Forum: Early V8 (1932-53) 10-05-2021, 12:09 PM
Replies: 7
Views: 271
Posted By Als48
Re: Holley 94 carb spring and detent

A magnet might work! Al H
Forum: Early V8 (1932-53) 09-29-2021, 08:18 AM
Replies: 640
Views: 42,657
Posted By Als48
Re: 1932 The Deuce, Dually, Dump Truck

Hi Sugarmaker, Any chance Ford tractor points and condenser would work in the distributor?

Al Hook
Forum: Early V8 (1932-53) 09-23-2021, 11:01 AM
Replies: 33
Views: 1,234
Posted By Als48
Re: 52 Flathead crankshaft end play

Hey, Rembrandt, Krylon 32 from Nebraska sells T-5 Adapter plates. I used one in my 48 Super Deluxe. Check the classified section. Good luck with your ring gear.

Al Hook
Forum: Early V8 (1932-53) 09-20-2021, 02:32 PM
Replies: 33
Views: 1,234
Posted By Als48
Re: 52 Flathead crankshaft end play

I have an 11" clutch on my Olds engine which was purchased as an Astro Van clutch. 4.3 Engine '85-90.

Al Hook
Forum: Early V8 (1932-53) 09-07-2021, 10:10 AM
Replies: 39
Views: 1,583
Posted By Als48
Re: '32 rear transmission mount

SB or not, I'm impressed with the firewall/cowl work. Keep going forward!

Al Hook
Forum: Early V8 (1932-53) 09-06-2021, 11:28 AM
Replies: 32
Views: 1,011
Posted By Als48
Re: 1936 Ford 1.5 ton 4 speed Transmission jumps out of 4th gear

Wasn't there a company called Gear Vendor who sold over/under drive add-on transmissions for motor homes and trucks a few years ago? Haven't heard of them on this forum. That would be an option for...
Forum: Model A (1928-31) 09-03-2021, 12:16 PM
Replies: 22
Views: 1,609
Posted By Als48
Re: Model A Mechanic

Who's the fellow in Punta Gorda who sells parts? He would know someone to contact.
Forum: Early V8 (1932-53) 08-24-2021, 10:00 AM
Replies: 640
Views: 42,657
Posted By Als48
Re: 1932 The Deuce, Dually, Dump Truck

Sugarmaker,

This is an awesome thread! I enjoy reading about your truck adventures.

Al Hook
Forum: Early V8 (1932-53) 08-09-2021, 09:05 AM
Replies: 18
Views: 1,042
Posted By Als48
Re: OK, so it is older

My dad allowed a logger to harvest some red oak trees off of the family farm around 2001. He was happy to get $10,000 for the trees, but they made a terrible mess of the land with the rubber tired...
Forum: Early V8 (1932-53) 08-02-2021, 10:52 AM
Replies: 31
Views: 1,454
Posted By Als48
Re: 49 F1 Clutch problem

Put it in high gear and hold the brake. Then try to start it. That will quite likely unstick the disc.

Al Hook
Forum: Early V8 (1932-53) 07-31-2021, 11:45 AM
Replies: 28
Views: 1,761
Posted By Als48
Re: Finally starting my 35s juice brake conversion

Or put the nut on backwards! But who would do that?
Forum: Early V8 (1932-53) 07-26-2021, 11:13 AM
Replies: 66
Views: 8,133
Posted By Als48
Re: '40 front fenders

That's a very cool rear shot with your Grandaughter.
Forum: Early V8 (1932-53) 07-26-2021, 10:17 AM
Replies: 12
Views: 687
Posted By Als48
Re: vin search

Right, David G. That's what I found when I tried to research my VIN on my 48 Ford in Kentucky. No early records were kept even tho I found a name to look for. Still don't know anything about its...
Forum: Early V8 (1932-53) 07-23-2021, 04:06 PM
Replies: 1
Views: 238
Posted By Als48
Re: Mart's Update 2021Ep30Pt1 32 Sedan progress.

Good work Mart, as always some good working tips.

Al Hook
Forum: Early V8 (1932-53) 07-22-2021, 01:03 PM
Replies: 39
Views: 2,324
Posted By Als48
Re: I'm a turncoat...

Weren't those straight eights? About 327 C I?

Al H
Forum: Early V8 (1932-53) 07-21-2021, 09:02 AM
Replies: 39
Views: 2,324
Posted By Als48
Re: I'm a turncoat...

The family name may be different, but they look like cousins to me. Nice Hudson.

Al H
Forum: Early V8 (1932-53) 07-20-2021, 09:11 AM
Replies: 14
Views: 839
Posted By Als48
Re: 1940 ford pickup brakes

Check to verify that all of your lug nuts are tight.

Al Hook
Forum: Early V8 (1932-53) 07-11-2021, 04:45 PM
Replies: 9
Views: 430
Posted By Als48
Re: 35 PU Broken door handle mechanism

Do you have a working key for the lock? Make sure it's not in the locked position. Of course you probably already thought of that.

Al Hook
Forum: Early V8 (1932-53) 06-03-2021, 11:46 AM
Replies: 25
Views: 1,171
Posted By Als48
Re: swap 1946 spindle left to right?

I had a set of spindles modified to accept GM disc brakee hubs and seals back in the 70's. If I remember correctly, I had to reduce the seal and inner bearing diameter and shorten the spindle an...
Forum: Early V8 (1932-53) 06-02-2021, 09:46 AM
Replies: 24
Views: 1,342
Posted By Als48
Re: 34 wheel/tire combo for roller

You might also find Suzuki Sidekick/Chevy Geo Tracker wheels at the local scrap yard. 5 on 5 1/2 also Jeep CJ maybe Cherokee, but not Wagoneer .
Showing results 1 to 25 of 80

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:02 AM.