Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.14 seconds.
Search: Posts Made By: redmodelt
Forum: Model A (1928-31) 07-04-2020, 12:00 PM
Replies: 11
Views: 362
Posted By redmodelt
Re: Which headlight wire for high/low beam

"32/32 should have identical filaments. You can flip it over if one filament burns out. Longer filament length = higher resistance, lower CP. Does it have a number on it?"


The one filament...
Forum: Model A (1928-31) 07-04-2020, 11:44 AM
Replies: 17
Views: 503
Posted By redmodelt
Re: Water in oil/engine

Living in Oregon and where my T is stored, I get the same thing. Short drives never gets the engine hot enough to burn off the condensation. Worried me to no end till I pressure checked the block...
Forum: Model A (1928-31) 07-01-2020, 09:32 PM
Replies: 31
Views: 1,170
Posted By redmodelt
Re: 600w oil

If you really want to mess with them ask for steam cylinder oil! LOL :)
Forum: Model A (1928-31) 07-01-2020, 09:31 PM
Replies: 26
Views: 3,846
Posted By redmodelt
Re: Ammco brake shoe chart

You need to start your own post and ask. Slim chance that someone will see this unless they are interested in the subject of the post and know of him. Last time he was on line was around the 20th of...
Forum: Model A (1928-31) 07-01-2020, 09:22 PM
Replies: 21
Views: 3,522
Posted By redmodelt
Forum: Model A (1928-31) 07-01-2020, 10:11 AM
Replies: 26
Views: 3,846
Posted By redmodelt
Re: Ammco brake shoe chart

While he has been on line in the V8 section today, this one is from 2016-17 so you might send a PM or email to get his attention because he may not be looking in the Model A section.
Forum: Model T (1909-1927) 06-30-2020, 08:58 PM
Replies: 8
Views: 518
Posted By redmodelt
Re: Montana 500 accident

I am thinking the same thing.
Forum: Model T (1909-1927) 06-30-2020, 01:34 PM
Replies: 8
Views: 518
Posted By redmodelt
Re: Montana 500 accident

This is not a sanctioned event by the Model T Ford Club of America. Here is a link to the 2019 rules;
http://www.antiqueautoranch.com/montana500/rules/2019rules.pdf
Forum: Model T (1909-1927) 06-30-2020, 09:05 AM
Replies: 8
Views: 518
Posted By redmodelt
Re: Montana 500 accident

https://www.facebook.com/groups/103574776049/
Forum: Questions & Suggestions 06-29-2020, 11:26 AM
Replies: 1
Views: 1,101
Posted By redmodelt
Re: 40 Ford sill plates correct installation

Suggestions, yes post your questions in the Early V8 section. This section is for questions about the site not car questions. While some will see it here, few will reply.
Forum: Model T (1909-1927) 06-28-2020, 07:51 PM
Replies: 2
Views: 340
Posted By redmodelt
Re: Guide to replace wood in a touring car

Not really re the videos and tutorias. Might take a look at You Tube. There is stuff on the web but you will need to search it out. Fordwood.com has some good drawings and there has been stuff posted...
Forum: Model A (1928-31) 06-28-2020, 12:45 AM
Replies: 15
Views: 853
Posted By redmodelt
Re: Your best method for drilling out rivets?

How about something like this;
https://ak-builder.com/index.php?dispatch=products.view&product_id=30649
Forum: Model A (1928-31) 06-24-2020, 10:55 AM
Replies: 12
Views: 651
Posted By redmodelt
Re: Headlights and tail lights

Adding the cowl lights to the system will not add that much draw on the system, not much more then adding another tail light. He isn't asking about having both high and low beams on at the same time.
Forum: Questions & Suggestions 06-24-2020, 10:45 AM
Replies: 2
Views: 505
Posted By redmodelt
Re: I'd like some help identifying these parts

Hi! This section isn't for car questions it is for questions about the site. Few people look and even fewer reply.

The only way to view your photos is to right click and click view image. If you...
Forum: Questions & Suggestions 06-24-2020, 10:39 AM
Replies: 1
Views: 195
Posted By redmodelt
Re: PM Box

On the right side there are boxes to check off that you want to remove. You will see your messages in groups. For example; you might see "OLDER" on the left then over on the right you will see a box...
Forum: Model T (1909-1927) 06-24-2020, 08:35 AM
Replies: 3
Views: 771
Posted By redmodelt
Re: 1926 4 door phaeton front bumper brackets and bumper

No on the diagram or instructions. The bumper shown is aftermarket not Ford supplied. I think if it was made for a Model T, it would be for 1925 back and may have used the "L" brackets to mount to...
Forum: Model A (1928-31) 06-23-2020, 08:47 AM
Replies: 7
Views: 354
Posted By redmodelt
Re: smith-gordon frame question

Here are a whole lot of pages on the Smith Air Compressors;


https://www.google.com/search?client=firefox-b-1-d&q=Ford+Model+a+Smith+air+compresso...
Forum: Questions & Suggestions 06-21-2020, 08:42 AM
Replies: 1
Views: 483
Posted By redmodelt
Re: flathead engine Help

He has also asked the question on the Early V8 forum.
Forum: Model A (1928-31) 06-20-2020, 09:02 AM
Replies: 17
Views: 828
Posted By redmodelt
Re: distributor wire

If you already have the switch this will work;
https://www.snydersantiqueauto.com/ProductDetail/A-11575-ER_REPLACEMENT-SWITCH-ORIGINAL-CABLE?fromCategory=Products/model-a/ignition-switch
Don't...
Forum: Model A (1928-31) 06-19-2020, 10:27 PM
Replies: 8
Views: 691
Posted By redmodelt
Re: Dsitributor Sight Glass Drip Oiler

Why not just replace the upper shaft with one that has the hole already in it.
Forum: Model A (1928-31) 06-18-2020, 08:58 PM
Replies: 13
Views: 491
Posted By redmodelt
Re: How do you install a metal valve stem?

[QUOTE=shew01;1900514]I found the description on the web site, but installation still doesn’t make sense to me. You actually cut out a good rubber stem to use these?

Yes, that is how it is done or...
Forum: Model A (1928-31) 06-18-2020, 10:28 AM
Replies: 2
Views: 339
Posted By redmodelt
Re: Clutch Stuck Disengaged

https://www.fordbarn.com/forum/showthread.php?t=282619
Forum: Model A (1928-31) 06-16-2020, 09:26 PM
Replies: 16
Views: 559
Posted By redmodelt
Re: Marvel Carb fuel line difference

The Eaton and Weatherhead part number is 1513. This is for the 1/4" tube with 1/8NPT male and 1/2-20 Model A female threads.
Forum: Model A (1928-31) 06-16-2020, 12:59 PM
Replies: 26
Views: 908
Posted By redmodelt
Re: No electricity. No crank. No horn

Don't think it's a solenoid, you would have to press the starter pedal then a starter button for that setup to work. Might be a disconnect, which shouls be on the other leg of the battery anyway. If...
Forum: Model A (1928-31) 06-14-2020, 07:49 PM
Replies: 49
Views: 1,447
Posted By redmodelt
Re: 29 Tudor charging system question

RE" Also (and you may think I'm nuts) turn the headlights on for about 10 minutes with the engine off to take some of the charge out of the battery. Then start the engine and read the volts when...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:33 AM.