Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Jim/GA
Forum: Model A (1928-31) Yesterday, 08:55 PM
Replies: 26
Views: 1,845
Posted By Jim/GA
Re: Westach Ammeters.

Understood. Thx.
Forum: Model A (1928-31) Yesterday, 05:04 PM
Replies: 26
Views: 1,845
Posted By Jim/GA
Re: Westach Ammeters.

Did you receive it? How does it fit? Would you recommend?
Forum: Model A (1928-31) 04-14-2024, 09:23 AM
Replies: 9
Views: 603
Posted By Jim/GA
Re: 2024 Old Car Festival - Greenfield Village

That page still has the 2023 OCF information, not 2024.
Forum: Model A (1928-31) 04-14-2024, 09:17 AM
Replies: 12
Views: 2,111
Posted By Jim/GA
Re: Installing tie rods without removing backing plate?

I do not think these will fit in the tight space between the backing plate and the tie rod end screw slot. I may be wrong. I have not tried it (yet).

I am out of town right now, I will try it on...
Forum: Model A (1928-31) 04-14-2024, 09:07 AM
Replies: 23
Views: 1,215
Posted By Jim/GA
Re: Nu Rex ignition switch

We reconnected a couple of wires where they attach to the switch and where they attach to the coil. That's about it.

You will also want to be sure your cable going into the distributor is screwed...
Forum: Model A (1928-31) 04-07-2024, 09:13 PM
Replies: 18
Views: 930
Posted By Jim/GA
Re: Differential Pinion Gear Bearing Preload

Bob, would it be possible for you to post scans of those pages here so that we can read the entire procedure in context?

It is not clear to me where the in-lbs of torque you are quoting are to be...
Forum: Model A (1928-31) 04-01-2024, 07:51 AM
Replies: 10
Views: 580
Posted By Jim/GA
Re: Separator

I like my cast iron bulb separator on my car. Every now and then I will open the little drain valve and let some fuel run into a clear glass jar, to look for water in the gas.

We have discovered...
Forum: Model A (1928-31) 03-26-2024, 07:27 AM
Replies: 11
Views: 700
Posted By Jim/GA
Re: Upper Front floorboard reinforcements?

The dowel is not reinforcing the joint as much as it is reinforcing the top wooden board where 2 deep notches have been cut into them. The narrow rectangular pieces to the left of the clutch pedal...
Forum: Model A (1928-31) 03-25-2024, 03:13 PM
Replies: 5
Views: 530
Posted By Jim/GA
Re: Zenith carburetor

It's a Z.

Manufactured by Zenith (H for Holly and no mark for Ford if it's a Zenith-3).

Zenith was the design holder for the carburetor, but they licensed it out to be manufactured by others to...
Forum: Model A (1928-31) 03-24-2024, 12:53 PM
Replies: 5
Views: 382
Posted By Jim/GA
Re: 29 standard phaeton belt rails

A photo would help, holding the wooden pieces up where you are considering mounting them.
Forum: Model A (1928-31) 03-22-2024, 02:13 PM
Replies: 13
Views: 765
Posted By Jim/GA
Re: Model T & Model A Show at the Beardsley Cider Mill

It might be. You can't tell from this angle. You need a photo of the rear quarter.
Forum: Model A (1928-31) 03-22-2024, 09:04 AM
Replies: 16
Views: 1,412
Posted By Jim/GA
Re: Town Car

It is hard to tell a real Town Car from a "made one up from a Fordor Sedan" Town Car replica, unless you look at it from the back. It is pretty easy to make the rest of the car look correct.

Look...
Forum: Model A (1928-31) 03-22-2024, 08:55 AM
Replies: 13
Views: 765
Posted By Jim/GA
Re: Model T & Model A Show at the Beardsley Cider Mill

Town Car, not Town Sedan.

I run into this a lot.

A lady called me because her dead husband had left a Town Car in their garage. She did some internet searching and found reference to how rare...
Forum: Model A (1928-31) 03-22-2024, 08:46 AM
Replies: 16
Views: 1,412
Posted By Jim/GA
Re: Town Car

There were 96 Town Cars made in 1930 (Great Depression beginning to hit).

They made 1,013 Town Cars in 1929 (peak year of the Roaring 20's boom).

They made 89 in 1928 (ramping up production).
...
Forum: Model A (1928-31) 03-22-2024, 08:21 AM
Replies: 6
Views: 613
Posted By Jim/GA
Re: model A airplane carburetor?

Yes, I believe so.

See original page number 1772b (file page n39) of the magazine "Aviation Week" in the link below. They refer to fitting a Stromberg NA-R3 carburetor (same as the data plate on...
Forum: Model A (1928-31) 03-17-2024, 11:43 AM
Replies: 11
Views: 1,362
Posted By Jim/GA
Re: Finding a nice Model A

Have a paint shop do a computer scan of the existing paint that want to match.

Do a test spray with that to confirm the match.

No paint code or formula will match existing old, aged paint....
Forum: Model A (1928-31) 03-16-2024, 05:12 PM
Replies: 11
Views: 1,362
Posted By Jim/GA
Re: Finding a nice Model A

Not the bodies, only the fenders, splash apron, etc., beneath the body.

Andalusite Blue was available for many body styles in '28/'29. It is a very dark blue, almost black. It looks black when not...
Forum: Model A (1928-31) 03-16-2024, 05:06 PM
Replies: 3
Views: 367
Posted By Jim/GA
Re: Evans waterless coolant

No, it does not. You have a problem.

It's primarily propylene glycol, the same as Sierra coolant.
Forum: Model A (1928-31) 03-14-2024, 07:25 AM
Replies: 24
Views: 837
Posted By Jim/GA
Re: 1929 TwoLite headlamps w/ LED turn signals

The main difference is the brightness of the two. Parking Light is only about 3 cp. Not too bright. Turn Signals need to be bright, like 32 cp or so.

I have seen turn signal controllers that...
Forum: Model A (1928-31) 03-14-2024, 07:19 AM
Replies: 24
Views: 837
Posted By Jim/GA
Re: 1929 TwoLite headlamps w/ LED turn signals

I agree with you about the cold blue light from the focused LED headlights, I don't like it. I prefer the warm white of the incandescent bulbs. But I like to see, and you can't beat the light beam...
Forum: Model A (1928-31) 03-13-2024, 08:28 PM
Replies: 24
Views: 837
Posted By Jim/GA
Re: 1929 TwoLite headlamps w/ LED turn signals

Joe, you raise some good points!

1. If you want the second socket inside the headlight reflector to serve as both Parking Light and Turn Signal bulb, you need to rewire it with a 2-filament bulb...
Forum: Model A (1928-31) 03-12-2024, 06:28 PM
Replies: 24
Views: 837
Posted By Jim/GA
Forum: Model A (1928-31) 03-12-2024, 11:45 AM
Replies: 24
Views: 837
Posted By Jim/GA
Re: 1929 TwoLite headlamps w/ LED turn signals

Here's a video of what the LED amber turn signal bulbs look like in the spot you ask about. They also serve as a 3 cp amber parking light bulb there. This is a 12 volt neg. grd. car.
...
Forum: Model A (1928-31) 03-10-2024, 08:40 PM
Replies: 26
Views: 2,087
Posted By Jim/GA
Re: Cash Value/Sale History of Red Grow's "Betsy"?

https://www.tapkat.org/model-a-ford-foundation-inc/q5pnpk
Forum: Model A (1928-31) 03-07-2024, 10:48 PM
Replies: 9
Views: 974
Posted By Jim/GA
Re: Fluted Headlight lenses?

The TwoLite system was rolled out starting in Feb. 1929, so that's when the fluted lenses started to go away. I have seen flutes on cars made as late as March 1929.

It seems to me like the...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:09 PM.