Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Don Rogers
Forum: Early V8 (1932-53) Yesterday, 10:08 PM
Replies: 19
Views: 685
Posted By Don Rogers
Re: Head bolt washers

Getting back to the original question.....Here is the correct washer used in the 1935-36 time frame.
Forum: Early V8 (1932-53) 09-17-2019, 11:16 PM
Replies: 25
Views: 883
Posted By Don Rogers
Re: Ropy Nacewicz Hardware business reopen date

Good luck Michael and Thank You!!!!
Forum: Early V8 (1932-53) 09-17-2019, 07:09 PM
Replies: 19
Views: 685
Posted By Don Rogers
Re: Head bolt washers

1935 and 1936 Chassis parts books show (42) 351428-S-7 washers used on both alum. and cast iron heads. Washers may have been eliminated in later years on cast iron heads.
Forum: Early V8 (1932-53) 09-09-2019, 09:34 AM
Replies: 42
Views: 1,541
Posted By Don Rogers
Re: 1936 floorboard screws

Frank, By the time the green bible was published 12+ years after 1935/36, a lot of the special fastners were either obsoleted or superseded by more common "fits-all" fastners.

If you look at...
Forum: Early V8 (1932-53) 09-09-2019, 08:24 AM
Replies: 42
Views: 1,541
Posted By Don Rogers
Re: 1936 floorboard screws

David, Here's another oddity...The speedometer cable to firewall(dash) clip on 1935/36 passenger cars is held in place by a 1/4"-20 x 1 round head machine screw (26547-S2). But the same clip on...
Forum: Early V8 (1932-53) 09-08-2019, 11:44 AM
Replies: 42
Views: 1,541
Posted By Don Rogers
Re: 1936 floorboard screws

One further note regarding floorboard screws........Ford Pickups/Panel Deliveries/full size trucks in 1935 and 1936 used 12-24 flat head machine screws and recessed washers to hold the floorboards in...
Forum: Early V8 (1932-53) 09-07-2019, 05:10 PM
Replies: 42
Views: 1,541
Posted By Don Rogers
Re: 1936 floorboard screws

The screws were flat head machine screws. When properly installed with counter sink washers they are flush with the floor.
Forum: Early V8 (1932-53) 08-19-2019, 04:59 AM
Replies: 2
Views: 187
Posted By Don Rogers
Re: 1936 rear shock position

This should help.
Forum: Early V8 (1932-53) 08-15-2019, 10:45 PM
Replies: 9
Views: 597
Posted By Don Rogers
Re: Ford V8 Cars and Trucks

Floyd Clymer also reprinted Victor's book and sold it under the name Early V-8 Ford Service Manual.
Forum: Early V8 (1932-53) 08-15-2019, 02:56 PM
Replies: 45
Views: 1,701
Posted By Don Rogers
Re: Who all going to Auburn National Meet???

Mary and I will be there. Looking forward to the meet.

Note: If you make any signs, buttons, etc with Ford Barn logo, you will need to get Ford Barn's permission. (aka Ryan)
Forum: Early V8 (1932-53) 08-15-2019, 12:33 PM
Replies: 9
Views: 597
Posted By Don Rogers
Re: Ford V8 Cars and Trucks

I'm sure that there was significant financial motivation also!!! LOL!
Forum: Early V8 (1932-53) 08-15-2019, 07:45 AM
Replies: 9
Views: 597
Posted By Don Rogers
Re: Ford V8 Cars and Trucks

Victor Page published maintenance manuals for the Model T and Model A. He published his first V-8 manual for the 1932 and 1933 Fords some time between 1933 and 1935.(Tan Book) The next completely...
Forum: Early V8 (1932-53) 08-13-2019, 08:59 AM
Replies: 3
Views: 267
Posted By Don Rogers
Re: Are '35 and '36 seat springs interchangeable?

Here's the link to snydersantiqueauto.com
Forum: Early V8 (1932-53) 08-12-2019, 09:37 AM
Replies: 6
Views: 406
Posted By Don Rogers
Re: H-10 Two rib spark plugs?

The H-10 2 rib was supplied up to WWII. By the end of the war most applications used the 5-rib design. The H-10 was used on many automotive and non-automotive applications, including lawn mowers...
Forum: Early V8 (1932-53) 08-07-2019, 09:50 PM
Replies: 13
Views: 562
Posted By Don Rogers
Re: 35 rumble lid

Here are some photos that show the various components involved with the conversion. In addition to the drip lip being modified, the lock strikers have to be switched, rumble pivot arms installed, a...
Forum: Early V8 (1932-53) 07-28-2019, 09:57 PM
Replies: 7
Views: 698
Posted By Don Rogers
Re: 36 Cabriolet original shocks and links

Besides being described in the 35-36 Book, here is some first hand source information. The drawing showing a 3" shock link came from The Benson Ford Research Center and parts listing 4 identical...
Forum: Early V8 (1932-53) 07-11-2019, 10:30 PM
Replies: 4
Views: 292
Posted By Don Rogers
Re: 1936 horn relay

There was no relay with the Ford production horns on 35 and 36 Cars. There was however a Sparton C-L-9 set of air horns mode for the 35-36 Fords that used a relay.
Forum: Early V8 (1932-53) 07-09-2019, 04:24 AM
Replies: 5
Views: 369
Posted By Don Rogers
Re: Mechanical brake rods

Dave, Here's a chart comparing 32-33-34 brake rods.
Forum: Early V8 (1932-53) 07-02-2019, 10:01 PM
Replies: 1
Views: 292
Posted By Don Rogers
Re: 1936 gastank

Gas tanks were painter Black medium luster enamel. Ford # M-1724
Forum: Early V8 (1932-53) 06-26-2019, 10:52 PM
Replies: 6
Views: 351
Posted By Don Rogers
Re: side curatin storarge - '36 roadster

I believe that the "big pouch" for the roadster is called the top curtain container ass'y and has the part # 48-715720. I do not have any drawings of this item. It will go on my list for my next...
Forum: Early V8 (1932-53) 06-19-2019, 10:31 PM
Replies: 12
Views: 875
Posted By Don Rogers
Re: Flathead V8 album Vol 1 & 2

Jeff, I coordinated the printing of the book for Scot and there were 500 copies printed.

Don Rogers
Forum: Early V8 (1932-53) 06-18-2019, 08:30 PM
Replies: 6
Views: 421
Posted By Don Rogers
Re: 35 Ford coupe taillight wiring

Here are some images that I put together on the tail light wiring.

Don Rogers
Forum: Early V8 (1932-53) 06-18-2019, 08:12 PM
Replies: 8
Views: 548
Posted By Don Rogers
Re: 36 Car Headlight buckets

The Bratton clip should do the trick with a few holes drilled for rivets
Forum: Early V8 (1932-53) 06-12-2019, 08:22 AM
Replies: 4
Views: 337
Posted By Don Rogers
Re: 35 Pickup Pin Stripe

Jakno, Here are some photos that might help. Factory pinstripe for Dearborn blue is Poppy Red.
Forum: Early V8 (1932-53) 05-30-2019, 05:14 PM
Replies: 6
Views: 335
Posted By Don Rogers
Re: 51 Merc sedan power seat wiring

Here's a wiring diagram and hydraulic diagram showing the seat controls.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:51 PM.