Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 341
Search took 0.02 seconds.
Search: Posts Made By: Herb Concord Ca
Forum: Model A (1928-31) 10-14-2020, 02:14 PM
Replies: 20
Views: 1,082
Posted By Herb Concord Ca
Re: Starter . . . Rebuild or Rebuilt?

I carefully cut through the wall with a hacksaw blade. It's easy going cutting bronze. Then use a punch to break it apart.
Forum: Model A (1928-31) 10-12-2020, 04:11 PM
Replies: 19
Views: 798
Posted By Herb Concord Ca
Re: New member and project

There are a few MAFCA chapters in your area. They would be a good source of information and or help.
Forum: Model A (1928-31) 10-12-2020, 04:07 PM
Replies: 6
Views: 448
Posted By Herb Concord Ca
Re: U joint felt seals.. how do you fit them?

The felt seals should be rectangular not square. The narrowest width should fit into the clam shell slots with a little help.
Forum: Model A (1928-31) 10-12-2020, 04:05 PM
Replies: 17
Views: 539
Posted By Herb Concord Ca
Re: Rusty Coolant

If you use Water and Water Wetter, it will not prevent rust. You need to use an anti-rust product.
Forum: Model A (1928-31) 10-12-2020, 04:01 PM
Replies: 3
Views: 327
Posted By Herb Concord Ca
Re: Generator rebuild question

The field wire without a lug goes to ground, either ground to the case inside or connect to the ground brush. The wire with the lug connects to the movable brush. While apart, make sure the...
Forum: Model A (1928-31) 10-12-2020, 03:52 PM
Replies: 20
Views: 1,082
Posted By Herb Concord Ca
Re: Starter . . . Rebuild or Rebuilt?

Best to try using the insulated brushes as is. You need a micro torch or a high wattage iron to remove and replace them. Clean the 4 brushes and brush holders with solvent, use a curved pick to...
Forum: Model-A 10-10-2020, 09:23 PM
Replies: 0
Views: 129
Posted By Herb Concord Ca
Hi-Boy air filter

Looking for a "Hi Boy" Model A air filter to fit a zenith or Tillotson carb.
Forum: Model A (1928-31) 10-02-2020, 01:38 PM
Replies: 10
Views: 672
Posted By Herb Concord Ca
European Classic Tires

Has any one purchased these tires? If you purchased a set, how do you like them?
They are advertised in The Restorer magazine.
Thanks
Forum: Model A (1928-31) 09-25-2020, 01:57 PM
Replies: 4
Views: 324
Posted By Herb Concord Ca
Re: 6v t0 12 v

I have had a Laycock overdrive on 2 6 Volt cars, It worked fine on both. To check the solenoid operation, run a jumper wire (16 or 14 gauge) from battery to solenoid terminal, should hear a click. ...
Forum: Model A (1928-31) 09-21-2020, 12:30 PM
Replies: 18
Views: 785
Posted By Herb Concord Ca
Re: Starter failure

Try#2 response or remove the starter and clean the brushes, brush holders and commutator oil the two bushing and put it back together. Test starter before installing, should spin up to 2000-3000 rpm...
Forum: Model A (1928-31) 09-21-2020, 12:17 PM
Replies: 19
Views: 768
Posted By Herb Concord Ca
Re: Just had a Model A wedding

On behalf of the Diablo A's, Concord CA, I want to wish Mike and Heather all the best. And yes, Heather enjoys the Model A as much as Mike.
Forum: Model-A 09-21-2020, 12:05 PM
Replies: 1
Views: 304
Posted By Herb Concord Ca
Forum: Model A (1928-31) 09-12-2020, 07:02 PM
Replies: 12
Views: 385
Posted By Herb Concord Ca
Re: Four-Ways Work, Turn Signals Don't !!!

First 6 ohms is too high, are you sure they are 6 ohms? You should use two 1 ohm resistors, one for the right side and one for the left. Best if they are installed in the wires going to the front...
Forum: Model A (1928-31) 09-11-2020, 01:03 PM
Replies: 12
Views: 435
Posted By Herb Concord Ca
Re: Shock fluid test results

Hi Bob, thanks for your detailed explanation. Looking forward for more of your experiments.
Thanks for your work!
Forum: Model A (1928-31) 09-10-2020, 08:46 PM
Replies: 12
Views: 435
Posted By Herb Concord Ca
Re: Shock fluid test results

Hi Bob, I too have some worn shocks, in my case pitted. Can you post your reason for plugging the lower bypass hole in the rotor? I, and I think others would be interested in you logic on this!
Forum: Model-A 09-09-2020, 12:55 PM
Replies: 1
Views: 304
Posted By Herb Concord Ca
Kari Keen trunk

Kari Keen Trunk Black needs repainting. Base is 35 by 14.
Posting for a friend. $300 plus shipping.
For pictures of the trunk, call Bob Grady 925-788-1276.
Forum: Model A (1928-31) 08-29-2020, 09:52 PM
Replies: 5
Views: 375
Posted By Herb Concord Ca
Re: Main Jet for Tillotson and Marvel Carburetors

Thanks Patrick for your reply. I have 9 main jets with 3 holes and 2 with 2 holes. I wasn't counting the hole near the bottom in the turned down area just above the threaded portion. I only use...
Forum: Model A (1928-31) 08-21-2020, 02:59 PM
Replies: 5
Views: 375
Posted By Herb Concord Ca
Main Jet for Tillotson and Marvel Carburetors

I have repaired both of these carburetors. Most main jets and the ones that vendors sell have 3 holes on side of the jet. I have 2 jets with only 2 holes on the side.
Anyone have any ideas on...
Forum: Model A (1928-31) 08-17-2020, 03:04 PM
Replies: 13
Views: 787
Posted By Herb Concord Ca
Re: *** Annual MAFCA Voting for Directors ***

I have met Jim, at the Annual awards banquet in OK City a few years ago. Jim is a good guy and would recommend voting for him, That's what i am going to do. Good luck Jim!
Forum: Model A (1928-31) 08-14-2020, 02:55 PM
Replies: 31
Views: 1,236
Posted By Herb Concord Ca
Re: Ford from Holland

Welcome Clint, in the picture of the engine compartment, I see you have a air conditioner installed, I also have a a/c installed in my town sedan, do you use it much in the Netherlands? I see an air...
Forum: Model A (1928-31) 08-03-2020, 12:41 PM
Replies: 1
Views: 165
Posted By Herb Concord Ca
Forum: Model A (1928-31) 08-03-2020, 12:38 PM
Replies: 34
Views: 1,664
Posted By Herb Concord Ca
Re: Electronic ignition advise

The way I connected mine was direct from battery post to fuse to ignition switch. The wire on the plate is a ground wire and connected to a good chassis ground.
Forum: Model A (1928-31) 07-29-2020, 09:50 PM
Replies: 8
Views: 621
Posted By Herb Concord Ca
Re: Snyders EZ Steer Kit A-3305-SE

I have these kits on both my Model A's, one for 20 years. Best to use with re-balled steering arms.
Forum: Model A (1928-31) 07-29-2020, 09:47 PM
Replies: 30
Views: 1,286
Posted By Herb Concord Ca
Re: Battery Isolator switch

Aquadave, if you have an alternator in place of a generator, you may have an internal leakage in the alternator and will discharge your battery in a few days. Best to pull the fuse mounted on the...
Forum: Model A (1928-31) 07-11-2020, 09:28 PM
Replies: 18
Views: 1,042
Posted By Herb Concord Ca
Re: Checking 6 volt neg ground output with multi meter

First you should use an Analog multimeter. A digital meter will not read steady unless it has a good filtering circuit. Most 6 volt positive alternators (don't know about 6 volt negative...
Showing results 1 to 25 of 341

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:06 PM.