Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: big35
Forum: Early V8 03-19-2020, 12:33 PM
Replies: 0
Views: 986
Posted By big35
hinge mirror arms for big truck

I need 2 - hinge mirror arms for a 1 1/2 ton truck. These measure 21" and are for a 2" hinge. Thanks

Arms found and bought. Thanks
Forum: Early V8 (1932-53) 08-09-2018, 04:08 PM
Replies: 19
Views: 3,346
Posted By big35
Re: 1935 model 51

The '38 motor is a 24 stud and has a 3 bolt distributor pattern. I did install the '35 distributor just to see if I can get the '38 motor running. It will not start but I do have power at the coil...
Forum: Early V8 (1932-53) 08-09-2018, 11:40 AM
Replies: 19
Views: 3,346
Posted By big35
Re: 1935 model 51

Will a my 1935 distributor work on this 1938 motor?
Forum: Early V8 (1932-53) 05-31-2018, 08:16 PM
Replies: 19
Views: 3,346
Posted By big35
Re: 1935 model 51

Thanks
Forum: Early V8 (1932-53) 05-31-2018, 08:15 PM
Replies: 19
Views: 3,346
Posted By big35
Re: 1935 model 51

Yes with 131" wheel base.
Forum: Early V8 (1932-53) 05-30-2018, 06:16 PM
Replies: 19
Views: 3,346
Posted By big35
Re: 1935 model 51

I was lucky to find this locally..twice. The 1st time 8 years ago it was in front of an appliance store with a sign saying 'this truck was used to haul your grandmother's refrigerator to her'. It...
Forum: Early V8 (1932-53) 05-30-2018, 05:27 PM
Replies: 19
Views: 3,346
Posted By big35
Re: 1935 model 51

Thanks for the comments! My 1st issue is the 19" on center, front mounts on my 35 vs. the 20" water pump mounts on the 38 motor. I will also need spacers to get the front of the motor clearance off...
Forum: Early V8 (1932-53) 05-29-2018, 02:47 PM
Replies: 19
Views: 3,346
Posted By big35
1935 model 51

I am new to the Ford Barn and have enjoyed searching through the great information you guys share daily. I am in the process of getting my 1935 truck model 51 up and running. I am replacing the...
Showing results 1 to 8 of 8

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 10:06 AM.