Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Chuck Sea/Tac
Forum: Model A (1928-31) 08-19-2019, 05:26 PM
Replies: 27
Views: 821
Posted By Chuck Sea/Tac
Re: Coil failure ?

Well, it’s obvious the coil is trying to work, because your amp meters moving. Have you checked for spark at the coil wire to ground. Coils do fail, but not as often as people think.
Forum: Model A (1928-31) 08-18-2019, 04:04 PM
Replies: 9
Views: 509
Posted By Chuck Sea/Tac
Re: "B" on top of Model A Ford cylinder head

It is a higher compression had made by Ford for the police and emergency type vehicles. I believe it’s 5.2 ratio.
Forum: Model A (1928-31) 08-18-2019, 03:15 PM
Replies: 10
Views: 669
Posted By Chuck Sea/Tac
Re: Twisted cylinder head

I had my 5.5 milled because it wasn’t straight right out of the box.
Forum: Model A (1928-31) 08-17-2019, 07:25 PM
Replies: 10
Views: 669
Posted By Chuck Sea/Tac
Forum: Model A (1928-31) 08-17-2019, 07:24 PM
Replies: 28
Views: 1,103
Posted By Chuck Sea/Tac
Re: Sanity check on lubing springs in place

I just jack one end of the car at a time up high, enough so that jackstands under the frame will let the wheels and spring hang as far down as it’ll go. Then I use like a motorcycle chain lube or...
Forum: Model A (1928-31) 08-16-2019, 02:05 PM
Replies: 10
Views: 690
Posted By Chuck Sea/Tac
Re: Too funny

It would be interesting to know if he sells it!
Forum: Model A (1928-31) 08-14-2019, 11:57 AM
Replies: 12
Views: 430
Posted By Chuck Sea/Tac
Re: Radiator overflow

On a plus note, with a slightly non sealing cap, you’ll know when there’s a problem. Assuming you don’t have a temp gauge.
Forum: Model A (1928-31) 08-13-2019, 09:09 PM
Replies: 9
Views: 506
Posted By Chuck Sea/Tac
Re: Leakless Water Pump

There were/are several different designs of “leakless” water pumps. If you’re mechanical, take it apart and see what style it is, and you’ll most likely be able to find parts and repair it. Otherwise...
Forum: Model A (1928-31) 08-13-2019, 03:55 PM
Replies: 15
Views: 758
Posted By Chuck Sea/Tac
Re: Flared copper washers for gaskets?

You can buy flare Gaskets already made from your local refrigeration supply house. If you’re making it by compressing a flat washer you’re already compressing the copper. The reason for the flare...
Forum: Model A (1928-31) 08-11-2019, 04:34 PM
Replies: 11
Views: 629
Posted By Chuck Sea/Tac
Forum: Model A (1928-31) 08-09-2019, 12:11 PM
Replies: 7
Views: 440
Posted By Chuck Sea/Tac
Re: Tubular Shock Link

for steering, start with moving the steering wheel and watching the Pitman arm. That needs to be totally tight where it Attaches to the sector shaft. If the movement is in the steering box, then...
Forum: Model A (1928-31) 08-08-2019, 06:03 PM
Replies: 15
Views: 615
Posted By Chuck Sea/Tac
Re: 30 Model A Zenith Carb

Sometimes the float sticks from just sitting awhile. If it keeps hanging up, then take it apart and make sure there isn’t a worn dimple where the shut of stem rides against the brass. Also some of...
Forum: Model A (1928-31) 08-07-2019, 06:56 PM
Replies: 17
Views: 670
Posted By Chuck Sea/Tac
Re: Dry Camshaft Gear

Time to pull your pan and check that oil screen. Although, I wonder how you been running it with a strict timing year :-). It would not be a bad idea to pull the pan though
Forum: Model A (1928-31) 08-05-2019, 02:40 PM
Replies: 8
Views: 461
Posted By Chuck Sea/Tac
Re: Distributor question

I just helped a club member out with this same problem. Not only was the tab not matching the contour of the spring loaded plate, but the tab was at an angle so only one little corner was rubbing...
Forum: Model A (1928-31) 08-04-2019, 06:25 PM
Replies: 28
Views: 1,217
Posted By Chuck Sea/Tac
Re: Service Truck

Maybe someone has a picture of Barb’s telephone truck they could post. I can’t remember if it had a box or bed. JW Hash would know, as he’s worked on it.
Forum: Model A (1928-31) 08-04-2019, 06:20 PM
Replies: 12
Views: 601
Posted By Chuck Sea/Tac
Re: oil out of the carburetor

I would say, if you have oil coming out of the carburetor and burning oil smoke, you have a cracked block, most likely in around an intake valve. Bad news. Pull the manifolds and valve cover and...
Forum: Model A (1928-31) 08-04-2019, 02:35 PM
Replies: 13
Views: 508
Posted By Chuck Sea/Tac
Re: Battery Discharge

If you didn’t see a draw, then the cut out is probably OK at this point, because if it was stuck then there would be a draw . So it sounds like it’s erratic. I would hook everything back up check...
Forum: Model A (1928-31) 08-04-2019, 02:27 PM
Replies: 15
Views: 674
Posted By Chuck Sea/Tac
Re: Is a gasket needed between transmission and bell housing?

He said between the bell housing and transmission. Not engine and fly housing.
Call Mitchell, since they sent the gasket.
Forum: Model A (1928-31) 08-01-2019, 04:38 PM
Replies: 10
Views: 552
Posted By Chuck Sea/Tac
Re: Crankshaft pulley question

Thatís what I was going to mention : the special washer/shim that the venders sell to make it work.
Forum: Early V8 (1932-53) 07-29-2019, 02:53 PM
Replies: 15
Views: 682
Posted By Chuck Sea/Tac
Talking Re: For Minnesota guys with cars that are still 6 volt

Except for when you break down 5 miles up a backroads short cut by Petes house, with NO cell service. Then you rely on friends with you and the occasional friendly local.
Forum: Model A (1928-31) 07-28-2019, 06:40 PM
Replies: 8
Views: 1,045
Posted By Chuck Sea/Tac
Forum: Model A (1928-31) 07-28-2019, 06:21 PM
Replies: 16
Views: 1,313
Posted By Chuck Sea/Tac
Re: Tire Dressing

I just googled this, and watched the video. Looks like good stuffó water-based. Too bad I didnít read this on Friday, because I swung by Griots in Tacoma and picked up the car washing supplies...
Forum: Model A (1928-31) 07-28-2019, 06:02 PM
Replies: 25
Views: 1,457
Posted By Chuck Sea/Tac
Talking Re: Take a gander at this.

What years is the Franklin, how many cylinders, and how much does it weigh?
At least you wonít have a radiator in your way!
Forum: Model A (1928-31) 07-22-2019, 01:50 PM
Replies: 23
Views: 1,103
Posted By Chuck Sea/Tac
Re: How Old Are Your Tires?

Hereís a riverside for ya! Evidently didnít like the sitting in the sun that day!
Forum: Model A (1928-31) 07-21-2019, 11:11 PM
Replies: 25
Views: 1,269
Posted By Chuck Sea/Tac
Re: Current BEST TIRES for daily driver?

How fast are you driving? The Lucas tires I had several years ago seemed to wander above 50. I sold them and went back to Michelins, and the car handled better again. When these are gone, I going...
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:52 PM.