Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: Bob C
Forum: Model A (1928-31) Yesterday, 11:48 AM
Replies: 11
Views: 332
Posted By Bob C
Re: Front end alignment question

It is normal because of the camber, the wheels are out at the top
and in at the bottom.
Forum: Model A (1928-31) Yesterday, 11:45 AM
Replies: 22
Views: 527
Posted By Bob C
Re: 30 Coupe Cooling question

What are the things that the arrows are pointing at? The splash plate should
look like the one in the radiator drawing.
Forum: Model A (1928-31) 03-02-2021, 06:37 PM
Replies: 6
Views: 294
Posted By Bob C
Re: front crossmember

Nope, it's factory.
Forum: Early V8 (1932-53) 03-02-2021, 11:09 AM
Replies: 64
Views: 1,485
Posted By Bob C
Re: My first dumb question

I think what you are seeing is the foot throttle, hand throttle and
choke linkage.
Forum: Early V8 (1932-53) 02-28-2021, 05:57 PM
Replies: 5
Views: 188
Posted By Bob C
Re: starter solenoid

Are you working on a stock '32 or a hot rod. Stock had no solenoid and the yellow horn wire came from the headlight switch at the bottom of the steering column.
Forum: Model A (1928-31) 02-28-2021, 05:29 PM
Replies: 11
Views: 306
Posted By Bob C
Re: 1928 drive shaft removal

How about posting a picture so we can see what you have.
Forum: Early V8 (1932-53) 02-28-2021, 05:27 PM
Replies: 5
Views: 188
Posted By Bob C
Re: starter solenoid

What wiring diagram are you using?
Forum: Early V8 (1932-53) 02-28-2021, 01:39 PM
Replies: 13
Views: 437
Posted By Bob C
Re: 1939 right rear drum install

Also be sure to clean all that grease off the axle and hub taper, needs to
be squeaky clean.
Forum: Model A (1928-31) 02-19-2021, 03:51 PM
Replies: 4
Views: 328
Posted By Bob C
Re: Canadian Patent Plate

Like this. https://www.mikes-afordable.com/product/A18650C.html
Forum: Model A (1928-31) 02-18-2021, 09:32 PM
Replies: 9
Views: 347
Posted By Bob C
Re: AA truck radiator question

This is a AA radiator shell that takes the thicker radiator, notice no widows peak.
Forum: Model A (1928-31) 02-18-2021, 06:53 PM
Replies: 9
Views: 347
Posted By Bob C
Re: AA truck radiator question

Yes and no. In April 1930 they went to a wider 4 row of tube radiator.
Forum: Model A (1928-31) 02-18-2021, 06:46 PM
Replies: 1
Views: 147
Posted By Bob C
Re: AA truck front end question

The Feb 1936 Service Bulletins show the A and AA camber and toe the same, the
AA has a little less caster.
Forum: Model A (1928-31) 02-16-2021, 01:35 PM
Replies: 11
Views: 437
Posted By Bob C
Re: 1931 Wide Bed Pickup Cowl band

Yes, page E-88 of the Judging Standards.
Forum: Model A (1928-31) 02-16-2021, 12:24 PM
Replies: 25
Views: 3,548
Posted By Bob C
Re: Engine Bearings

This started in post 16 when the thread was high jacked instead of starting a new thread.
Forum: Model A (1928-31) 02-16-2021, 12:07 PM
Replies: 11
Views: 437
Posted By Bob C
Re: 1931 Wide Bed Pickup Cowl band

Body color is correct.
Forum: Early V8 (1932-53) 02-16-2021, 11:31 AM
Replies: 9
Views: 340
Posted By Bob C
Re: 1936 Intake manifold

Cab Over Engine
Forum: Early V8 (1932-53) 02-16-2021, 11:30 AM
Replies: 23
Views: 1,270
Posted By Bob C
Re: Flathead identification

As Alan mentioned, not a truck oil pan.
Forum: Model A (1928-31) 02-15-2021, 05:49 PM
Replies: 20
Views: 870
Posted By Bob C
Re: Rear axle housing grease zerk question

This is from page 361 of the Service Bulletins.


Rear axle shaft, drive shaft, and rear wheel
grease retainers, part numbers A-4245 and
A-1175, must be installed with the sharp edge
of the...
Forum: Early V8 (1932-53) 02-14-2021, 07:41 PM
Replies: 6
Views: 246
Posted By Bob C
Re: 47 pickup 100vs60 mph speedometer

Do the odometers read accurately?
Forum: Early V8 (1932-53) 02-14-2021, 07:16 PM
Replies: 2
Views: 147
Posted By Bob C
Re: F-1 Brake/Clutch pedal support question

In the parts book is shows a pin at the grease fitting end of the shaft.
The shaft looks like part # O1T-7606 and the bushings B-7526-A
Forum: Early V8 (1932-53) 02-14-2021, 11:28 AM
Replies: 5
Views: 310
Posted By Bob C
Re: wiper motor ID?

A little late to the party but I have Trico catalogs that cover 1927-1946
and I didn't see KSB 600 listed.
Looks like OldGold is right, a universal motor.
Forum: Model A (1928-31) 02-13-2021, 02:12 PM
Replies: 20
Views: 1,166
Posted By Bob C
Re: B Carb Questions

This is out of print and no longer available. To bad it was a great book.
Forum: Model A (1928-31) 02-12-2021, 05:23 PM
Replies: 7
Views: 445
Posted By Bob C
Re: NewRex Ignition Switch with Auxiliary Position

The ignition shouldn't be on when it's turned to ACC.
Forum: Early V8 (1932-53) 02-11-2021, 12:01 PM
Replies: 2
Views: 419
Posted By Bob C
Re: K R wILSON TOOL

How about a picture??
Forum: Model A (1928-31) 02-10-2021, 05:35 PM
Replies: 6
Views: 403
Posted By Bob C
Re: Front Brake operating pin

Model A drums are 11", 1932 are 12"
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:32 PM.