Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: TinCup
Forum: Model A (1928-31) 12-19-2018, 06:02 PM
Replies: 0
Views: 266
Posted By TinCup
Model B Distributor Swap

I have always misunderstood that to use the Model B distributor in that you had to wire your existing ignition cable to the distributor. Since I have finally been schooled correctly If you have made...
Forum: Model A (1928-31) 10-31-2018, 09:52 AM
Replies: 4
Views: 524
Posted By TinCup
Distributor Oiler and Bushings.

Occasionally when rebuilding a distributor I will run across the remnants of some type of wick in the side oiler chamber. No part exists in any catalogue I have seen nor have any of the online...
Forum: Model-A 10-09-2018, 06:16 PM
Replies: 0
Views: 281
Posted By TinCup
Late 31 Distributor Body

I am looking for the later distributor body with the closed clip holders. I have a ton of early stuff but would like to build one to match my October 31 car.
Forum: Model A (1928-31) 09-13-2018, 08:59 AM
Replies: 6
Views: 355
Posted By TinCup
Re: Need Videos for Trans and clutch

google is your best friend in this endeavor.
Forum: Model A (1928-31) 08-27-2018, 03:26 PM
Replies: 71
Views: 9,081
Posted By TinCup
Re: UPDATE....Ok so a brand new radiator and it still runs hot

I have installed 6 Bergs radiators without a single problem. Family run business that makes a big difference to me. I have installed only one Brassworks and I had a hard time getting the radiator...
Forum: Model A (1928-31) 08-27-2018, 03:15 PM
Replies: 71
Views: 9,081
Posted By TinCup
Re: UPDATE....Ok so a brand new radiator and it still runs hot

My old radiator was fine as long as the temps didn't get above 75 degrees. It too was a 2 row 8 fin. Had it flushed twice. It just takes 3 cores to do the job.
Forum: Model A (1928-31) 08-27-2018, 03:01 PM
Replies: 71
Views: 9,081
Posted By TinCup
Re: UPDATE....Ok so a brand new radiator and it still runs hot

There is a much more detailed post here in the barn. Radiator ended up being an aftermarket 2 core radiator. Stock radiator was three core. Bought a replacement from Bergs Radiator and all is good...
Forum: Model A (1928-31) 08-20-2018, 03:22 PM
Replies: 25
Views: 1,805
Posted By TinCup
Re: Don't ask me how

No not at all.
Forum: Model A (1928-31) 08-19-2018, 04:00 PM
Replies: 25
Views: 1,805
Posted By TinCup
Re: Don't ask me how

I already posted in the wanted section and at this point the only venue I haven't tried is the telegraph. The whole point here is I don't want to have to put more money in the machine shop. Yes I...
Forum: Model A (1928-31) 08-19-2018, 11:15 AM
Replies: 25
Views: 1,805
Posted By TinCup
Re: Don't ask me how

Just trying to get this back together without a trip to the machine shop.
Forum: Model A (1928-31) 08-18-2018, 09:52 AM
Replies: 25
Views: 1,805
Posted By TinCup
Don't ask me how

Reassembling a motor that a club member brought back from New York state all went well until this piston decided to not to cooperate. The pistons are 120 over and finding replacements has turned out...
Forum: Model-A 08-18-2018, 09:45 AM
Replies: 0
Views: 197
Posted By TinCup
120 over Pistons Needed

1 of the 4 120 pistons is cracked and cannot be reused. Would rather not bore to 125. I need 1 or all 4 if you have them.
Forum: Model A (1928-31) 04-22-2018, 05:03 PM
Replies: 16
Views: 1,577
Posted By TinCup
Forum: Model A (1928-31) 04-21-2018, 10:12 AM
Replies: 16
Views: 1,577
Posted By TinCup
Re: radiator fan efficiency

More facts to ponder.
Forum: Model A (1928-31) 04-07-2018, 09:45 AM
Replies: 6
Views: 632
Posted By TinCup
Re: Vacuum wiper motor Rebuilt Kit?

I bought a kit from Snyder's and from Bratton's. You already know that sometimes they sell the same thing but in this case they were different. On each kit the replacement paddle was crap and since...
Forum: Model A (1928-31) 03-16-2018, 06:26 PM
Replies: 45
Views: 3,096
Posted By TinCup
Re: Won't run without choke

If the passage from the secondary well is plugged it will do the same thing. First time I found this was rebuilding a side bowl carb like this one. This will plug the cap jet. I have heard timing...
Forum: Model A (1928-31) 03-12-2018, 01:00 PM
Replies: 23
Views: 2,568
Posted By TinCup
Re: Installed the Simmons Super Power head

That's a thing of beauty. Now you need a Simmons Carb like mine.
Forum: Model A (1928-31) 03-12-2018, 12:57 PM
Replies: 14
Views: 1,051
Posted By TinCup
Re: Zenith carb stall

Sounds like the float may be too low. This is a common issue on the Zenith carb which is why in 1932 the float design was changed so that the float was perpendicular to the car not inline. When you...
Forum: Model A (1928-31) 03-12-2018, 10:45 AM
Replies: 17
Views: 2,222
Posted By TinCup
Re: Just a cool pic

Are those Kelsey Hayes wheels? 650X16's?
Looks nice on that coupe.
Forum: Model A (1928-31) 03-11-2018, 11:23 AM
Replies: 16
Views: 1,381
Posted By TinCup
Re: Has Anyone Seen A Breather Cap Like This Before?

I believe Henry tried 4 different oil filler tubes trying to solve the blow by out the oil filler tube. Looks like someone came up with number 5
Forum: Model A (1928-31) 03-07-2018, 11:57 AM
Replies: 35
Views: 2,958
Posted By TinCup
Re: Carburetor Float valves

I have a Viton tipped valve in my 31 and have had for over 6 years. I do not have the leaking issue some have reported with them. The gaskets as Jim has suggested can also be the cause. Oh and by the...
Forum: Model A (1928-31) 03-06-2018, 01:21 PM
Replies: 16
Views: 1,337
Posted By TinCup
Re: The Zenith Carburetor

Don't forget this great write up and animations on the Zenith carb.
Zenith Carb Basics (http://www.modelabasics.com/carb%20basics%202.htm)
Forum: Model A (1928-31) 03-05-2018, 11:36 AM
Replies: 45
Views: 3,839
Posted By TinCup
Re: 1929 Mail Truck Find.

Some guys have all the luck!
Forum: Model A (1928-31) 03-02-2018, 10:19 AM
Replies: 16
Views: 976
Posted By TinCup
Re: Oil on radiator??

If someone has over greased the rear water pump zerk the oil from the grease plus coolant can cause this. I have seen so many radiators that are full of grease from this. The rear pump zerk should...
Forum: Model A (1928-31) 02-21-2018, 04:44 PM
Replies: 30
Views: 2,390
Posted By TinCup
Re: Leaking Zenith Carburetor

Try repeating the test and leave the gas cap off.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 08:46 AM.