Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: 6volt
Forum: Model T (1909-1927) 11-10-2020, 10:23 PM
Replies: 9
Views: 2,370
Posted By 6volt
Re: Timing Light

Try going to Tractor Supply. Get an electric fence tester. It's even got 5 lights to measure the amount of "HOT" getting to each plug....
Forum: Model A (1928-31) 06-10-2016, 08:44 PM
Replies: 16
Views: 3,684
Posted By 6volt
Re: Hand throttle rod linkage

That's the info I'm looking for! Thanks.
Forum: Model A (1928-31) 06-10-2016, 06:19 PM
Replies: 16
Views: 3,684
Posted By 6volt
Re: Hand throttle rod linkage

Thanks Tom, but I am needing the Ford assigned name for the part, and availability of a new part.
Forum: Model A (1928-31) 06-10-2016, 05:07 PM
Replies: 16
Views: 3,684
Posted By 6volt
Re: Hand throttle rod linkage

This connector (circled in photo) is mounted on a vertical shaft and is held in place by a pin. Does anyone know the correct Ford name for the part and are they available to purchase from any of the...
Forum: Model A (1928-31) 05-27-2016, 07:20 PM
Replies: 16
Views: 3,684
Posted By 6volt
Re: Hand throttle rod linkage

Thanks for the help!
After looking at the spark & gas levers I agree that the column is rotated too far counter-clockwise, if viewing from the drivers seat. When I figure what to loosen, I'll rotate...
Forum: Model A (1928-31) 05-27-2016, 03:06 PM
Replies: 16
Views: 3,684
Posted By 6volt
Re: Hand throttle rod linkage

5lugnuts- you wrote "I notice the linkage that bolts to the back of your engine may be different than my 31 or maybe it is just the angle of the photo, not sure."

Can you explain the difference?...
Forum: Model A (1928-31) 05-27-2016, 01:38 PM
Replies: 16
Views: 3,684
Posted By 6volt
Hand throttle rod linkage

This '30 Model A Town Car had a broken hand throttle rod at an old weld when purchased. I re-welded it. It was broken because the throttle rod contacts the starter control rod. There are wear marks...
Showing results 1 to 7 of 7

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:46 AM.