Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: Phil Gillespie
Forum: Early V8 (1932-53) 06-20-2019, 11:01 AM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

So just checking again and it would appear the inner axle seals which sit in behind the bearings are not fitted? The bearing is located in a recess at bell but the inner seal when fitted is located...
Forum: Early V8 (1932-53) 06-19-2019, 07:08 PM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

Will be using same tube so that should be ok.
These items are good to know about prior to refitting.
Axle carrier berarings look good so will reuse.
Phil NZ
Forum: Early V8 (1932-53) 06-19-2019, 03:01 AM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

To remove the inner axle taper bearing for refitting to replacement axle is this a simple task. Or any special tricks? Have the existing broken shaft assembly out for axle replacement LH side broken,...
Forum: Early V8 (1932-53) 06-18-2019, 04:25 AM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

Yes it certainly makes very good sense for sure.
Will follow this advice.
This recent failure happened just north of Westport.
Lucky to have the AA+ for AA Service which took care of transport...
Forum: Early V8 (1932-53) 06-18-2019, 02:45 AM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

Whats the reason for this then. I'm keen to know.
Phil NZ
Forum: Early V8 (1932-53) 06-17-2019, 03:29 PM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

Appreciate all advice and assistance given. Could try with the porta- power to take load at LHS for spring shackle removal and leave RHS in place.
Will check axle before refitting provided it...
Forum: Early V8 (1932-53) 06-17-2019, 03:25 PM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
Re: 39 Coupe Broken Axle Removal.

The torque was tight at very close at 200ft/lbs. Was very careful with this.
But again what about previous 60 plus years.
Phil NZ
Forum: Early V8 (1932-53) 06-17-2019, 05:37 AM
Replies: 22
Views: 4,581
Posted By Phil Gillespie
39 Coupe Broken Axle Removal.

So today removed LH rear hub together with broken axle piece. Had broken just at the back area where keyway lies.
Want to do it in place without removing complete diff unit.
To release the spring...
Showing results 1 to 8 of 8

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:01 AM.