Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 99
Search took 0.01 seconds.
Search: Posts Made By: 1930deluxe
Forum: Model A (1928-31) 09-15-2019, 07:38 AM
Replies: 5
Views: 358
Posted By 1930deluxe
Re: Speedometer

Thanks to all of you for you advise. This is very helpful.
Forum: Model A (1928-31) 09-15-2019, 07:33 AM
Replies: 4
Views: 397
Posted By 1930deluxe
Re: Anti-Rattle Spring

Thanks all of you for your advise.
Forum: Model A (1928-31) 09-12-2019, 08:12 AM
Replies: 5
Views: 358
Posted By 1930deluxe
Speedometer

The speedometer on my 1931 tudor sedan is not working. I took the cable lose from the drive shaft. I can not turn the inner drive cable. It moves in and out but won't turn. Do I need to replace...
Forum: Model A (1928-31) 09-11-2019, 07:56 PM
Replies: 4
Views: 397
Posted By 1930deluxe
Anti-Rattle Spring

I am installing the anti-rattle springs and since they were missing I am not sure I have them on right See photos
Forum: Model A (1928-31) 08-25-2019, 02:39 PM
Replies: 14
Views: 808
Posted By 1930deluxe
Lug nuts

Did I read the lug nut should be 77 foot pounds?
Forum: Model A (1928-31) 08-25-2019, 01:53 PM
Replies: 6
Views: 353
Posted By 1930deluxe
1930 Tudor Sedan

I have tightened the adjustment on the steering box. The car shimmies terrible at 20 mph. Very little shimmy at highway speed. Do I need to have the steering box rebuilt?
Forum: Model A (1928-31) 08-25-2019, 01:49 PM
Replies: 4
Views: 321
Posted By 1930deluxe
Water Level

The car holds three gallon of water. How much should I put in so it stops sending it out the overflow?
Forum: Model A (1928-31) 07-29-2019, 04:49 PM
Replies: 4
Views: 328
Posted By 1930deluxe
Coolant Filter

What does the coolant filter go and what does it look like?
Forum: Model A (1928-31) 06-13-2019, 11:09 PM
Replies: 4
Views: 426
Posted By 1930deluxe
Re: Rear Fender Welt

Thanks to everyone that responded to my questions. What a great group with the same interest as mine.
Forum: Model A (1928-31) 06-13-2019, 07:15 AM
Replies: 4
Views: 426
Posted By 1930deluxe
Rear Fender Welt

I am ready to install the rear fenders on my 1930 tudor sedan. I have never installed a welt before. What is the best way to install the welt? How far does the welt go down the rear of the fender?...
Forum: Model A (1928-31) 06-03-2019, 07:05 PM
Replies: 12
Views: 1,299
Posted By 1930deluxe
Re: Motor Rebuilding

I would like to thank everyone for your reply it is very helpful.
Forum: Model A (1928-31) 06-02-2019, 09:37 PM
Replies: 12
Views: 1,299
Posted By 1930deluxe
Motor Rebuilding

Where is a good place to have a motor rebuilt? How much does it cost?
Forum: Model A (1928-31) 06-02-2019, 08:40 AM
Replies: 2
Views: 394
Posted By 1930deluxe
Re: Front Fender

Thank you for your reply jw
Forum: Model A (1928-31) 06-01-2019, 08:03 PM
Replies: 2
Views: 394
Posted By 1930deluxe
Front Fender

Does the front fender go under the lower radiator mounting bracket or on top and where does the rubber pad go above or below the fender? The volume 1 repair manual is not clear.
Forum: Model A (1928-31) 05-18-2019, 09:30 PM
Replies: 5
Views: 503
Posted By 1930deluxe
Re: Body to Hood Alignment

Crank lines up with the motor. The rear hood bracket is not in place but I do not believe it will close the gap that much unless it is shimmed a lot.
Forum: Model A (1928-31) 05-18-2019, 09:27 PM
Replies: 2
Views: 373
Posted By 1930deluxe
Rear Wheels

When up on blocks with car running and in gear should both wheels turn at the same time or is just one the drive wheel?
Forum: Model A (1928-31) 05-18-2019, 06:24 PM
Replies: 5
Views: 503
Posted By 1930deluxe
Body to Hood Alignment

I have installed new wood blocks with shims. The door alignment on both sides are very good but the hood is way off. Is the frame sagging or does the front body need more shims to correct the hood...
Forum: Model A (1928-31) 04-26-2019, 09:32 AM
Replies: 8
Views: 769
Posted By 1930deluxe
Re: Cleaning Cooling System

The radiator and head has been cleaned when I had it apart. Sounds like the Rust 911 would be a better way to go since it dissolves the rust?
Forum: Model A (1928-31) 04-25-2019, 08:49 AM
Replies: 8
Views: 769
Posted By 1930deluxe
Cleaning Cooling System

How much white vinegar do you add to the cooling system to clean it out? How long should a person leave it in before flushing the system?
Forum: Model A (1928-31) 04-17-2019, 11:02 AM
Replies: 9
Views: 834
Posted By 1930deluxe
Re: Water pump Update

Katy was right the new bushing was too large to be installed in the housing. The housing measurement is 1.016 and the bushing measured 1.021. Five thousandth puts too much force on the housing...
Forum: Model A (1928-31) 04-14-2019, 09:11 PM
Replies: 9
Views: 834
Posted By 1930deluxe
Water pump Update

What may have caused this pump to crack? See Photo


https://imgur.com/tjfllV4
Forum: Model A (1928-31) 04-12-2019, 07:37 PM
Replies: 6
Views: 550
Posted By 1930deluxe
Re: Water pump

Engine has not been running yet
Forum: Model A (1928-31) 04-12-2019, 07:34 PM
Replies: 6
Views: 550
Posted By 1930deluxe
Re: Water pump

The best I can find out is there were several companies manufacturing the water pumps for Ford and the tolerances were not the same. The crack is at the rear bearing housing and goes to the upper...
Forum: Model A (1928-31) 04-10-2019, 06:05 PM
Replies: 6
Views: 550
Posted By 1930deluxe
Water pump

What is the biggest cause for water pumps to crack?

https://imgur.com/tjfllV4
Forum: Model A (1928-31) 12-26-2018, 12:54 PM
Replies: 5
Views: 795
Posted By 1930deluxe
Re: Firewall

Thank you, I was thinking it may be a clamp but I was not sure.
Showing results 1 to 25 of 99

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:41 AM.