Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 64
Search took 0.01 seconds.
Search: Posts Made By: GMCPASO
Forum: Model A (1928-31) 02-20-2024, 12:00 PM
Replies: 25
Views: 1,730
Posted By GMCPASO
Re: Fantastic picyure

Interesting helmet that we used back then.
Forum: Model A (1928-31) 02-17-2024, 12:33 PM
Replies: 62
Views: 6,027
Posted By GMCPASO
Re: Skills Necessary To Own & Operate A Model "A"

Another way to learn and develop the skill set, which I learned in College as a lab instructor, was to become a teacher of others that have the desire to learn.
Forum: Model A (1928-31) 02-15-2024, 12:16 AM
Replies: 62
Views: 6,027
Posted By GMCPASO
Re: Skills Necessary To Own & Operate A Model "A"

GoJoMoJo

That is all that is needed, then just keep on keepen on. Of course, rely on The red Manual # 1.
Forum: Model A (1928-31) 07-11-2022, 10:23 AM
Replies: 51
Views: 11,554
Posted By GMCPASO
Smile Re: toe in tool

Agree with that observation. We have one in our club purchased by a member.

It is stored at my house and has been used 4 times now and all are amazed at how well their cars now drive/steer.
...
Forum: Model A (1928-31) 01-21-2020, 07:37 PM
Replies: 59
Views: 38,209
Posted By GMCPASO
Re: Marvel Carburetor Disection

I have found this idle jet is threaded into the lower body with a 10-32 thread. It is a thick walled tube so you can get a firm hold on it and it will come out. Don't know how they set the height...
Forum: Model A (1928-31) 01-17-2020, 10:44 PM
Replies: 15
Views: 1,918
Posted By GMCPASO
Re: Head light focusing procedure

It helps if it is a foggy night also.
Forum: Model A (1928-31) 07-03-2019, 02:42 PM
Replies: 61
Views: 27,135
Posted By GMCPASO
Re: Who's running a Marvel/Schebler carb?

Yes, I found leather washers in the GAV. I replaced them with same and no issues here.
Forum: Model A (1928-31) 12-10-2018, 04:31 PM
Replies: 61
Views: 27,135
Posted By GMCPASO
Re: Who's running a Marvel/Schebler carb?

Got back from 4670 mile trip.
Trip resulted in 21.4 mpg. Stopped once due to fuel filter, glass bowl and filter, plugged with junk from tank. Was headed home in Wy. Changed filter and back on...
Forum: Model A (1928-31) 10-01-2018, 09:13 AM
Replies: 61
Views: 27,135
Posted By GMCPASO
Re: Who's running a Marvel/Schebler carb?

Yes, I have noticed some gas around the carburetor after shutting down. I have started to shut off valve off before getting into the garage and letting it run a short time to lower the fuel in the...
Forum: Model A (1928-31) 09-30-2018, 07:20 PM
Replies: 61
Views: 27,135
Posted By GMCPASO
Re: Who's running a Marvel/Schebler carb?

The only problem I have with mine it it stops when it doesn't get gas, fuel filter blocked it. I run an air filter on mine with a balanced system.
Forum: Model A (1928-31) 09-29-2018, 12:38 PM
Replies: 61
Views: 27,135
Posted By GMCPASO
Re: Who's running a Marvel/Schebler carb?

Ok, I am back from a 4673 mile trip to South Dakota and return with the Model A Touring Club. Drove the car from home in Central Coast of California, through Nevada, Arizona, Utah, Wyoming, and...
Forum: Model A (1928-31) 05-25-2018, 10:26 AM
Replies: 12
Views: 2,622
Posted By GMCPASO
Re: Vintage pic I came across...

I believe it is a Sport Coupe.
Forum: Model A (1928-31) 05-09-2018, 03:57 PM
Replies: 5
Views: 1,367
Posted By GMCPASO
Re: A/B manifold question

I agree with all above. Bored out A manifold with Zenith A and B, Tillotson and running a Marvel. All worked well and like the Marvel right now, one with accelerator pump and one with out. All work...
Forum: Model A (1928-31) 05-08-2018, 11:26 PM
Replies: 45
Views: 8,753
Posted By GMCPASO
Re: Running Single Plate in California

California reads, "you run with the plates or plate you are issued. Motorcycles have one plate, cars and trucks get two. If it is enforced is another question. It is not a law till it is enforced...
Forum: Model A (1928-31) 05-08-2018, 11:23 PM
Replies: 23
Views: 6,929
Posted By GMCPASO
Re: Would leaving the ignition on cause damage to the coil?

If you have an original pop-out it could burn it out also, Could.
Forum: Model A (1928-31) 05-06-2018, 12:38 PM
Replies: 14
Views: 2,748
Posted By GMCPASO
Re: Phenolic spacer

Are you using engine pans to direct the air from radiator along side of the engine and over the carburetor?
Forum: Model A (1928-31) 04-23-2018, 08:03 AM
Replies: 76
Views: 13,646
Posted By GMCPASO
Re: 1929 Tudor 'Barner' count....

Here is another. May 5, 1929. Original purchase into South Dakota from assy plant in Twin Cities plant, then to Oregon then to California. We have had it for 38 years and have put 57000 miles on...
Forum: Model A (1928-31) 04-17-2018, 03:34 PM
Replies: 32
Views: 7,864
Posted By GMCPASO
Re: Oil mist on left side of engine

SST scowling pads work well, that is what I use. No rust that way.
Forum: Model A (1928-31) 04-16-2018, 02:08 PM
Replies: 32
Views: 7,864
Posted By GMCPASO
Re: Oil mist on left side of engine

# 7 works very well with weak rings and blow-by.
Forum: Model A (1928-31) 04-16-2018, 02:05 PM
Replies: 12
Views: 3,180
Posted By GMCPASO
Re: Are these Model T or Model A Subrails?

Does not look like any A frame rail that I have ever seen. I have a tudor and this is not it.:confused:
Forum: Model A (1928-31) 04-01-2018, 10:09 AM
Replies: 16
Views: 3,147
Posted By GMCPASO
Re: Steering

I have an F-100 done by Mel Gross, Randy's dad, many years ago and it is great. Have had no problems once I got the front end set up correctly. Also use Dyna beads in my tires and on first long...
Forum: Model A (1928-31) 03-20-2018, 08:45 PM
Replies: 23
Views: 5,727
Posted By GMCPASO
Re: Newer engine internals

I had a crankshaft that was verrry bad. When overhauling the engine, first time in its life, the crank was checked. It was found that the factory must have had a trainee on this one. The balance...
Forum: Model A (1928-31) 03-19-2018, 03:29 PM
Replies: 14
Views: 2,609
Posted By GMCPASO
Re: Timing marks don't line up

The cam shaft turns once to the cranks 2 turns so they will only line up once per cam rev. Think about it.
Forum: Model A (1928-31) 03-16-2018, 01:31 PM
Replies: 10
Views: 2,560
Posted By GMCPASO
Re: Timing light

I have no issues with my 12v timing light. It still fires when number one fires. Just make sure you hook up the battery (power leads) correctly on the standard 6v system. No issues on mine.
Forum: Model A (1928-31) 03-16-2018, 01:28 PM
Replies: 11
Views: 2,882
Posted By GMCPASO
Re: Points/Plugs mileage

If using modern points, you can get platinum or tungsten for longer life. Little more expensive but good.
Showing results 1 to 25 of 64

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:59 AM.