Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 125
Search took 0.01 seconds.
Search: Posts Made By: papanomad
Forum: Early V8 (1932-53) 10-14-2019, 11:17 AM
Replies: 7
Views: 363
Posted By papanomad
Re: Registration information....

I used Donna Leek 7 years ago and couldn't have been easier. sent her forms and check and 2 weeks later had registration and plates.
Forum: Early V8 (1932-53) 09-16-2019, 06:41 PM
Replies: 24
Views: 1,078
Posted By papanomad
Re: The "W" Block

"W" block is chevy 348 & 409.
Forum: Early V8 (1932-53) 08-22-2019, 08:56 PM
Replies: 8
Views: 428
Posted By papanomad
Re: Where to purchase King-brand main bearings & Best big bore engine gasket set?

the last bearings I bought from Vanpelt were king bearings.
Forum: Early V8 (1932-53) 07-27-2019, 09:15 AM
Replies: 18
Views: 792
Posted By papanomad
Re: F1 steering in a Model A

vern tardel sells the flange for the f1 box. verntardel.com
Forum: Early V8 (1932-53) 07-09-2019, 09:38 PM
Replies: 17
Views: 699
Posted By papanomad
Re: 1937-40 Ford Flathead V-8 60 Horsepower Parts

give it some time. also pictures will help sell faster.
Forum: Early V8 (1932-53) 06-12-2019, 04:39 PM
Replies: 70
Views: 6,160
Posted By papanomad
Re: The Bubba plan for now ......???? Jim Linder

your health comes first, then distributors. take care.
Forum: Early V8 (1932-53) 04-29-2019, 10:22 PM
Replies: 22
Views: 2,001
Posted By papanomad
Re: Craigslist ?

after reading this thread I went on cl and sure enough, car parts section is full of cars.
Forum: Early V8 (1932-53) 04-24-2019, 02:01 PM
Replies: 9
Views: 504
Posted By papanomad
Re: 48 Coupe Acelerator Return Spring

you can't go wrong with 35fordtn for parts and service.
Forum: Model-T 03-26-2019, 08:23 PM
Replies: 0
Views: 352
Posted By papanomad
1926-1927 coupe trunk support

looking for trunk support bracket for 1926 - 1927 coupe.
Forum: Early V8 (1932-53) 02-14-2019, 08:07 PM
Replies: 22
Views: 1,600
Posted By papanomad
Re: Lower rad hoses

I used gates 20151. amazon has them.
Forum: Early V8 (1932-53) 02-09-2019, 03:15 PM
Replies: 9
Views: 659
Posted By papanomad
Re: How do I mount a 21 stud with a 36 Trans into a model A coupe

contact member rarebike from Omaha. he had advertised 32 k members for model A's.
Forum: Early V8 (1932-53) 02-06-2019, 09:26 PM
Replies: 24
Views: 1,518
Posted By papanomad
Re: 8BA Timing Gears, Any brand better than the others?

try Fred at southside obsolete for nos gear.
Forum: Early V8 (1932-53) 01-20-2019, 09:34 PM
Replies: 36
Views: 2,966
Posted By papanomad
Re: Old cars

had to be a millennial.
Forum: Early V8 (1932-53) 12-10-2018, 04:20 PM
Replies: 19
Views: 1,577
Posted By papanomad
Forum: Early V8 (1932-53) 11-26-2018, 09:53 PM
Replies: 3
Views: 371
Posted By papanomad
Re: Spindle Year Identification

1942-1948 left side.
Forum: Early V8 (1932-53) 11-15-2018, 04:27 PM
Replies: 19
Views: 1,666
Posted By papanomad
Re: Do I go with this fella?

if it sounds too good to be true it probably is. don't walk away-RUN
Forum: Early V8 (1932-53) 11-12-2018, 04:14 PM
Replies: 17
Views: 1,138
Posted By papanomad
Re: New pistons, what brand?

egge from van pelt, and they have .080.
Forum: Early V8 (1932-53) 10-21-2018, 12:58 PM
Replies: 22
Views: 2,354
Posted By papanomad
Re: need to sell

ebay is a good place to advertise but put high reserve. gets a lot of exposure in areas you couldn't get anywhere else. I have sold cars listed on ebay but always after auction closed.
Forum: Early V8 (1932-53) 10-17-2018, 09:29 AM
Replies: 44
Views: 3,099
Posted By papanomad
Re: Revisiting head stud removal. Ugh!!!!!!

just finished 2nd block in last year and did not break any studs. I used acetylene torch to heat studs and bees wax. if stud did not move just repeat procedure until stud moves. may take 4-5 tries...
Forum: Early V8 (1932-53) 10-03-2018, 08:08 PM
Replies: 19
Views: 1,298
Posted By papanomad
Re: Cleaning a block- Hot tanked in acid?

4-5 days in acid sounds scary! bake is the way to go. I doubt if acid will have any affect on grease.
Forum: Early V8 (1932-53) 10-01-2018, 03:16 PM
Replies: 17
Views: 1,779
Posted By papanomad
Re: Banjo steering wheels

if you cut the horn button rod off how do you keep the horn button on steering wheel?
Forum: Early V8 (1932-53) 09-27-2018, 09:13 PM
Replies: 15
Views: 888
Posted By papanomad
Re: Head Temperature Boss Crack

I had same crack on a 59ab head and used high heat jb weld to repair. grind a v in crack and fill with jb weld. that was 3 years ago and still holding.
Forum: Early V8 (1932-53) 09-17-2018, 08:41 AM
Replies: 4
Views: 410
Posted By papanomad
Forum: Early V8 (1932-53) 09-05-2018, 09:23 PM
Replies: 60
Views: 4,725
Posted By papanomad
Re: Gas 10% ethanol

I did this check 2 years ago driving I-80 from sacramento to chicago and found 2 mpg increase in honda pilot with ethanol free gas.
Forum: Early V8 (1932-53) 08-31-2018, 06:42 PM
Replies: 60
Views: 4,725
Posted By papanomad
Re: Gas 10% ethanol

if I want something that runs on corn, i'll get a horse!!
Showing results 1 to 25 of 125

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:22 AM.