Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: trubble
Forum: Model A (1928-31) 08-10-2020, 09:54 PM
Replies: 22
Views: 2,939
Posted By trubble
Re: Not enough power??

Good point all. Those danged old inventions need attention in all areas.
Forum: Model A (1928-31) 05-17-2020, 01:24 PM
Replies: 6
Views: 1,158
Posted By trubble
Re: No fire at the points

I have the same issue. My quick fix is split a straw or tube and slip it over the cable wire. This stopped the short for now but I'll need the new cable.
Question is "which cable?". I'm seeing...
Forum: Model A (1928-31) 09-25-2015, 08:20 AM
Replies: 46
Views: 12,423
Posted By trubble
Re: Non fitting / defective aftermarket parts

Wondering why one or both of the national organizations doesn't have a committee to review of rate reproduced parts.
Forum: Model A (1928-31) 09-24-2015, 06:37 PM
Replies: 6
Views: 1,144
Posted By trubble
Re: I feel good all over

I've done similar. It is very gratifying.
Forum: Model A (1928-31) 05-24-2013, 07:48 AM
Replies: 8
Views: 1,438
Posted By trubble
Re: non release pressure plate 1930 coupe

Thanks Fellows for your thoughts and advice.
I can't see any chunks or is anything bouncing around in the bell area.
I am resigning myself to the fact I will be removing the trans and replacing the...
Forum: Model A (1928-31) 05-23-2013, 08:05 PM
Replies: 8
Views: 1,438
Posted By trubble
Re: non release pressure plate 1930 coupe

I checked the bearing and it will spin. When I press the peddle the throw out bearing will move all the way in. But the problem remains, the pressure plat fingers are not returning to the in gauged ...
Forum: Model A (1928-31) 05-23-2013, 06:23 PM
Replies: 8
Views: 1,438
Posted By trubble
Re: non release pressure plate 1930 coupe

Yes .The fingers are remaining in. The rest if the parts are doing their part.
When I adjusted the linkage I think I went most of the way on the rod.
Thanks Flamingo.
Forum: Model A (1928-31) 05-23-2013, 05:30 PM
Replies: 8
Views: 1,438
Posted By trubble
non release pressure plate 1930 coupe

I have been slowly getting this car drivable sense last July. The motor has been starting and running ok. I have driven it only a few miles. Under ten anyway,
So the other day on a test run I...
Showing results 1 to 8 of 8

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:19 PM.