Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 147
Search took 0.01 seconds.
Search: Posts Made By: joltesvig
Forum: Model A (1928-31) 03-23-2020, 01:22 PM
Replies: 6
Views: 1,929
Posted By joltesvig
Re: Ammeter needle movements

PS: In any event, my 31 Coupe won’t start but is getting fuel to the carb.
Forum: Model A (1928-31) 03-23-2020, 01:19 PM
Replies: 6
Views: 1,929
Posted By joltesvig
Ammeter needle movements

Should the ammeter needle move slightly negative when I turn the ignition switch on indicating the ignition switch is making contact?
When cranking the engine should the ammeter needle make a large...
Forum: Model A (1928-31) 07-10-2018, 04:47 PM
Replies: 5
Views: 1,405
Posted By joltesvig
Re: Starter Switch Test

Thanks Big Hammer and thanks Mike! I have a Brattons catalogue...I’ll check it out!
Forum: Model A (1928-31) 07-10-2018, 08:26 AM
Replies: 5
Views: 1,405
Posted By joltesvig
Starter Switch Test

The starter key switch has armor all the way into the bottom of the distributor. I already replaced the spark coil with a new one. Still have no spark so I think the starter key switch has gone bad....
Forum: Model A (1928-31) 06-06-2018, 05:39 PM
Replies: 12
Views: 2,262
Posted By joltesvig
Re: Checking for Spark Solo

THANKS, VERY HELPFUL! I’ll try this tomorrow!
Forum: Model A (1928-31) 06-06-2018, 03:26 PM
Replies: 12
Views: 2,262
Posted By joltesvig
Checking for Spark Solo

My Model A cranks but won’t start. Getting lots of fuel to the carb. I’m all alone and I need to see if I’m getting a spark to the plugs. Is there a way to do this solo?
Forum: Model A (1928-31) 07-06-2017, 03:45 PM
Replies: 3
Views: 947
Posted By joltesvig
Re: Runs rough

Thanks RAWHIDEKID...I did what you suggested...apparently the engine gets starved for fuel sometimes! Problem fixed! THANKS!
Forum: Model A (1928-31) 07-06-2017, 12:24 PM
Replies: 3
Views: 947
Posted By joltesvig
Question Runs rough

Spark plugs good, fuel is fresh, points good, starts and idles good, manifold vacuum is sealed but it runs rough on the road. When I accelerate, it misses and stumbles like it wants to die so I end...
Forum: Model A (1928-31) 07-06-2017, 10:27 AM
Replies: 2
Views: 1,202
Posted By joltesvig
Engine misses, stumbles

Standard 4 banger engine in my 31 coupe. The plugs look good and so do the points. When it warms up a little it starts missing /stumbling when I step on it a little. The manifold vacuum tube is not...
Forum: Model A (1928-31) 06-16-2016, 07:35 PM
Replies: 4
Views: 1,695
Posted By joltesvig
6 v pos grand alternator

This Delco modification never generated a charge and so the battery kept running down. I don't remember who I bought it from (before cancer 4 years ago). Anybody know who can debug this or do I have...
Forum: Model A (1928-31) 11-14-2014, 03:15 PM
Replies: 4
Views: 1,937
Posted By joltesvig
600R16 vs. bias ply tires

My 31 Coupe has the 16 inch wheels and I'm considering buying new tires for it.
Can anyone tell me if replacing the old bias ply tires with radial tires will improve the ride?
A set of radials...
Forum: Model A (1928-31) 11-14-2014, 03:08 PM
Replies: 40
Views: 6,888
Posted By joltesvig
Re: Black walls or white walls ?

Thanks everyone, extremely helpful to help make a decision!
Forum: Model A (1928-31) 11-14-2014, 10:15 AM
Replies: 40
Views: 6,888
Posted By joltesvig
Black walls or white walls ?

I am so tired of the 6 white walls on my 31 coupe because they are yellowing. I have tried everything to make them look nice and white but maybe they are just yellow with age? Anyone else have this...
Forum: Model A (1928-31) 11-07-2014, 10:25 AM
Replies: 15
Views: 4,285
Posted By joltesvig
Re: Oil Filler Tube

You guys are a wealth of information !!! I'm ordering the oil breather tube as a short term fix to direct the oily fumes down into the slip stream under the chassis. Ordering from page 45 of...
Forum: Model A (1928-31) 11-06-2014, 01:09 PM
Replies: 15
Views: 4,285
Posted By joltesvig
Re: Oil Filler Tube

So it may be blow-by exhaust getting around the piston rings? Is compression difficult to check? What do I need? Or can most auto garages check the compression or do they need special tools to...
Forum: Model A (1928-31) 11-06-2014, 12:15 PM
Replies: 15
Views: 4,285
Posted By joltesvig
Oil Filler Tube

My oil filler tube has baffles in it.
I take it those are to keep oil from splashing up and out of the breather cap.
I notice that a LOT of smoky oil fumes normally come out of the breather.
...
Forum: Model A (1928-31) 09-24-2014, 01:02 PM
Replies: 1
Views: 1,211
Posted By joltesvig
Adjusting 39 Ford hydraulic brakes

My 31 Coupe has 39 Ford hydraulic brakes on it. My pedal travel is excessive (only 2 inches of travel left to floorboard) so I'm finally going to have to learn how to adjust them. Anyone know of...
Forum: Model A (1928-31) 08-16-2014, 11:20 AM
Replies: 99
Views: 23,860
Posted By joltesvig
Re: What's the future of the Model T and Model A hobbies?

I'm 66. The reason I own a 31 Coupe is that my father-in-law restored it, a 31 pick-up, a 31 Sedan and a 30 roadster. When he died, we got the roadster. I love the car but my wife takes no...
Forum: Model A (1928-31) 07-31-2014, 03:24 PM
Replies: 17
Views: 7,465
Posted By joltesvig
Re: Radiator overflow water loss

Thanks Bill Williamson, Guru of Stuff! I have watched your posts for a couple of years and you haven't steered me wrong yet! My 31 Coupe has been using a lot of water for the pst few years and...
Forum: Model A (1928-31) 07-31-2014, 02:53 PM
Replies: 10
Views: 1,638
Posted By joltesvig
Re: is the GAV needle the same on A and B carbs?

Excuse my ignorance as I am still a fledgling Model A driver...what does GAV stand for if anything?
Forum: Model A (1928-31) 07-25-2014, 10:35 AM
Replies: 6
Views: 1,936
Posted By joltesvig
Brake adjustment of 31 Coupe with 39 Ford hydraulic brakes?

Where can I find out how to adjust the brakes on my Model A equipped with 39 Ford hydraulic brakes. My brake pedal has way too much free travel now that the brake linings have broken in from a...
Forum: Model A (1928-31) 05-28-2014, 10:16 AM
Replies: 41
Views: 11,384
Posted By joltesvig
Re: aluminum fan

My steel fan blew up a couple years ago. The blade which came apart made a small out-ding in my hood. I was lucky! Now I have an original looking aluminium fan which you can buy from most parts...
Forum: Model A (1928-31) 05-28-2014, 10:10 AM
Replies: 35
Views: 7,540
Posted By joltesvig
Re: Driving at night

Wow, excellent ideas which I will use next time at night joy riding. My coupe will not sustain 55 mph so I will not drive it at night on the expressway. Thanks to all!
Forum: Model A (1928-31) 05-28-2014, 10:02 AM
Replies: 3
Views: 1,811
Posted By joltesvig
Re: Double Clutch video

Excellent video with instructions! I'll practice to gain more confidence with my double clutching this afternoon!
Forum: Model A (1928-31) 08-26-2013, 12:05 PM
Replies: 37
Views: 8,259
Posted By joltesvig
Re: floor board heat

I live in North Carolina where it gets pretty hot sometimes and even hotter when cruising in my 31 Cuope. I always considered it part of "the Model A experience". I have a friend who lives in the...
Showing results 1 to 25 of 147

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 03:31 PM.