Forum: Early V8 (1932-53)
06-17-2019, 07:31 AM
|
Replies: 2
Views: 1,314
Re: 1935 Rumble Seat Removal
Got it, thanks.
Wish I had known this Saturday before I pulled the brand new gas tank, pump, and sending unit out. Finally figured the puzzle out yesterday and got the tank out and noticed the trap...
|
Forum: Early V8 (1932-53)
06-17-2019, 05:30 AM
|
Replies: 2
Views: 1,314
1935 Rumble Seat Removal
Can someone guide me as how to best remove the rumble seat from a 35 ford coupe? I need access to the top of the gas tank. I'm sure all I need is to remove the seat cushions but not sure slide back,...
|
Forum: Early V8 (1932-53)
06-12-2019, 02:08 PM
|
Replies: 12
Views: 1,557
Re: '35 Ford Coupe Rear Fenders
As a matter of fact that is the exact set up and manufacture. Great folks there. Funny you mention a bottle. I have a plastic prescription bottle that I have considered using. Dill a center hole in...
|
Forum: Early V8 (1932-53)
06-12-2019, 12:34 PM
|
Replies: 12
Views: 1,557
Re: '35 Ford Coupe Rear Fenders
Yes but that puts the vent in "harms way" if the car is driven in the rain... which is not usually the case but possible. Just concerned about debris and moisture entering the tank. There is a spot...
|
Forum: Early V8 (1932-53)
06-12-2019, 10:51 AM
|
Replies: 12
Views: 1,557
Re: '35 Ford Coupe Rear Fenders
Let me clarify. Not the tail lamp housing itself but inside the lower part of the mount for the tail lamp. Its just above the fender - separated by a rubbers sheet from the inside of the fender, but...
|
Forum: Early V8 (1932-53)
06-12-2019, 07:34 AM
|
Replies: 12
Views: 1,557
Re: '35 Ford Coupe Rear Fenders
Thanks for the help. I think I found a way to put the vent within the housing for the tail light. The fender has a pretty steep angle at that point but will try to fab an angled bracket.
|
Forum: Questions & Suggestions
06-11-2019, 07:34 AM
|
Replies: 1
Views: 1,879
|
Forum: Early V8 (1932-53)
06-11-2019, 07:22 AM
|
Replies: 12
Views: 1,557
'35 Ford Coupe Rear Fenders
Posted this over in the questions section without a reply so I'll try here.
Got my dads '35 ford in the garage and due to Mr Ethanol, I have had to replace fuel tank, pump, filters, and rework...
|
Forum: Questions & Suggestions
06-10-2019, 11:58 AM
|
Replies: 1
Views: 1,879
'35 Ford Coupe Rear Fenders
Got my dads '35 ford in the garage and due to Mr Ethanol, I have had to replace fuel tank, pump, filters, and rework some rotten lines. This is an all steel, original shaped (no chop), street rod...
|