Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 102
Search took 0.01 seconds.
Search: Posts Made By: transbytip
Forum: Early V8 (1932-53) 09-01-2019, 12:23 AM
Replies: 11
Views: 351
Posted By transbytip
Re: How to remove distributor caps 1936

I have found that taking the coil out with a long screw driver go thru coil hole&gently tap the innercaps out works for me Cliff.
Forum: Early V8 (1932-53) 08-07-2019, 05:18 PM
Replies: 4
Views: 315
Posted By transbytip
Re: Newer Overdrive in a 50 Ford?

SENT YOU A p.m.the 59 will be 12 volts sol. wont work.Cliff.
Forum: Early V8 (1932-53) 07-09-2019, 11:15 PM
Replies: 6
Views: 589
Posted By transbytip
Re: Borg-Warner Overdrive

Admiral,a big diff. is the nub for clutch linkage on side case is located lower on the 51 also the gears are cut diff.on51 also the 51 does not have the elect.rev.lockout sw.I have both O.D.trannys...
Forum: Early V8 (1932-53) 12-19-2018, 11:23 AM
Replies: 19
Views: 785
Posted By transbytip
Vacume source

A friend has a multi carb 8ba engine with 3 97 carbs wanted to know what to do for vac. running stock 8ba dist. any ideas for vac. thanks Cliff.
Forum: Early V8 (1932-53) 09-07-2018, 10:32 PM
Replies: 23
Views: 1,751
Posted By transbytip
Re: Front End Shake

I know it dont sound right but I had a car doing the same an oldtimer told me to check the rubber ball on end of wish bone it was bad replaced it no more shimmey might be something for you to check...
Forum: Early V8 (1932-53) 08-31-2018, 10:13 PM
Replies: 10
Views: 874
Posted By transbytip
Why oil leak from breather?

Wondering why am getting oil dripping from vent in front of pan dosent seem to have a lot of C.C.blow by? It is stock 36 engine that set for many years got it running good now except this oil leak...
Forum: Early V8 (1932-53) 08-11-2018, 10:06 PM
Replies: 15
Views: 824
Posted By transbytip
Re: Intake Manifold 35 Ford

I sent you a p.m.on the 35 or 36 manifold got no response still have it Cliff.
Forum: Early V8 (1932-53) 02-02-2018, 03:48 PM
Replies: 62
Views: 5,721
Posted By transbytip
Re: Block availability

What am I doing wrong?Have a complete 49 Merc 4 in stroke eng,advertised it for $850.00 no takers heads&pan off for insp, have at least a half dozen 8ba bare blocka&2 21 stud blocks plus a ton of...
Forum: Early V8 (1932-53) 02-02-2018, 03:33 PM
Replies: 17
Views: 1,073
Posted By transbytip
Re: Std bore 21 stud I've been stepping over 26 yrs

The dist. is a rare late 36 only Cliff,
Forum: Early V8 (1932-53) 01-31-2018, 12:45 PM
Replies: 9
Views: 667
Posted By transbytip
Re: 8BA questions

Hi I recently pulled 2 engines from 53 P.U,s both after teardown had valve seats on both in.&ex.they both were mounted from side bell housing &front mount like the Y blocks have all for sale.Cliff.
Forum: Early V8 (1932-53) 01-13-2018, 10:19 PM
Replies: 22
Views: 1,508
Posted By transbytip
Re: Nuts :)

Looks like you could use a needle point grease fitting to grease without taking the nut off, can get the fitting at Tractor supply Cliff.
Forum: Early V8 (1932-53) 12-02-2017, 06:17 PM
Replies: 1
Views: 365
Posted By transbytip
It worked for me

Guys,lets start& share a good idea thread.My first idea I came up with to help make a job easier is,I gave my daughter a Dodge Interepid,after many miles the water pump started leaking,guess who got...
Forum: Early V8 (1932-53) 12-02-2017, 05:55 PM
Replies: 4
Views: 417
Posted By transbytip
Re: Will it work?

40cpe yes you are correct output will be faster if input is the same.Cliff.
Forum: Early V8 (1932-53) 12-02-2017, 11:44 AM
Replies: 4
Views: 417
Posted By transbytip
Will it work?

Hi guys,have an idea to try will it work? I have had 13 o.d. trannys from the 49-59 Merc.&49 up fords incl the t85s sold quite a few have a few left have wondered if the o.d. works did the one test...
Forum: Early V8 (1932-53) 11-22-2017, 01:28 PM
Replies: 25
Views: 2,138
Posted By transbytip
Re: Electrical shutoff on 36 coupe

I like Koates have the good lever shut off on the floor just under the seat out of sight but still reachable on my 36 conv.sedan works great,Cliff.
Forum: Early V8 (1932-53) 09-18-2017, 06:10 PM
Replies: 15
Views: 1,345
Posted By transbytip
Re: 1936, Std vs Deluxe

the speedo trip odometer for deluxe has 4 nos.while the standard had 3
Forum: Early V8 (1932-53) 08-02-2017, 10:49 PM
Replies: 13
Views: 988
Posted By transbytip
Re: Sequence for tightening of fan belts 8BA

This is my red neck way of tighting the belts a bit cumbersom but it worked for me easier if you have hoist but not ness.get a couple step ladders put one on each side place a long 2by 6 on edge...
Forum: Early V8 07-16-2017, 10:36 PM
Replies: 0
Views: 212
Posted By transbytip
39Merc gauge cluster

have complete 39 Merc gauge cluster incl.working speedo.tipper 52501@yahoo.com Cliff.
Forum: Early V8 (1932-53) 07-16-2017, 10:19 PM
Replies: 11
Views: 830
Posted By transbytip
Re: 8BA.....When They Eliminated the Hardened Seats?

The 53 Ford P.U.had both In.&ex.seats I have 2 of them if inst.Cliff.
Forum: Early V8 (1932-53) 07-16-2017, 11:09 AM
Replies: 22
Views: 1,376
Posted By transbytip
Re: brake bleeder Q

I like my red neck way of bleeding old Ford brakes with m.c.under car raise car up on hoist tie strong rope to brake pedal clamp vise gripss on pedal so rope wont slide down pedal,now tie other end...
Forum: Late V8 07-11-2017, 05:49 PM
Replies: 0
Views: 283
Posted By transbytip
T85 trans 4 sale

Have a complete h.d. O.D.tranny incl/kick down sol.gov.&rear yoke looks great can e-mail pics Cliff. tipper52501@yahoo.com
Forum: Early V8 07-07-2017, 05:49 PM
Replies: 0
Views: 303
Posted By transbytip
49 Merc.engine&many F.H.pts.

Have a complete 49 Merc 4 in.engine carb to&incl pan W.P.to&incl.fly wheel& cl.&P.P. bellhousing available.From running local 49 Merc. with 39000 miles heads off for insp.it is free turning also have...
Forum: Early V8 (1932-53) 09-05-2016, 05:45 PM
Replies: 40
Views: 5,048
Posted By transbytip
Re: '36 3 Window Coupe

Things wrong in engine comp.Fuel pump no drain petcock, oil filler wrong,headers, no plug wire tubes, all easy to correct.Cliff.
Forum: Early V8 (1932-53) 06-04-2016, 07:44 PM
Replies: 8
Views: 714
Posted By transbytip
Re: 39/40 Rear end

Another big diff.is 39 still has the big bolt pattern where the 40 had the 5 by 5.5 pattern for the wheels Cliff.
Forum: Early V8 (1932-53) 05-19-2016, 09:21 PM
Replies: 3
Views: 818
Posted By transbytip
Re: lincoln zepher gears

Go to Vanpelt sales he has that info.
Showing results 1 to 25 of 102

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:45 AM.